Getac Technology 041 Bluetooth Module User Manual BTC04R2XXX QIG FCC v01
Getac Technology Corp. Bluetooth Module BTC04R2XXX QIG FCC v01
user manual
CastleNet BTC04R User Guide User Guide Bluetooth2.1+EDR Module CastleNet Technology Inc. Copyright © 2008 All Rights Reserved. 1 of 6 CastleNet BTC04R User Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. CastleNet Technology Inc. Copyright © 2008 All Rights Reserved. 2 of 6 CastleNet BTC04R User Guide This device is intended only for OEM integrators under the following conditions: TANT NOTE: In the event that these conditions can not be met (for example certain laptop LABEL OF THE END PRODUCT: configurations co-location another in transmitter), then with the FCC authorization is no longer The final end or product mustwith be labeled a visible area the following" Contains TX FCC ID: MAU041 TheFCC FCCIDpart has toInalso be circumstances, available on the considered valid and".the can 15.19 not be statement used on the below final product. these the label: This device complies with Part 15 of FCC rules. Operation is subject to the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and following two conditions: obtaining a separate (1) this device mayFCC notauthorization. cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains TX FCC ID: MAU040”. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The users manual for OEM integrators must include the following information in a prominent location “IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements. The antenna must not be co-located or operating in conjunction with any other antenna or transmitter. CastleNet Technology Inc. Copyright © 2008 All Rights Reserved. 3 of 6 CastleNet BTC04R User Guide Canada-Industry Canada (IC) Operation is subject to the following two conditions: this device may not cause interference and this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment with IC radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with IC RF exposure compliance requirements, please follow operation instruction as documented in this manual. CastleNet Technology Inc. Copyright © 2008 All Rights Reserved. 4 of 6 CastleNet BTC04R User Guide 1. INTRODUCTION The BTC04R series is a embedded Bluetooth module, smallest form factor for Notebook and handheld PC. The Bluetooth function is based on CSR BlueCore4-ROM A07 single chip, which is fully compliant with Bluetooth 2.1 specification plus EDR. It has good RF performance. Lowest power consumption, piconet and scatternet capability. The interface is HCI USB compliant with USB fully speed (12Mbits). The cable connection and PIN define of “Host I/F connector” from BT module (BTC04R series) to PC system is specially customized by OEM Laptop PC. There are two models shown as below: Model A: the chip antenna is embedded on board. Model B: it requires the external antenna connection. CastleNet Technology Inc. Copyright © 2008 All Rights Reserved. 5 of 6 CastleNet BTC04R User Guide 2. INSTALLATION 2.1 Installed in Laptop PC The Mainboard of the system should provide a Host connector and Cable connection for BT module. Please follow the SOP to install & assemble it step by step. 2.2 Testing in Lab The module is embedded inside Notebook. If for testing purpose, we provide the “USB Testing Board” in order to let tester connect BTC04R via the special cable connection to PC externally. The USB Testing Board provides +5V/3.3V conversion from PC Host. Please plug into any USB port on your PC. After Hardware installation, when system find the new hardware, please install the driver / software correctly. CastleNet Technology Inc. Copyright © 2008 All Rights Reserved. 6 of 6
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Tagged PDF : No XMP Toolkit : 3.1-702 Producer : Acrobat Distiller 7.0 (Windows) Company : Toshiba Source Modified : D:20081001105134 Creator Tool : Acrobat PDFMaker 7.0 for Word Modify Date : 2010:09:15 14:34:52+08:00 Create Date : 2008:10:01 19:04:44+08:00 Metadata Date : 2010:09:15 14:34:52+08:00 Document ID : uuid:eb7e2af5-b257-40dc-8186-8a71f41461db Instance ID : uuid:d205bdbd-46fd-437d-a78f-971edd669932 Version ID : 13 Format : application/pdf Title : Microsoft Word - BTC04R2XXX_QIG_FCC_v01.doc Creator : user Subject : Headline : Has XFA : No Page Count : 6 Page Layout : OneColumn Author : userEXIF Metadata provided by EXIF.tools