HES 6 Rev B 5000 Series Installation Guide HES5000Install Instructions

5000 Installation Instructions HES 5000 Install Instructions Hanchett Entry Systems (HES) | JMAC Supply

User Manual: HES HES 5000 Series Installation Guide Installation Guide

Open the PDF directly: View PDF PDF.
Page Count: 6

Installation Diagrams
DIAGRAM 7: JAMB CUTOUT DIMENSIONS
DIAGRAM 6: JAMB VIEW
3
DIAGRAM 4: FAIL SAFE CONVERSION
Strike Conversion
a. Loosen the two #2-56 screws located on the back of the
strike as shown above, but do not remove them.
b. Move screws from the top of the hole (Fail Secure position)
to the bottom hole (Fail Safe position) as shown above.
c. Tighten screws.
Convert Mode
d. Verify the strike is now in the Fail Safe operation
mode. If the strike still operates as Fail Secure, be sure
screws are fully seated in the bottom position.
Verify
4-7/8” x 1-1/4” Square Corner Faceplate
ANSI Metal Jamb Installations
5000 with 501 Faceplate
3 -3/8"
[85.7]
1 -1/4"
[31.8]
4 -7/8"
[124]
11/16"
[17.5]
[2.3]
3/32"
[mm]
Inches
1 -1/4"
[31.8]
4 -7/8"
[124]
4 -1/8"
[104.8] 1 -7/16"
[36.6]
a
b
Fail Safe position
4
Cutout Templates
4-7/8” x 1-1/4” Radius Corner Faceplate
Aluminum Jamb Installations
5000 with 501A Faceplate
1 -1/4"
[31.8]
4 -7/8"
[124]
3 -3/8"
[85.7]
11/16"
[17.5]
3/32"
[2.3]
4 -7/8"
[124]
4 -1/8"
[104.8] 1 -7/16"
[36.6]
1 -1/4"
[31.8]
R 1/8"
[3]
7-15/16” x 1-7/16” Radius Corner Faceplate
5000 with 502 Faceplate
Aluminum Frame Installations
3-3/8"
[85.7]
11/16"
[17.5]
3/32"
[2.3]
1 -7/16"
[36.5]
7-15/16"
[201.6] 1 -7/16"
[36.6]
7 -15/16"
[201.6]
7 -7/16"
[189]
1 -7/16"
[36.6]
R 3/16"
[4.1]

Navigation menu