GemTek Technology WIXFBR-117 2.5GHz WiMAX/WiFi CPE User Manual

User Manual

Model No: WIXFBR-117 WiMAX/WiFi CPE

Operating Frequency Range: 2.5GHz~2.7GHz

Bandwidth: 5MHz/10MHz

Operation temperature: 0℃~40℃

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However,

even if the equipment is installed properly, it is still possible that interference with radio or television reception may

result. If this equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by Clearwire could void the user's authority to

operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference; and (2) this device must accept any interference received, including

interference that may cause undesired operation.

IMPORTANT NOTE:

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated at a minimum distance of 20 cm from your body.

This equipment must not be co-located and must not operate in conjunction with any other antenna or transmitter.

The availability of some specific channels and/or operational frequency bands is country-dependent, and this

equipment is firmware programmed at the factory to match the intended destination. The firmware setting is not

accessible by the end user.