HYUNDAI MOBIS SMK-4E07 Smart Key ECU User Manual

HYUNDAI MOBIS CO., LTD. Smart Key ECU

User Manual

1. GENERAL DISCRIPTIONIf the button of door handle or SSB button is pressed, SMART KEY ECU output the LF(125kHz) signal.1) LF signal output for engine start SSB button is pressed, SMART KEY ECU output LF signal through the interior LF antenna2) LF signal output for door lock/unlock and trunk release The button of door handle or trunk is pressed, SMART KEY ECU output LF signal thtough the exterior LF antenna for Fob searching2. ELECTRICAL CHARACTERISTICSDescription of SMART KEY ECUOperating voltage9V ~ 16VSMART KEY ECUmodel namefor Fob searching.Dark current5mA Max.ModulationASKOperating temperature-30℃ ~ +75℃Operating frequency125KHz
FCC WarningThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or more of the following measures:■Reorient or relocate the receiving antenna.■Increase the separation between the equipment and receiver.■Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.■Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or modifications to this device not explicitly approved by manufacturer could voidyour authority to operate this equipment.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation.IC Warning"This device complies with Industry Canada licence-exempt RSS standard(s)."Operation is subject to the following conditions: (1) this device may not cause interference, and (2) this device mustaccept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas provoquer de brouillage, et (2)l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'encompromettre le fonctionnement.

Navigation menu