Gainward Co VGA-GWVZHA VGA CARD User Manual Manual
Gainward Co Ltd VGA CARD Manual
Manual
NVIDIA
GeForce256
Multimedia VGA Controller
Installation Guide
Version 1.0
01/00
Copyrights and Liabilities
The information contained in this manual has been validated at the time of this
manual’s production. The manufacturer reserves the right to make any changes and
improvements on the product described in this manual at any time and without notice.
Consequently, the manufacturer assumes no liability for damages incurred directly or
indirectly from errors, omissions or discrepancies between the product and the
manual. All registered trademarks are the property of their respective owners.
Copyright © 1999 All rights reserved. No reproduction of this document in any form
is permitted without prior written authorization from the manufacturer.
Trademark
All products and company names are trademarks or registered trademarks of their
respective holders.
MMP0000-10E-0C
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Notice:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with manufacturer's instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Plug the computer into a different outlet so that the two devices are on different
branch circuits.
. If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions.
Warning:
Shielded interface cables (except TV cable) must be used in order to comply with
emission limits.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Attention: This product, FCC ID:ICUVGA-GWVZHA, only be certified with
Monitor connector and TV-out S-video jack. The user should disregard any
information in the manual about other connectors.
CSA Notice:
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Table of Contents
Chapter 1 Overview................................................................... 1
Chapter 2 Hardware Installation ............................................. 2
Chapter 3 Software Installation ............................................... 4
Chapter 4 Display Properties for Windows.............................. 6
Chapter 5 Expertool for Windows.......................................... 11
Chapter 6 Technical Information........................................... 15
Chapter 7 Trouble Shooting................................................... 19