General Electric CSB42WSK C3
User Manual: General-Electric GE Appliances Literature Search Results
Open the PDF directly: View PDF 
.
Page Count: 3
| Download | |
| Open PDF In Browser | View PDF |
CSB42WSK GE Café™ Series 42" Built-In Side-By-Side Refrigerator DIMENSIONS AND INSTALLATION INFORMATION PRODUCT CLEARANCES STAINLESS STEEL WRAPPED REFRIGERATORS These refrigerators are equipped with a 2-position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. Stainless Steel wrapped refrigerators have wrapped doors and grille panels, and beveled edges. These models are shipped ready for installation. A 130° DOOR SWING H G 90° DOOR SWING B 22-3/8" BEHIND FRAME C C AB D E D F MODELS A B C D 42" 12-3/16" 16" 27-7/8" 4" Allow minimum clearances for Freezer door (Dimension A) and Fresh Food door (Dimension B) for a full 130° door swing and to allow for drawer removal. Four inch (4") minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, drawer access is maintained, but drawer removal is restricted. For answers to your Monogram, GE Café™ Series, GE Profile™ Series or GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center® Service, 800.626.2000. Overall Dimensions D Height to top of door (in.) A 84 Height to top of case (in.) B 83-1/2 Case depth without door (in.) C 22-3/8 Case depth less door handle (in.) D 25-3/4 Case depth with door handle (in.) E 28-1/4 Depth with fresh food door open 90˚ (in.) F 50-1/4 42 Width (in.) G Width with door open 90˚ inc. handle (in.) H 48-5/8 Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards. Listed by Underwriters Laboratories Specification Revised 5/16 CSB42WSK GE Café™ Series 42" Built-In Side-By-Side Refrigerator THE INSTALLATION SPACE 41-1/2" for 42" width models 47-1/2" for 48" width models 18" for 42" DIMENSIONS AND INSTALLATION INFORMATION GROUNDING THE REFRIGERATOR SIDE PANELS IMPORTANT—PLEASE READ CAREFULLY Side panels (not supplied) must be used whenever the sides of the refrigerator will be exposed. The 1/4" side panels will slip into the side case trim. Order side panels from your cabinet manufacturer. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. The power supply cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD. width models A 24" 6" 20" for 48" width models E 5" *83-1/2" MIN *84-1/2" MAX *Trim will overlap additional 7/16" *84" *Depending on installation height. FLOORING 75" From floor to bottom of electrical area 5" *3" to 4" 1-1/2" B A – Mounting the junction in this location will also allow for front accessibility through access panel. B – Water supply area. 5" 3-1/2" WATER FRONT VIEW ADDITIONAL SPECIFICATIONS For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 1500 lbs. A 120 volt, 60Hz, 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown. NOTE: Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where you are working. NOTE: GFI (ground fault interrupter) is not recommended. DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATOR TO A 2-PRONG OUTLET. WATER AND ELECTRICAL LOCATIONS DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE. THE CUTOUT DEPTH MUST BE 24" The opening must be prepared with the electrical and water supply located as shown. The refrigerator will project forward, slightly beyond adjacent cabinets, depending on your installation. For answers to your Monogram, GE Café™ Series, GE Profile™ Series or GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center® Service, 800.626.2000. Water line can enter the opening through the floor or rear wall. The water line installed should be 1/4" O.D. copper tubing or GE SmartConnect™ tubing between the cold water line and water connection location. The line should be long enough to extend to the front of the refrigerator. Installation of an easily accessible shutoff valve in the water line is required. Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards. Listed by Underwriters Laboratories Specification Revised 5/16 CSB42WSK GE Café™ Series 42" Built-In Side-By-Side Refrigerator FEATURES AND BENEFITS 42" built-in configuration LED Lighting – Illuminates the fresh food compartment, vegetable drawer and climate-controlled drawers to spotlight food without compromising space TM Advanced temperature management system – A multi-shelf air tower keeps foods fresh by evenly distributing air through the refrigerator Upfront temperature controls with actual temperature display – Features easy-to-reach, easy-to-read temperature controls and displays the actual temperature setting Advanced water filtration uses MWF replacement filter – Reduces trace pharmaceuticals from water and ice* (* Removes 98% of ibuprofen, atenolol, fluoxetine, progesterone and trimethoprim. These pharmaceuticals are not necessarily in all users’ water) Humidity-controlled drawers – Help preserve fruits, cheeses and vegetables Adjustable spillproof glass shelves – Raised edges help contain spills to make clean up quick and easy Large door bins – Offer ideal space for storing large containers in the door, freeing up valuable shelf space Model CSB42WSKSS – Stainless steel CSB42WSK_CSB48WSK Specification Revised 5/16
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27 Create Date : 2016:05:17 15:47:27-04:00 Metadata Date : 2016:05:17 15:47:34-04:00 Modify Date : 2016:05:17 15:47:34-04:00 Creator Tool : Adobe InDesign CS6 (Macintosh) Instance ID : uuid:d908cda7-5cc2-1640-800e-017890f114ea Original Document ID : adobe:docid:indd:061fe336-4939-11d8-bd03-8053a66144b2 Document ID : xmp.id:667AA8572C206811822AC7DAD557E040 Rendition Class : proof:pdf Derived From Instance ID : xmp.iid:BA28DDE52A206811822AC7DAD557E040 Derived From Document ID : adobe:docid:indd:061fe336-4939-11d8-bd03-8053a66144b2 Derived From Original Document ID: adobe:docid:indd:061fe336-4939-11d8-bd03-8053a66144b2 Derived From Rendition Class : default History Action : converted History Parameters : from application/x-indesign to application/pdf History Software Agent : Adobe InDesign CS6 (Macintosh) History Changed : / History When : 2016:05:17 15:47:27-04:00 Format : application/pdf Producer : Adobe PDF Library 10.0.1 Trapped : False Slug Checksum : 2779905101 Slug Post Script Name : Escrow-Roman Slug Foundry : The Font Bureau Slug Version : 1.000 Slug Outline File Size : 0 Slug Family : Escrow Slug Font Sense 12 Checksum : 2779905101 Slug Font Kind : OpenType - PS Slug Kerning Checksum : 0 Page Count : 3 Creator : Adobe InDesign CS6 (Macintosh)EXIF Metadata provided by EXIF.tools