Garland Ecg Users Manual

ECG to the manual 91586e87-21f1-45d6-9ce7-a87955789b85

2015-02-09

: Garland Garland-Ecg-Users-Manual-559264 garland-ecg-users-manual-559264 garland pdf

Open the PDF directly: View PDF PDF.
Page Count: 12

Scroll down to view the document on your mobile browser.
P/N: 3073400 04/2001INSTALLATION AND OPERATINGINSTRUCTIONSFORECG SERIES ELECTRIC CHAINGRIDDLESTHIS MANUAL SHOULD BE HANDED TO THE EQUIPMENT OWNER ANDRETAINED FOR FUTURE REFERENCE.THE FOLLOWING INSTRUCTIONS SHOULD BE READ CAREFULLY AS THEMANUFACTURER CANNOT BE HELD RESPONSIBLE FOR ANY DAMAGE TOPROPERTY OR PERSONS CAUSED BY INCORRECT INSTALLATION OR OPERATIONOF THE EQUIPMENT.TABLE OF CONTENTSGENERAL INFORMATIONTECHNICAL SPECIFICATIONSGENERAL INSTALLATIONINSTALLATION PROCEDURECOMMISIONINGOPERATING INSTRUCTIONSMAINTENANCE & CLEANING……………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………PAGE 1PAGE 2PAGE 3PAGE 4PAGE 4PAGE 5PAGE 6 MANUFACTURED BY: DISTRIBUTED BY:GARLAND COMMERCIAL RANGES LIMITED GARLAND COMMERCIAL INDUSTRIED, INC.1177 KAMATO ROAD, MISSISSAUGA, 185 EAST SOUTH STREET,ONTARIO, CANADA L4W 1X4 FREELAND, PA 18224Phone: 905/624-0260 Fax: 905/624-5669 Phone: 570/636-1000 Fax: 570/636-3903ECGTRAINING06
1GENERAL INFORMATION1. Damage Check: Check carton or crate for possible damages incurred in shipping. Aftercarefully examining, check for “Concealed” damage. Report any damage immediately toyour carrier.2. Any protective material covering stainless steel parts must be removed.3. All units are shipped from the factory with legs or casters fitted, unless specifically orderedwithout4. The type of voltage supply that the equipment was manufactured for at the factory is noted onthe data plate and on the packaging. This type of supply must be used.5. Do not remove permanently affixed labels, warnings or data plates from the appliance, forthis may void approvals and create a safety hazard.NOTE: The griddle top is raw steel and can react with moisture forming rust. This is normal andnot considered a defect. Clean with a stainless steel fiber pad. A light coating of salt free oil maybe applied to prevent further rusting.INTRODUCTIONThe Garland ECG series complies with the standards CSA C22.2 no. 109 – latest edition, theUL197 – latest edition and the ANSI/NSF 4 – latest edition. The installation & connection ofthis appliance must comply with current codes. In Canada – the Canadian Electrical Code Part 1and in the USA – the National Electrical Code.SAFETYThis manual pertains to Electric Chain Griddles. The reader/operator must interpret its contentsto applicable needs. If there is any question of interpretation of any of the literature pertaining toGarland Electric Chain Griddles, please contact your Authorized Service Agency or ourCustomer Service Department at 1 800 427 6668.A qualified person must perform the installation in accordance with local codes.Always follow these safety instructions when operating the Electric Chain Griddle:Qualified persons must only operate the unit. DO NOT operate without reading this manual.DO NOT operate the product unless it has been properly installed and grounded.SAFETY - CONTINUED

Navigation menu