Golight 3049T Remote Control Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	529042
Application ID	BBP9+H74j00iPLE92CMnSQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	163.17kB (2039658 bits)
Date Submitted	2005-04-06 00:00:00
Date Available	2005-04-06 00:00:00
Creation Date	2005-04-06 11:33:26
Producing Software	Adobe Acrobat 6.02 Image Conversion Plug-in
Document Lastmod	2005-04-06 11:33:27
Document Title	Users Manual
Document Creator	Adobe Acrobat 6.02

* FCC RULE
Part.15.1[)5 Note: This equipment has been tested and
found to comply with the limits for a Class B dI Ital device,
pursuant to Part 15 ofthe FCC Rules. These Ilm is are
designed to provide reasonable protection against
harmful Interference In a residential lnstallatlon.This
equipment generates,uses and can radiate radio
frequency energy and,lf notlnstalled and used In
accordance wit the Instructions, may cause harmful
interference to radio communications.However,there
Is no guarantee that Interference will not occur In a
fiarllcular Installation. If this equipme does cause
armful interference to radio ortele on reception,
which can be determined by turning the equipment on
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--|hc_rease the separation between the equipment and
receiver.
--Connect the equipment Into an outlet on a circuit
different from that to which the receiver Is connected.
--Consultthe dealeror an experienced radio/TV
technician for help.
Part.15.21-changes or modifications made hy the
user not expressly approved by Golight. lnt.for compliance could
void the user's authority to operate the equipment.
For safe and eflicient operation ofyourGoIight" suylrer'M, observe
these guidelines
Your Stryker‘“ is a radio transmitter and receiver operating at
433mm. Whenever the light is on,the Internally mounted antenna
sends out and receives radio frequency (RF) energy.
- Modern electronic equipment, i.e. Personal medical devices such
as pacemakers hearing aidseicmre shielded from RF energy.
However.lil= energy may affect some electronic equipment
- Vehicle electronic systems may be affected by RF energy
Checkwith yourvehide manufacturer representative to be sure
that your StrykerW will not affect the electronic system of your
vehicle.
Five Year Limited warranty
Golight, inc. warrants the Stryker‘“ against any deemed defects
that are due to workmanship for parts or faulty materialsexcept
lamps, for five years from the date of the original purdlaseJ'hiS
warranty does not cover damage resulting from unreasonable
use or misuse and unreasonable maintenance or loss.
Warranty cards must be filled out and sent in within so days of
purchase to Golight. Inc. r RT 3 Boat 373 ~ Culbertson, NE 68024,
for warranty protection. Register online at wwwaolightcom.
If the Golight" StryIter'M does {all to operate under warranted
specifications, send the light and remote control postage paid.
plus $9.95 for shipping and handling to: Golight Inc. ~ Service
Department - RT 3 Box 378 - Culbertson. NE 69014. No c0.D.'s
accepted. Only the above manufacturer is authorized to perform
warranty repair or replace product.
Any consequential damages to person or property are excluded
from this warranty. Some states do not allow the ethusion and
limitation of incidental or consequential damages, therefore the
above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights and you may also have
other rights.
GOLIGH’I"
sought, Inc.
RT 3 Box 378 ‘ Culbertson, NE 69024
0004557009. ' 30827531 31 ' mgolighuom
strylrer“
By Goligl-rto
Congratulations
Vou are new the owner of one of the finest
remote control searchlights available today.
Thank you for letting Gollghto assist you in your
lighting application needs. We‘re proud
ofour products and the technology that
we've developed to ensure ourcustomers
(he most durable, versatile and powerful
searchllghts In the lighting Industry.
Please read these instructions
before using your new
Golighto Strykerw.
Instruction Guide
The Gollgm" strykerw ls deslgned to permanently attach to a vehicle.
The 2»Speed Searchlight with Directional Flexibility is controlled bya
wireless remote. which gives the operator a full 370° horizontal
rotation and a 135° vertical tilt with lingenip control. The srrylteriM
provides superior light penetration with the new crs Pentalaeamw II
technology.
