HUANG BO TOYS FACTORY HB-YY101620 Remote control car series User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3419521
Application ID	3YJDsI3XPe68v+orlSdc9Q==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	109.49kB (1368663 bits)
Date Submitted	2017-06-09 00:00:00
Date Available	2017-06-09 00:00:00
Creation Date	2017-06-08 20:35:26
Producing Software	Adobe Acrobat 11.0 Image Conversion Plug-in
Document Lastmod	2017-06-08 20:35:37
Document Title	User Manual
Document Creator	Adobe Acrobat 11.0

'35? Product Operation Manual
CHOKING HAZARD-small parts,
not for children under 3 years.
It‘s possible difference between
pictures and real products!
FOR AGES 3 AND UP
nrr-nnnnrnssmu
K1. Némsefmrtéi
Go lam-W Turn My
Backward mm mm
Turning
Who-I
OFF/ON OFF/ON
4X1 5WA'
Included it»... ml raw)
Ll
2x1 sv'AA'
lam m mm
{Zlfiiéiééléfiéfi éfiéfiéfilfiééfifiiéfifiéi
(1) Install 2x1.5V battery according to the polarity
marks in the battery compartment.
(2) Replace the battery cover.
How to install battery in the car
(3) Locate the hole on the top of the transmitter for
installing the antenna. Insert the antenna in and
turn clockwise to fix it.
(4) Correctly install the rechargeable battery pack in
the battery compartment and replace the battery
cover.
(5) Fasten the screw with a plus driver.
The car must charge with
the special charger, be sure
that the technology parameter
is fit for the chargerDo not
help youselves to match
' a charger.
Wm
How to install battery In
the transmitter
lnr-y mlml
.3 B'ééi'c' ob'ér'ét'iéh' 6f 'T'lié'c'dfit'r'dliéf '3
Backward
L4 BATTERY SAFETY J
1) Adult's supervision is required for charging.
(2) To charge the rechargeable battery pack in the car, first remove it from the chassis.
(3) Timely remove exhausted batteries from the car and the transmitter.
(4) Make sure the main switch is set to OFF before installing the battery pack into the car body.
(5) Note polarity marks in the battery compartments when installing the batteries.
(6) Do not try to charge non-rechargeable batteries.
(7) Do not short-circuit the batteries.
(8) If you plan to stop use for a long time, remove the batteries from the transmitter and the car body to avoid leakage.
(9) Never throw the batteries into fire to avoid explosion or leakaget
(10) Do not mix batteries from different producers or new and old batteries.
(11) Use only recommended batteries or equivalent ones.
(12) Check the batteries on a regular basis to avoid leakage.
(13) Keep this manual well for future reference as it contains important information about this product
iiéliééEf/ééifiéiiéi
'When the car is in motion, do not touch the wheels by hand to avoid damages to the car.
9’ "u,® m
1—.) 11 Mg
as)” M“, 0 ~
When there‘s more than one car played in the same
plans. set the cars to dmerenl band: a: avold mutull
lntefleranoa
D0 "01 bend the antenna or point it at other
people or articles to avold hurts.
Do not play in a place with
Puddle. mud or sand.
The statements should be displayed in the user manual:
changes or modifications not expressly approved by the party responsible for
compliance could void the user' s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi Ion
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the recei lng antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
» Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules, Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation,

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Create Date                     : 2017:06:08 20:35:26+08:00
Creator                         : Adobe Acrobat 11.0
Modify Date                     : 2017:06:08 20:35:37+08:00
Title                           : 
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2017:06:08 20:35:37+08:00
Creator Tool                    : Adobe Acrobat 11.0
Format                          : application/pdf
Document ID                     : uuid:6ba4cf27-3af1-41d2-ad13-83498742292a
Instance ID                     : uuid:b092d008-786f-4618-8905-11cc4d0c33f8
Producer                        : Adobe Acrobat 11.0 Image Conversion Plug-in
Page Count                      : 1

EXIF Metadata provided by EXIF.tools