HYUNDAI MOBIS FOB-4F03 Remote Keyless Entry User Manual FOB 4F03 FCC IC 433 92MHz 4KEY 130115
HYUNDAI MOBIS CO., LTD. Remote Keyless Entry FOB 4F03 FCC IC 433 92MHz 4KEY 130115
User Manual
1. How to use FOB-4F03
- FOB-4F03 is a part of Remote Keyless System.
- This unit controlls door lock/unlock/panic/trunk open with wireless.
- This unit is a Transmitter.
2. Introduction of Transmitter (FOB-4F03 )
- Transmitter has four buttons
- Transmitter uses a battery
- Radio Freqency is 433.92MHz
- Modulation item is a PLL IC
- Transmitter uses a Rolling code algorithm
An outline of Transmitter
FCC Warning
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void
your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This transmitter must not be collocated or
operating in conjunction with any other antenna or transmitter unless authorized to do so by the FCC.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le
brouillage est susceptible d'en compromettre le fonctionnement.