Gibson Innovations SHB5250 Bluetooth Headphones User Manual 1

Gibson Innovations Limited Bluetooth Headphones 1

Contents

User manual-1

www.philips.com/supportUser manualAlways there to help youRegister your product and get support atSHB5250 Question?Contact Philips
1ENContents1 Important safety instructions 2Hearing Safety 2General information 22 Your Bluetooth in-ear headphones 3What's in the box 3Other devices 3Overview of your Bluetooth in-ear headphones 33 Get started 4Charge your headphones 4Pair the headphones with your mobile phone 44 Use your headphones 5Connect the headphones to a Bluetooth device 5Manage your calls and music 55 Technical data 76 Notice 8Declaration of conformity 8Disposal of your old product and battery 8Compliance with EMF 8Trademarks 97 Frequently asked questions 10
2EN1 Important safety instructionsHearing Safety Danger • To avoid hearing damage, limit the time you use headphones at high volume and set the volume to a safe level. The louder the volume, the shorter the safe listening time is.Be sure to observe the following guidelines when using your headset.• Listen at reasonable volumes for reasonable periods of time.• Be careful not to adjust the volume continuously upwards as your hearing adapts.• Do not turn up the volume so high that you can’t hear what’s around you.• You should use caution or temporarily discontinue use in potentially hazardous situations.• Excessive sound pressure from earphones and headphones can cause hearing loss.• Using headphones with both ears covered while driving is not recommended and may be illegal in some areas while driving.• For your safety, avoid distractions from music or phone calls while in trafc or other potentially dangerous environments.General informationTo avoid damage or malfunction:Caution • Do not expose headphones to excessive heat. • Do not drop your headphones. • Headphones shall not be exposed to dripping or splashing. • Do not allow your headphones to be submerged in water. • Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives. • If cleaning is required use a soft cloth, if necessary dampened with a minimum amount of water or diluted mild soap, to clean the product. • The integrated battery shall not be exposed to excessive heat such as sunshine, re or the like. • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.About operating and storage temperatures and humidity• Operate or store in a place where temperature is between -15ºC (5ºF) and 55ºC (131ºF) (up to 90% relative humidity.• Battery life may be shorter in high or low temperature conditions.
3EN2 Your Bluetooth in-ear headphonesCongratulations on your purchase, and welcome to Philips! To fully benet from the support that Philips offers, register your product at www.philips.com/welcome.With this Philips wireless in-ear headphones, you can:• enjoy convenient wireless handsfree calls;• enjoy and control wireless music;• switch between calls and music.What's in the box Philips Bluetooth in-ear headphones SHB5250 USB charging cable (for charging only) Quick start guideOther devicesA mobile phone or device (e.g. notebook, PDA, Bluetooth adapters, MP3 players etc) which supports Bluetooth and is compatible to the headphones (see 'Technical data' on page 7).Overview of your Bluetooth in-ear headphones a Volume/Track control buttonb Micro USB charging slot c LED indicatord On/off, music/call control buttone Microphonebaedc
4EN3 Get startedCharge your headphonesNote • Before you use your headphones for the rst time, charge the battery for 5 hours for optimum battery capacity and lifetime. • Use only the original USB charging cable to avoid any damage. • Finish your call before charging the headphones, as connecting the headphones for charging will power the headphones off. • You can operate the headphones normally during charging.Connect the supplied USB charging cable to: • the micro USB charging slot on the headphones and; • the charger/USB port of a computer. » LED turns white during charging and turns off when the headphones is fully charged.Tip • Normally, a full charge takes 2 hours.Pair the headphones with your mobile phoneBefore you use the headphones with your mobile phone for the rst time, pair it with a mobile phone. A successful pairing establishes a unique encrypted link between the headphones and mobile phone. The headphones store the last 4 devices in the memory. If you try to pair more than 4 devices, the earliest paired device is replaced by the new one. 1 Make sure that the headphones are fully charged and turned off.2 Press and hold the on/off button until the blue and white LED ashes alternately. » The headphones remain in pairing mode for 5 minutes.3 Make sure that the mobile phone is turned on and its Bluetooth feature is activated.4 Pair the headphones with the mobile phone. For detailed information, refer to the user manual of your mobile phone.The following example shows you how to pair the headphones with your mobile phone.1 Activate the Bluetooth feature of your mobile phone, select Philips SHB5250.2 Enter the headset password "0000" (4 zeros) if prompted. For those mobile phones featuring Bluetooth 3.0 or higher, no need to enter a password. SettingsDevices FoundSelect10:36Settings ConnectivitySelectBack10:37Enter Password****0000SettingsBluetoothSelectBack10:35ConnectivityAddBluetoothdeviceBackPhilips SHB5250
