Good Way Technology WD6050Z2 USB Z-Wave Dongle User Manual
Good Way Technology Co., Ltd. USB Z-Wave Dongle
User Manual
USB Z-Wave® Dongle
User’s Manual
1. Hardware Specification
LED
Indicator Light
Status Description
RED Solid Z-Wave USB dongle is activating,
when it is ready, the light will be off
BLUE
Blinking slowly
5 sec. Inclusion
Blinking fast 5
sec. Exclusion
GREEN
Blinking/Solid
When sending or receiving the
Z-Wave command, the time the light
remains on is determined by the size
of the Z-Wave command packet
Solid
For detecting the anomaly, for
example, the conditions of the smart
plug after inclusion. When the plug is
removed, yet the user sends the
command to switch on under
disconnection, the Z-Wave command
will be saved in queue module
temporarily. After trying 3 times,
according to Z-Wave feature, and
there are no responses, the
command will be aborted and the
next command will be executed.
2. Installation
3. Product Specification
Power DC 5V (USB bus powered)
Host Interface USB A-Type Plug
USB Compliance Compliant with USB 2.0 version specification.
Frequency WD6050Z2: 908.42 MHz (US);
WD6051Z2: 868.42 MHz (EU);
WD6052Z3: 922.5 MHz (JP)
Housing Plastic
LED Indicator Red / Green / Blue *
Protocol Z-Wave(ZM5101)
Data Rate 100kbps
Operation Range 100 feet(About 30M)
Application Indoor use
Operation Temp. 0℃~40℃
Regulatory Approval FCC/CE/TELEC
* Please see LED Indicator table in Hardware Specification for more details.
4. Regulatory Compliance
FCC conditions
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this
device could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CE
This equipment is in compliance with the requirements of the following
regulations: EN 55 022: CLASS B
WEEE Information
For EU (European Union) member users:
According to the WEEE (Waste electrical and electronic equipment)
Directive, do not dispose of this product as household waste or commercial
waste. Waste electrical and electronic equipment should be appropriately
collected and recycled as required by practices established for your country.
For information on recycling of this product, please contact your local
authorities, your household waste disposal service or the shop where you
purchased the product.
20160111
LEDIndicator