The Strylter'"l Includes:
- Strylterw Searchlight
' Remote Control
' 2 GP Super Alkaline Batteries 23A IZV
- Rockguard
- Permanent Mount Gasket
- Permanent Mounting Plate
- Mounting Screws
MOUNTING INSTRUCTIONS
Determine the location for the light on your vehicle or boat. Center
the mounting plate with the vlse screw on the mounting plate to the
back. Mark the hole locations for the three mounting screws and drill
a pilot hole for each with 1/5 inch bit. Fasten the stainless steel
mounting plate with the 3 itm— 16 x 3/4 type AB aoss recessed pan
head tapping screwsrstainless steel. Drill a hole in the center ofthe
mounting plate hole to accommodate the power cord. Bring the
power cord through the surface ofthe vehicle and install the
grommet provided into the hole over the wire.
when connecting the positive and negative wires keep in mind that
the Strykerm electronics are not polarized. Vau do not have to be
concerned with connecting the positive and negative wires
Incorrectly. The 12volt DC power wire should be Joined to the leads
under the lamp with appropriate automotive wire attachments. Keep
the wire connection above the mounting surface.
Wet mounting surface with a small amount of water for easier
installation,then Place the light over the mounting plate by sliding
the front of the light overthe front of the plate first,then seating
the back ofthe light on to the mounting plate. Displace the back
or the gasket and install the vise screw(provided).Using a p
screw d river tighten. Replace the gasket.
ps
The power should be fused at 10 amps and be on an ignition switched
circuit lr possiblevmh power connected your light is ready ror
operation.
PROGRAMMABLE neuron INSTRUCTIONS
The colighto srrylrerm is oontrolled with a programmable remote with
6561 different channels. This feature allows you the freedom to
change the channel selection,and the receiver relearns the new
selection.
PROGRAMMING the TRANSMrI'I'ErL
This light has been preprogramnred at the factory, and it is not
necessary to re-program the transmitter, unless you aperience
outside interference.
l. IMPORTANT: DISiconnecl power by removlng fuse or
disconnecting vehicle battery.
2.Remove battery cover from back of handheld remote]
Remove rubber cover from front of dash mount remote.
3. Set the 7 dip switches to a selection of your choice. There are 3
positions on each; positive. negative, and neutral. use a small
screwdriver and select a position for each dip switch.
4. Insert both GP 13A 11V batteries with the +l- in the same
direction. Make sure batteries have adequate charge.
5. Replace battery cover,
-. Depress the on/oif button and hold it down, Red LED will light.
b. While holding the Wolf button down, reinstall the power
(replace fuse or connect vehicle battery).
r. Keep your finger on the on/off button a few seconds, and then
release. The light should now be programmed.
OPERATION OF STRVKER'“
‘|. Using the remote controltum on the light using the on/off switch.
2. With the 4-way switch on the remote control, rotate your light to
the desired location. Depending upon conditions, the remote may
be used up to 100 feetfrom the Stryker‘".
3. The speed of the light rotation can be controlled bydepresslrlg
the fast/slow button one time and by depressing It again to
restore the original speed.
BULB REPLACEMENT
The Golight' Strylter'M utilizes a Philips‘ 9011 bulb,which may be
purchased through Golight. Inc. — 308.278.3131 or 800.557.0098.
IMPORTANT SAFETY INFORMATION
* This symbol is to alert you to important operating or servicing
instructions that appear in your instructions. Always follow basic
safety precautions when using this product to reduce the risk of
injury,fire or electric shock.
* This light is for off road and utility use only. It is not designed for
road use as a driving light.
* The Strylter'M complies with Part.15 of the FCC Rules. Operation Is
subject mthe following two conditions:
L This light and remote may not cause harmful Interferenceand
2. This light and remote must accept any interference received,
including interferencethat may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 2
XMP Toolkit                     : XMP toolkit 2.9.1-14, framework 1.6
About                           : uuid:fafbeb31-db9a-4e47-ad71-654e2c11c7b6
Modify Date                     : 2005:04:06 11:33:27+02:00
Create Date                     : 2005:04:06 11:33:26+02:00
Metadata Date                   : 2005:04:06 11:33:27+02:00
Document ID                     : uuid:8e5abeb0-8cb2-4cda-bada-ee3fcf6c6a7d
Format                          : application/pdf
Creator                         : Adobe Acrobat 6.02
Producer                        : Adobe Acrobat 6.02 Image Conversion Plug-in

EXIF Metadata provided by EXIF.tools