Contents
- 1. Exhibit 8
- 2. REVISED SAR INSERT
REVISED SAR INSERT
LZT 123 4598/6 R2
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission (FCC) of
the U.S. Government. These limits are part of comprehensive guidelines
and establish permitted levels of RF energy for the general population.
The guidelines are based on standards that were developed by indepen-
dent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone trans-
mitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the
maximum value. This is because the phone is designed to operate at
multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna,
the lower the power output.
Before a phone model is available for sale to the public, it must be tested
and certified to the FCC that it does not exceed the limit established by
the government-adopted requirement for safe exposure. The tests are
performed in the locations as required by the FCC for each model. The
highest SAR value as reported to the FCC for this model phone when
tested for use at the ear is 1.40 W/kg and when worn on the body is
1.16 W/kg. Body worn measurements are made while the phone is in
use and worn on the body with an Ericsson accessory. The design and
composition of an accessory can affect the body worn SAR levels for the
phone. Ericsson has not measured, and makes no representation about
the body worn SAR levels when the phone is used with non-Ericsson
accessories.
The FCC has granted an Equipment Authorization for this model
phone with all reported SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. While there may be differences between
the SAR levels of various phones, all mobiles granted a FCC equipment
authorization meet the government requirement for safe exposure.
SAR information on this model phone is on file with the FCC and can
be found under the Display Grant section of http://www.fcc.gov/oet/
fccid after searching on FCC ID AXATR-416-A2.
Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications & Internet Association
(CTIA) web-site at http://www.phonefacts.net/.
___________________________________
* In the United States and Canada, the SAR limit for mobile phones
used by the public is 1.6 watts/kilogram (W/kg) averaged over one
gram of tissue. The standard incorporates a substantial margin of
safety to give additional protection for the public and to account for
any variations in measurements.
Important Information