5EN4 Use your headphonesConnect the headphones to a Bluetooth device1 Turn on your mobile phone/Bluetooth device. 2 Press and hold the on/off button to turn the headphones on. » The blue LED ashes. » The headphones are reconnected to the last connected mobile phone/Bluetooth device automatically. If the last one is not available, the headphones try to reconnect to the second last connected device.Tip • If you turn on the mobile phone/Bluetooth device or activate the Bluetooth feature after turning on the headphones, you have to reconnect the headphones and mobile phone/Bluetooth device manually.Note • If the headphones fail to connect to any Bluetooth device within range in 5 minutes, it will switch off automatically to save the battery life.Manage your calls and musicOn/off Task Button OperationTurn the headphones on.On/off, music/call controlPress and hold for 2 seconds.Turn the headphones off.On/off, music/call controlPress and hold for 4 seconds. » The white LED is on and fades out.Music control Task Button OperationPlay or pause music.On/off, music/call controlPress once.Adjust volume. +/-Press once.Skip forward. +Long press.Skip backward. -Long press.Call controlTask Button OperationPick up/hang up a call.On/off, music/call controlPress once. » 1 beep.Switch caller during a call.On/off, music/call controlPress twice. » 1 beep.Other headphones indicator status Headphones status IndicatorThe headphones are connected to a Bluetooth device, while the headphones in standby mode or while you are listening to music.The blue LED ashes for every 8 seconds.The headphones are ready for pairing.The LED ashes blue and white alternately.The headphones are on but not connected to a Bluetooth device.The blue LED ashes quickly.If no connection can be made, the headphones will turn itself off within 5 minutes.
6ENLow battery level. The white LED ashes 3 times for every 10 seconds until it is out of power.Battery is fully charged.White LED is off.
7EN5 Technical data• Music time: 4.5 hours• Talk time: 4.5 hours• Standby time: 55 hours• Normal time for a full charge: 2 hours• Rechargeable lithium polymer battery (120 mAh)• Bluetooth 4.1, Bluetooth mono support (Headset Prole - HSP, Hands-Free Prole - HFP), Bluetooth stereo supported (Advanced Audio Distribution Prole - A2DP; Audio Video Remote Control Prole - AVRCP)• Operating range: Up to 10 meters (33 feet)• Digital echo & noise reduction • Auto power offNote • Specications are subject to change without notice.
8EN6 NoticeDeclaration of conformityHereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. You can nd the Declaration of Conformity on www.p4c.philips.com.Disposal of your old product and battery Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. This symbol on a product means that the product is covered by European Directive 2012/19/EU. This symbol means that the product contains a built-in rechargeable battery covered by European Directive 2013/56/EU which cannot be disposed of with normal household waste. We strongly advise you to take your product to an ofcial collection point or a Philips service centre to have a professional remove the rechargeable battery. Inform yourself about the local separate collection system for electrical and electronic products and rechargeable batteries. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.Remove the integrated batteryNote • Make sure the headphones are disconnected from the USB charging cable before removing the battery.If there is no collection/recycling system for electronic products in your country, you can protect the environment by removing and recycling the battery before disposing the headphones. Compliance with EMFThis product complies with all applicable standards and regulations regarding exposure to electromagnetic elds.Environmental informationAll unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of
9ENpackaging materials, exhausted batteries and old equipment.TrademarksBluetoothThe Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Gibson Innovations Limited is under license. Other trademarks and trade names are those of their respective owners.
10 EN7 Frequently asked questionsMy Bluetooth headphones do not switch on.The battery level is low. Charge the headphones. I cannot pair my Bluetooth headphones with a mobile phone.The Bluetooth is disabled. Enable the Bluetooth feature on your mobile phone and turn on the mobile phone before you turn on the headphones. Pairing does not work.Make sure the headphones are in pairing mode.• Follow the steps described in this user manual. • Make sure that the LED light ashes blue and white alternately before you release the call/music button. Do not stop holding the button if you see the blue LED only. The mobile phone cannot nd the headphones. •The headphones may be connected to a previously paired device. Turn off the connected device or move it out of range. •Pairing may have been reset or the headphones have been previously paired with another device. Pair the headphones with the mobile phone again as described in the user manual. My Bluetooth headphones are connected to a Bluetooth stereo enabled mobile phone, but music only plays on the mobile phone speaker.Refer to the user manual of your mobile phone. Select to listen to music through the headphones. The audio quality is poor and crackling noise can be heard.The Bluetooth device is out of range. Reduce the distance between your headphones and Bluetooth device, or remove obstacles between them. The audio quality is poor when streaming from the mobile phone is very slow, or audio streaming does not work at all.Make sure your mobile phone not only supports (mono) HSP/HFP but also supports A2DP (see 'Technical data' on page 7). I hear but cannot control music on my Bluetooth device (e.g. play/pause/skip forward/backward).Make sure the Bluetooth audio source supports AVRCP (see 'Technical data' on page 7). For further support, visit www.philips.com/support.
08902015 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V.UM_SHB5250_00_EN_Draft0.1wk1548

Navigation menu