General Dynamics Broand NODEBBFZ 2GHz Band RN2410 Base Station User Manual V6 eNode B Installation Manual
General Dynamics Broadband, Inc. 2GHz Band RN2410 Base Station V6 eNode B Installation Manual
Installation Manual Regulatory Information Addendum
RN2410 2GHz Band Regulatory Information
GDB-3811 Iss-0.1
Page 1 of 1
General Dynamics Broadband
FCC Regulatory Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
No changes shall be made to the equipment without the manufacturer’s permission as this
may void the user’s authority to operate the equipment.
To comply with FCC requirements, the eNodeB has been approved for use with antennas
that have a maximum gain of 20dBi.Please refer to the FCC Grant of Certification for RF
Exposure exclusion distances.
The FCC Grant of Certification can be found using the FCC ID Search feature and entering
the FCC ID marked on the eNodeB. https://www.fcc.gov/general/fcc-id-search-page
RF Exposure
Antenna installations for the General Dynamics Broadband RN2410 LTE eNode B shall be
performed in accordance with the manufacturer’s recommendations and all national laws
and regulations. To ensure correct antenna installation, the installer shall evaluate
compliance with applicable national laws and regulations regarding exposure to
electromagnetic fields and define the required exclusion zones for RF workers and the
General Public.
Any changes to the antenna installation or radio transmission equipment require a re-
evaluation of the exposures to electromagnetic fields.
Pursuant to 47 CFR Part 1, Subpart 1, subject to the provisions of section 1.1307, all
installations must be evaluated for requirements contained in Table 1, “Limits for maximum
permissible exposure,” in section 1.1310.
2GHz Band
The 2GHz Band RN2410 eNode B has been assessed for compliance with FCC
requirements for antennas with gains upto 20dBi, the minimum exclusion distance required
to meet the Un-Controlled/General Public limit of 1.00mW/cm2 is 3.2m.