GemTek Technology A950927AG MOBILE MESH NETWORK SUBSCRIBER UNIT (MMSU) User Manual 802 11ag mobile device 2

Gemtek Technology Co., Ltd. MOBILE MESH NETWORK SUBSCRIBER UNIT (MMSU) 802 11ag mobile device 2

Contents

Manaul

2006/8/16 v1.0 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2006/8/16 v1.0 The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.
2006/8/16 v1.0 European Union Notice: Radio products with the CE marking comply with the R&TTE Directive (1999/5/EC).Compliance with these directives implies presumption of conformity to the following European Norms:•EN 60950-1 Product Safety•EN 300 328 / EN 301 893 Technical requirement for radio equipment•EN 301 489-1/-17 General EMC requirements for radio equipment•EN 50385

Navigation menu