Genica Gn 675Va Users Manual

GN-675VA to the manual bdb5ba41-e403-4629-a02d-a890133489dd

2015-02-09

: Genica Genica-Gn-675Va-Users-Manual-560055 genica-gn-675va-users-manual-560055 genica pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

DownloadGenica Genica-Gn-675Va-Users-Manual- Genica-gn-675va-users-manual
Open PDF In BrowserView PDF
Troubleshooting Guide
System

Probable Cause

Recommended Solution

Power switch to “I”
Position & LED and
Alarm are OFF

Power cord disconnected

Connect power cord

City power failure

Turn the power switch to “O”
position. When the city power has
resumed, turn the power to “I.”

AC fuse blown

Remove the load from the GN675VA. Check the fuse near outlet,
replace the fuse if it is blown.

Power switch to “I”
position & LED is
blinking YELLOW

Red LED Light on

Control PCM error

Call Dealer for Service

GN-675VA input voltage
over HI transfer voltage or
under low transfer voltage

Make sure the voltage of city
power is correct.

Control PCB error

Call Dealer for Service

Battery under or GN-675VA
as been shutdown

Charge battery, shut down,
condition will release automatically.

GN

675VA

UNINTERRUPTIBLE

Power Supply
GN-675VA

USER GUIDE
GN-675VA

Internet Protection

GN-675VA
Back Panel
Functions

STATUS

LAN
Interface
Outlet
Socket

LINE

MODEM

To Modem
From
Telephone
Line
Main
Switch
Outlet
Socket

Overview:

AC Input
Socket
Fuse &
Spare
Fuse

Outlet
Socket

The GN-675VA protects your sensitive electronic equipment from power disturbances. A power
outage can occur when you least expect it – threatening the loss of critical data. The Genica
GN-675VA Uninterruptible Power Supply works as a battery back up to protect your
equipment and data in the event of a power loss. In addition, the ARV (automatic voltage
regulator) and built-in line conditioner provides stable voltage when power fluctuates.
Also includes modem protection! By routing your modem cable through the GN-675 your
modem will also be protected from damage by occurrences such as a lightning strike.

Importance Notices:

Operation Instructions (FOR US / 110V use ONLY)

• Read instructions carefully before operating the GN-675VA UPS.
• All operation instructions should be followed.
• The GN-675VA should be power by a grounded power source.
DO NOT OPERATE THE GN-675VA WITHOUT a grounded power source.
• Replace fuse with the same type and rating only.

• Make sure that you are plugging the unit into 110v wall outlet
(city power) and that the power switch is in “O” position.
• Plug AC (power) cord into the outlet and plug the power cord
of the computer and peripherals into the female outlet of the
GN-675VA.
• Turn the power switch on back of the GN-675VA in the “I” position
and wait for about 3 seconds (soft start). Now the UPS is in AC
operation mode and DC inverter output is in “stand by” mode.
• When AC input power is interrupted (AC power failure) the led will
start blinking yellow, and an alarm will sound. The GN-675VA will
switch to battery operation mode automatically.

Warning:
• Don’t open the cover, there are no user serviceable parts inside.
• Don’t insert any object into ventilation holes or other openings.
• The GN-675VA is for computer use only.

System Function:
• Automatic voltage regulator. Built-in line conditioner provides stable
voltage when power fluctuates.
• Monitoring software allows the user to view status of the GN-675VA
• Modem (modem line) protection.
• Overload and short current protection.
• Automatically detect circuit and battery charge / discharge protection.

CAUTION: After initial start-up, keep power on continuously to the GN675VA for at least 12 hours to ensure batteries are fully charged.

Meaning of LED and ALARM

Electrical Specification
Inverter Capacity:

675VA

STATUS LED COLOR

ALARM SOUNDS

STATUS CONDITION

AC Input

110V +/- 20% 60Hz

Green

X

City power normal and battery full

Inverter Output (rms)

100VAC or 120VAC

Green Blinking

X

City power normal and battery charging

Inverter Regulation

+/- 3%

Yellow Blinking

1 Time 2 Sec

City power loss

Cosine

0.6

Yellow Blinking

1 Time 1 Sec

City power loss & battery low

Inverter Frequency

50 or 60Hz + 2%

Transfer Time

-< 3ms

Full Load Back-up Time

3 minutes

Battery Specification

7AH / 12V x 1

w w w. g e n i c a . c o m

Red

City power loss and battery low –
Or the GN-675VA has been shut down.

Yellow 25%

Battery charged 25%

Yellow 50%

Battery charged 50%

Yellow 75%

Battery charged 75%

Yellow 100%

Battery charged 100%
Source Exif Data: 
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : Yes
Create Date                     : 2002:06:28 10:32:19
Producer                        : Acrobat Distiller 4.05 for Macintosh
Modify Date                     : 2002:06:28 10:32:20-07:00
Page Count                      : 2
EXIF Metadata provided by EXIF.tools

Navigation menu