GIANT ALARM SYSTEM JJ-RC-A Remote control User Manual instruction JJ JS 183
GIANT ALARM SYSTEM CO., LTD Remote control instruction JJ JS 183
Users Manual
INSTRUCTION OF SINGLE CHANNEL REMOTE CONTROL
SYSTEM
z VOLTAGE：12V/24V optional
z FREQUENCY：433.92MHZ±100K
z CHANNEL：1
z CHARACTERISTICS：
APPLICATION RANGE: gard agaist theft, gate opener, motor etc.
This system can memory about 100 remotes.
If the receiver is not in the state of learning new code, but it gets same code(and
same format) of the remote, learning LED will flash to indicate that the remote
can work with the receiver.
z WORKING INSTRUCTION：press the button, dry contact activates 2 minutes. In
the first 5 seconds, any other control signals will be invalid. After 5 seconds if
you press the button again, dry contact will disconnect. If there’s no operation in
the first 2 minutes, dry contact will open 2 minutes later.
LEARNING CODE：
Short press learning button on PCB, LED will flash and keep lighting, now you can
learn new code. If the code is learnt successfully, LED will turn off. If it doesn’t learn
new code in 5 seconds, LED will turn off and stop learning.
z REMOVE CODE:
Press learning button for 10 seconds, LED will flash 5 times and turn off. Then all
the existing codes will be removed.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
FCC ID: WSYJJ-RC-A
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.