HANK ELECTRONICS STICK Z-WAVE STATIC CONTROLLER User Manual

HANK ELECTRONICS CO., LTD. Z-WAVE STATIC CONTROLLER Users Manual

Users Manual

Download: HANK ELECTRONICS STICK Z-WAVE STATIC CONTROLLER User Manual
Mirror Download [FCC.gov]HANK ELECTRONICS STICK Z-WAVE STATIC CONTROLLER User Manual
Document ID3799596
Application IDcw9neiurleFo2ZC/EAVXGg==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize12.12kB (151530 bits)
Date Submitted2018-03-28 00:00:00
Date Available2018-03-28 00:00:00
Creation Date2018-03-14 17:13:05
Document Lastmod2018-03-14 17:13:05
Document TitleUsers Manual
Document CreatorWPS Office
Document Author: Sky123.Org

OPERATING MANUAL
Z-WAVE STATIC CONTROLLER
HKZW-STICK
The Stick is a USB v2.0 full speed low power CDC-ACM compliant Z-Wave adapter in a thumb
drive form factor. The Stick can act as a Z-WAVE Controller when it’s connected to a host like
PC, MAC or Gateway (some in the market) etc. With a certain program installed on the PC, it
can add or remove devices in or from a network.
Ⅰ. GENERAL INFORMATION ABOUT STICK
1. Product layout
2. Specifications
Power supply:
Storage environment:
Operational temperature:
Radio protocol:
Radio frequency:
Range:
Dimensions:
DC 4.75~5.25V
-20℃~60℃
0%~80%
-10℃~40℃
Z-Wave
868.42 MHz (EU)
908.42 MHz (US)
921.42 MHz (ANZ)
More than 150m outdoors
About 40m indoors (depending
on building materials)
90*25*11mm
Ⅱ. INSTALLATION
The stick can act as a secondary controller within an existing z-wave network after the terminal
program being installed. You can also use the stick to make a new z-wave network.
As the device exports a USB CDC/ACM class compliant interface, it appears as a serial port,
reusing existing standard drivers on most popular PC operating systems. As such there is no
vendor driver required.
1 Windows 2000/XP/Vista/7/8 32 & 64 bit
UZB.INF & UZB.CAT are provided in the Z-Wave SDK that reuses the standard Windows usbser.sys
or usbser64.sys driver. The device appears in the Device Manager under the Ports section, and is
accessible through the Windows CreateFile API by applications as “//.//COMxxx” where xxx is the
COM Port number assigned by the OS.
2 Linux kernel 2.6.24+
The device appears as “/dev/ttyACMxx” where xxx is the tty number assigned by the OS.
3 MAC OS X 6.4
The device appears as “/dev/tty.usbmodemxxx” where xxx is the tty number assigned by the OS.
Ⅲ.INDICATOR
1. The LED indicator on the Stick will keep being on when it’s successfully connected to the
host.
2. The LED Indicator will blink once when the stick is sending a Z-WAVE command.
IV.FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
The manufacturer is not responsible for any radio or tv interference caused by unauthorized
modifications or change to this equipment. Such modifications or change could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Page Count                      : 2
Author                          : Sky123.Org
Comments                        : 
Company                         : 
Create Date                     : 2018:03:14 17:13:05+09:13
Creator                         : WPS Office
Modify Date                     : 2018:03:14 17:13:05+09:13
Producer                        : 
Source Modified                 : D:20180314171305+09'13'
Subject                         : 
Title                           : 
Trapped                         : false
EXIF Metadata provided by EXIF.tools
FCC ID Filing: 2AIOC-STICK

Navigation menu