GRAND HALL ENTERPRISE 09GH001 2.4GHz wireless outdoor speaker User Manual
GRAND HALL ENTERPRISE CO., LTD. 2.4GHz wireless outdoor speaker
User manual
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 1 -
2009.7
Aulong Technology Company Limited
Tel: (852) 31722560 Fax: (852) 31192417 E-mail: info@aulong-tech.com
1. Description
2. Product Overview
3. Operation
4. Accessories
5. Specification
6. Troubleshooting
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 2 -
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
- Consult the dealer or an experienced radio/TV technician for help
-
MODEL: 09GH001
Please read the below information carefully.
1. The maximum ambient temperature should not exceed 35 .℃
2. The 2.4G wireless speaker shall be installed according to specification.
The rating shall be not over the specified as following value.
Input: 230Vac, 50Hz, 50W
3. The 2.4G wireless speaker is used for Audio and Video equipment only.
4. For indoor use only.
5. Polarity of output plug: Center is anode.
6. This 2.4G wireless speaker is not intended to be repaired by service personal in case of failure or
component defect.
7. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquid
shall be placed on the apparatus.
8. The main plug of this adaptor is used as disconnect device, the disconnect device shall remain
readily operable.
9. This product must not be disposed together with the domestic waste. This product has to be
disposed at an authorized place for recycling of electrical and electronic appliances. By collecting and
recycling waste, you help save natural resources, and make sure the product is disposed in an
environmental friendly and healthy way.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 3 -
1. Description
Totum 2.4G Wireless Audio System (with LED Light Bar) can transmit the PC
Audio (USB port) or Analog Audio (MP3) to the Speakers through 2.4GHz ISM band in
a broadcasting mode.
Features:
- Plug and play USB 2.0 audio transmitter
- Compatible with Win98SE/WinME/Win2000/WinXP and MacOS 9.2.1/MacOS 10.2 without
additional driver
- Support direct line in playback via 3.5mm audio jack
- 2.4GHz GFSK transmission
- RF frequency hopping in 34 channels
- Broadcasting mode
- Long distance < 50m (Line of sight)
- Support no audio detection function
- Programmable delay time 20ms / 55ms
- Audio format 16bit , 48KHz sampling rate
- Power ON/OFF pop noise reduction
- Robust packet error correction
- Low power consumption
- No RF induced audio noise
- LED Light Bar (Flash according to the Audio signal)
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 4 -
Broadcasting mode:
In the broadcasting mode, one Transmitter Box can be connected to 50 Heaters.
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 5 -
2. Product Overview
a) Transmitter Box
Item Name Description
1 Battery RWR switch Battery Power Switch
2 USB port USB Port (support USB 2.0 high speed)
3 LED indicator a) always on: normal operation (audio is transmitting)
b) flash (1sec): no audio source
c) flash (0.25sec): ID Leaning operation
4 ID button When simultaneously press the ID button on Transmitter box and
the control Knob on the Heater longer than 5 seconds, the ID
learning process will be enabled
5 Line in jack Direct line in playback via 3.5mm audio jack
6 Battery compartment 4 x AA battery
1
2
3
4
5
6
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 6 -
b) Totum Heater (Receiver)
Item Name Description
1 L. Speaker Left Speaker
2 R. Speaker Right Speaker
3 L. LED Light Bar Left LED Light Bar
4 R. LED Light Bar Right LED Light Bar
5 Control Box Control board (with 2.4GHz Receiver Module)
6 Control Knob a) Push 0.5sec: turn on the audio system
- LED Light Bar will Flash in Green colour (about 5sec)
b) Push 5sec: the ID learning process will be enabled
c) Push 0.5sec: turn off the audio system
- LED Light Bar will Flash in Blue colour (about 5sec)
d) Turn left/right: change the LED Light Bar colour
7 Gas Knob Switch On/Off the gas
3 4
