Gemalto 473GPO Smart Card Reader User Manual MES473GPO
Gemalto Smart Card Reader MES473GPO
Gemalto >
Manual
FCC ID: MES473GPO
Page 1/1
USER MANUAL
User manual is printing on the box with FCC statement document in:
FCC ID: MES473GPO
Page 1/1
USER MANUAL (FCC STATEMENT)
This is a copy of the page where the FCC statement is included:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Regulatory Information
Notice for the USA: FCC Statement
Federal Communications Commission (FCC) Radio Frequency Interference Statement (USA Only)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of FCC
Rules. These limits are designed to provide reasonable protections against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try one of more of the following measures:
Relocate the radio or television antenna.
Plug the equipment away from the radio or television.
Plug the equipment into a different electrical outlet, so that the equipment and the radio or television are on separate
electrical circuits.
Make sure that all your peripheral devices are also FCC Class B certified.
Make sure you use only shielded cables to connect peripheral devices to your equipment.
Consult your equipment dealer, or an experienced radio / television technician for help.
WARNING: The system verification tests were conducted with gemalto supported peripheral devices. Cables used with this
equipment must be properly shielded to comply with the requirements of the FCC.
Changes or modifications not expressly approved by gemalto could void the user's authority to operate the equipment.
"Accessories for use with UL Listed Computers having limited power or Class 2 output"