HUANG BO TOYS FACTORY HBDP-27MHZ BUMPER CARS User Manual

HUANG BO TOYS FACTORY BUMPER CARS Users Manual

Users Manual

Download: HUANG BO TOYS FACTORY HBDP-27MHZ BUMPER CARS User Manual
Mirror Download [FCC.gov]HUANG BO TOYS FACTORY HBDP-27MHZ BUMPER CARS User Manual
Document ID3567471
Application IDS5ZWz2R3yBLb0XKVbbo1bw==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize164.89kB (2061085 bits)
Date Submitted2017-09-18 00:00:00
Date Available2017-09-18 00:00:00
Creation Date2017-09-13 10:26:13
Producing SoftwareAdobe Acrobat 11.0 Image Conversion Plug-in
Document Lastmod2017-09-13 10:26:17
Document TitleUsers Manual
Document CreatorAdobe Acrobat 11.0

INSTRUCTION
CHARGER I NOT CHARGER
”mm“ . m svnaai- I
J trim-Mi “b tinciudeol
inflow}
Remote Control
x2
: 6E7? 4» i:
Bumper Car
x2
(1) Use the tool to loosen the screw on the back cover ot the battery
oompartinent in anticlockwise direction
(2) ZPCS tbv AA batteries and 3 av battery pack are required (as the I
picture above shown). please make sure correct the w -. -
the l 5v battery battery
V3) close the battery cover. and then use the tool to tighten the screw on the (a) close the battery cover. and then use the tool to tighten the screw on tiny
(1) Use the tool to loosen the screw on the back cover at the battery
compartment in anticlockwise dlrectlon
(2) zpcs t 5v AA batteries and apes l 5 AAA batteries are required. tas the
polarity or picture above shown), please make sure conect the w " pdlanty ot the
back cover ot the battery compartment in clockwise direction back cover at the battery compartment in clockwise direction
Operating ste
4 Keep pressing the Backward
key at the ieIt side of the
transmitterwhiie pressing the
lettlright key on the right side,
you can control the bumper car
to turn Iefl backward or turn
right backward.
1. Load the battery in the
transmitter and bumper car.
Switch on the power at the
transmitter and the bumper
car (Pull it to ON position).
5. Strike the key at the rear
pan or the bumper car. the
player on the bumpercar
that being stricken will be
ejected out.
2 Keep pressing the
Forward/Backward key on
the lefl ot the transmitter
and you can control the
bumper car to run iorward
or backward.
6 After these 2 bumper cars being
started in the same time. please
control your bumper car to strike
your opponent's bumper car until
your opponent's player in the
bumper car being ejected out. the
party whose player in the bumper
car is not ejected out will be the
winner.
3. Keep pressing the
Forward key on the left or
the transmitter while pressing
the left/right key on the right
side‘ you can control the
bumper car to turn lett lonivard
and turn right tonivard
Caution on using the battery
1,3.6V chargeable battery pack is required in this toy car. 2PCS «5v “AA" non-chargeable batteries are required in the transmitter.
. Non-chargeable batteries are not to be charged.
,Oniy the batteries Same as the recommended ones or the same battery can be used
. Please DO NOT nilx using the old batteries with the new ones or batteries of different types.
. Battery is to be loaded as the correct w " polarity shown,
, Exhausted batteries are to be removed from this toy
. Power end is not to be short-Circuited.
Charger should be checked periodically each month. especially the electric wire. plug, outer shell and other components to see iiihese pans are
damaged or not. it any damage is round. please stop using it until it is well repaired.
PRECAUTIONS:
This product may contain small parts. Please DO NOT give it to children on or under 3 years old. This product contains electric component.
please DO NOT soak it into the water or use it under the moisten environment. This toy can not be connected to the powerguantity more
than recommended.
important lntomiation is contained in this package. please well keep it for future reterence.
ooxioauieuru
This equipment has been tested and lound to comply with the limits tor a Class a
digital device. pursuant to Part is or the Fcc Ruies These limits are designed to
pmvlde reasonable pmtecIion against hanntul interterence in a residenIlal
installation This equipment generates. uses and can radiate radio treauancv energy
and it not installed and used in accordance with the instnictions may cause hanntul
intenerence to radio communicators however. there is no guarantee that
interterence will nnt occur in a particular installatcn
ltthis equlpment does cause harmtul iniartarenca to radio or television receptlari.
which can be determined by turning the equipment cit and on the user is
encouraged to try to correct the interterence by one or more or the tollowing
measures
a Reonent or relocate the receiving antenna
W increase the separation belween the equipmenI and receiver
-» Connect the equipment into an outlet on a circuit dittarenl trcm that to which the
receiver is connected
a Consufl the dealer or an experienced radio/TV technician tor help
Warning changes at inodincations not expressiy approved oy the
party responsible tor compliance could void the user‘s authority to
operate the equipment

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Create Date                     : 2017:09:13 10:26:13+08:00
Creator                         : Adobe Acrobat 11.0
Modify Date                     : 2017:09:13 10:26:17+08:00
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2017:09:13 10:26:17+08:00
Creator Tool                    : Adobe Acrobat 11.0
Format                          : application/pdf
Document ID                     : uuid:c0f499bb-f02e-4e74-8af4-0c3e72dc7421
Instance ID                     : uuid:cde6595c-6fb6-4dce-8c92-88cf1b198951
Producer                        : Adobe Acrobat 11.0 Image Conversion Plug-in
Page Count                      : 1
EXIF Metadata provided by EXIF.tools
FCC ID Filing: ZY3-HBDP-27MHZ

Navigation menu