1 2
5
6
7
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 7 -
I) Control Box (Receiver)
Item Name Description
1 Power Receptor Receptor for the supplied power adapter
2 Battery compartment Battery compartment
3 Battery LiFePO4 Rechargeable Battery Pack
132
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 8 -
II) Speaker (Receiver)
Item Name Description
1 Rigging Points Rigging Points used to fix the speaker in the Heater
2 Speaker cable 24 AWG cable
2
1
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 9 -
III) LED Light Bar (Receiver)
Item Name Description
1 LED Each Light Bar has 30pcs LED (RGB colour)
2 Light Bar cable 24 AWG cable
1
2
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 10 -
3. Operation
3.1 Transmitter Box Operation
a) For direct line in playback, please use the battery power
open the battery compartment on the bottom, put in 4 x AA battery and close the
compartment
Turn on the battery power switch
connect the Audio cable provided to the audio source and the 3.5mm audio jack
start playing songs in the music sources (e.g. MP3 Player)
b) For USB input, please use the USB bus power
Turn off the battery power switch
Connect the USB cable provided to your PC and the USB port of the Transmitter Box
start playing songs in your PC
3.2 Receiver (Control Box) Operation
a) For Adaptor power, connect the Adaptor provided to the Power Receptor
b) For battery power, insert the Li-FePO4 Rechargeable Battery Pack into the battery
compartment
c) Turn on the Control box by push the Control Knob (about 0.5Sec)
d) The Speaker will output the songs automatically
e) You can change the LED Light Bar colour by adjust the control Knob
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 11 -
4. Accessories
4.1 Transmitter box
I) USB Cable (Aulong Technology)
II) Audio Cable (Aulong Technology)
III) 4 x AA battery (Grand Hall)
4.2 Receiver (Totum Heater)
I) LiFePO4 Rechargeable Battery Pack (Grand Hall)
II) Adaptor (Vin = 120V (AC Power), Vout = 10V/5AH (AC Power)) (Grand Hall)
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 12 -
5. Specification
5.1 RF Specification
Item Specification Unit Note
Frequency Range 2406 ~ 2472 MHz
Channel 34
Modulation GFSK
RF TX Power 16±2 (typ) dBm Radiation Power
RX Sensitivity -79 (typ) dBm
5.2 Audio Specification
Item Specification Unit Note
SNR 79 (typ) dBr Audio Amp output @1KHz
THD + N -70 (typ) dB Audio Amp output @1KHz
Frequency Response +0.5 / +0.5 dB 20 ~ 20KHz
Crosstalk -96 (typ) dB Audio Amp output @1KHz
FSIV 2 Vrms
FSOV 2 Vrms
5.3 Electrical Specification
Item Specification Unit Note
Transmitter Box 6 V DC Power (250mA)
Control Box (Receiver) 10 V AC Power (5AH) (Grand Hall)
Speaker (Receiver) 12 V DC Power (900mA)
LED Driver (Receiver) 12 V DC Power (500mA)
5.4 LED Light Bar Specification
Item Type Note
Colour 12 01 – No colour
02 – White
03 – Red
04 – Pink
05 – Orange
06 – Yellow
07 – Bright Green
08 – Dark Blue
09 – Light Blue
10 – Light Purple
11 – Purple
12 – Grass Green
Totum --- 2.4G Wireless Audio System (with LED Light Bar)
- 13 -
6. Troubleshooting
Transmitter (No sound output from the speaker):
(a) Direct Line In
Battery compartment with battery?
Turn on the Battery Power Switch?
Direct Line in connect to the 3.5mm Audio jack properly?
Analog Audio Player (e.g. MP3) playing Music? or adjust sound level of the music
player?
(b) USB Audio
USB cable connected to USB port properly?
Disconnect the audio cable from the 3.5mm Audio jack?
Computer playing Music? or adjust sound level of the music player?
Receiver (No sound output from the speaker):
(a) Battery compartment with battery?
(b) Connect the adaptor properly?
(c) Can you switch on the Control Box?
Transmitter & Receiver (No sound output from the speaker):
(a) Both the Transmitter and the Receiver have the same ID?
Warning: the ID of both the Transmitter and the Receiver are 0000 (by default), if you
do the ID learning process, the ID of the Transmitter and the Receiver will change to a
random number