GemTek Technology M940103AG47 Motion Computing LE1600 with 11a/b/g WLAN User Manual BM GP CS 08 2004 12 03
Gemtek Technology Co., Ltd. Motion Computing LE1600 with 11a/b/g WLAN BM GP CS 08 2004 12 03
Contents
Users manual BT
Bluetooth 1.2 USB module (BM-GP-CS-08) Data Sheet www.usi.com.tw December 2004 Rev 1.4 Introduction The Bluetooth Class 2 Module (model number BM-GP-CS-08) is a small module with 10-way connector that provides a complete 2.4GHz Bluetooth system. This ready-to-use Class2 Bluetooth module provides a fully compliant Bluetooth system V1.2 for data and audio communications. This module also provides the coexistence solution that is critical for Notebook implementation. The coexistence solution includes AFH, and WCS (Wireless Coexistence Solution). Activity Signaling is an option. Feature l Fully Qualified Bluetooth v1.2 system l Enhanced Data Rate(EDR) compliant with v0.9 of specification for both 2Mbps & 3Mbps modulation modes l Scatternet Support l With small size suitable for compact system integration. Low power consumption, extend the battery life. l 2.402 – 2.4835 GHz frequency band. l Support for 802.11b/g Coexistence including Intel WCS (Wireless Coexistence System). l Integrated Printed Antenna l Easy for integration into mobile and handheld device with flexible system configuration and antenna design. l On board 8 Mbits flash memory for firmware upgrade All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) General Description Features Description TM Standards Frequency Band Sensitivity Output Power Fully compliant with Bluetooth 1.2 Standard 2.402GHz ~ 2.4835GHz -82 dBm 4 dBm max with power control (Maximum Power measurement is from chip set) Peak Gain @ 2.45GHz: 0.5dBi 10m ~20m (Varies depending on operating environment) Operating temperature: 0 °C to +70 °C Storage temperature: -40 °C to +85 °C 3.3V DC +/- 10% Peak RF current during TX burst: 65 mA Peak RF current during RX burst: 47 mA Asynchronous:723.2kbps/57.6kbps Synchronous:433.9kbps/433.9kbps JST SM10B-SRSS-TB connector Length: 36.0 mm, Width: 13.8 mm, Height: 3.8 mm 2.0 grams +/- 15% Windows 98SE/ME/2000/XP Integrated Antenna Coverage Temperature Operating Voltage Power Consumption Data Rate Interface Dimensions Weight Operating systems Electrical Connector Pinout Figure 1: Connector pin assignment Pin Number Pin Name Description GND Ground USB_D+ USB D+ USB_D- RSVD USB DReserved for BT_Active output to 802.11b for CoExistence. This is optional if you need Activity Signalling scheme. BT Priority and Channel Clock for WCS. 10 BT_Priority / Ch_Clk (PIO4) HW_RADIO_DIS# (Optional) +3.3V Disable radio transmissions when low Channel Data for WCS (Standard). Or, WLAN_Active input from 802.11b for Activity Signalling which is optional. 3.3V power input LED LED indicator for radio activity GND Ground Ch_Data (PIO6) Table 2: Connector pin assignment All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Block Diagram Figure 2: Module Block Diagram Electrical Characteristics Absolute Maximum Ratings Rating Storage Temperature Supply Voltage: VDD Min Max -40 °C -0.40V +85 °C +3.60V Recommended Operating Conditions Operating Condition Min Operating Temperature Range* 0 °C Supply Voltage: VDD +3.0V Max +70 °C +3.60V All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Input/Output Terminal Characteristics Digital Terminals Input Voltage VIL input logic level low (VDD=3.0V) VIH input logic level high Output Voltage Min Typ Max Unit +0.8 VDD+0.4 0.2 Min Typ Max Unit 0.3VDD 0.7VDD -1 2.5 10 µA pF 2.8 0.2 VDD -0.4 0.7VDD VOL output logic level low, (lO = 4.0mA), VDD=3.0V VOH output logic level high, (lO = -4.0mA), VDD-0.2 VDD=3.0V USB Terminals Input threshold VIL input logic level low VIH input logic level high Input leakage current VSS < VIN< VDD CI Input capacitance Output levels to correctly terminated USB Cable VOL output logic level low VOH output logic level high Average Current Consumption VDD=3.3V Temperature = 20°C Typ Unit ACL data transfer 1Mbps USB (Slave) 50 mA ACL data transfer 1Mbps USB (Master) 58 mA Standby Mode (Connected to host, no RF activity) 10 mA 380 uA Mode Deep Sleep Peak Current Consumption VDD=3.3V Temperature = 20°C Mode Typ Unit Peak RF current during TX burst (+4 dBm , CW mode) 55.0 mA Peak RF current during TX burst (0 dBm , CW mode) 52.0 mA Peak RF current during RX burst (-82 dBm) 44.0 mA All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Radio Characteristics Radio Characteristics, VDD = 3.3V Temperature = +20°C Receiver Sensitivity at 0.1% BER Maximum received signal at 0.1% BER Transmitter RF transmit power Initial carrier frequency tolerance Frequency (GHz) Min Typ Max 2.402 2.441 2.480 2.402 2.441 2.480 -82 -84 -84 -78 -80 -80 Frequency (GHz) Min Typ Max 2.402 2.441 2.480 2.402 2.441 2.480 -3 -3 -3 10 10 10 35 35 35 Bluetooth Specification ≤−70 ≥-20 Bluetooth Specification -6 ? to +4(4) 75 Unit dBm dBm dBm dBm dBm dBm Unit dBm dBm dBm kHz kHz kHz 25 35 ≥16 dB 20dB bandwidth for modulated carrier 820 1000 ≤1000 kHz Drift ( five slot packet) ±15 ±25 ±25 kHz Drift Rate ±250 ±400 ±400 Hz/µs Frequency (GHz) Min Typ Max Bluetooth Specification Unit 2.402 2.441 2.480 2.402 2.441 2.480 140 140 140 115 115 115 165 165 165 140 140 140 175 175 175 RF power control range ?f1avg “Maximum Modulation” ?f2max “Minimum Modulation” 140≤f1avg≤175 ≥115 kHz kHz kHz kHz kHz kHz Notes: Results shown are referenced to input of the RF Balanced-Filter. All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Radio Characteristics, C/I and Adjacent Channel Power VDD = 3.3V Temperature = +20°C Frequency = 2441 MHz Min Typ Max Bluetooth Specification Unit C/I co-channel 11 ≤11 dB Adjacent channel selectivity C/I F=F0+1MHz -4 ≤0 dB Adjacent channel selectivity C/I F=F0-1MHz -4 ≤0 dB Adjacent channel selectivity C/I F=F0+2MHz -35 -30 ≤-30 dB Adjacent channel selectivity C/I F=F0-2MHz -21 -20 ≤-20 dB Adjacent channel selectivity C/I F=F0+3MHz -45 -40 ≤-40 dB Adjacent channel selectivity C/I F=FImage -18 -9 ≤-9 dB Adjacent channel selectivity C/I F=F0-4MHz -25 -20 ≤-20 dB Min Typ Max Bluetooth Specification Unit Adjacent channel transmit power F=F0±2MHz -35 -20 ≤-20 dBm Adjacent channel transmit power F=F0±3MHz -45 -40 ≤-40 dBm Receiver Transmitter All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Mounting Guide for Antenna Radiation In order to achieve longest communication range, please keep the area surrounding antenna free of grounding or metal housing. All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Impedance Matching of Antenna BM-GP-CS-08 utilizes a meander line printed antenna for radiate communication. Application environments, such as notebooks, PDAs, headsets or other handheld devices, both have plastic housings, different motherboards and other mechanism structures. These factors will cause the deviation of antenna resonant frequency. Therefore, impedance matching of antenna should be optimized for various applications to achieve longest communication range. Please consult USI for further information. All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Mechanical Drawing All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Laser Marking Legend: 1. USI MMYY: MMYY is the date code. MM stands for month while YY stands for the last 2 digits of the year. 2. P/N: BM-GP-CS-08 is the the standard USI model number. This part number can be customize to your specific part number. 3. MAC: MAC address. All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. Bluetooth USB Module (BM-GP-CS-08) Packaging For Additional information, please contact the following: Universal Scientific Industrial Co., Ltd. Headquarters 141, Lane 351, Taiping Road, Sec. 1, Tsao-Tuen , Taiwan, Http://www.usi.com.tw Tel: + 886-49-2350876, 2325876 Fax: +886-49-3439561, 2337360, 2351093 E-mail:usi@ms.usi.com.tw All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI. 10
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Encryption : Standard V1.2 (40-bit) User Access : Print, Copy, Fill forms, Extract, Assemble, Print high-res Create Date : 2004:12:07 17:50:51Z Modify Date : 2005:04:26 09:57:36+08:00 Page Count : 11 Creation Date : 2004:12:07 17:50:51Z Author : 李錫維 Producer : Acrobat PDFWriter 4.05Windows NT ª© Mod Date : 2005:04:26 09:57:36+08:00 Metadata Date : 2005:04:26 09:57:36+08:00 Title : BM-GP-CS-08 _2004-12-03_ Creator : 李錫維EXIF Metadata provided by EXIF.tools