Hangzhou H3C Technologies EWPA1PCIGA Wireless mini PCI Card User Manual EWPA1PCIGA
Hangzhou H3C Technologies Co., Ltd Wireless mini PCI Card EWPA1PCIGA
User Manual
EWPA1PCIAA User Manual
Hangzhou H3C Technologies Co., Ltd.
Hangzhou H3C Technologies Co., Ltd.
2008-12-12 版权所有，未经许可，请勿复制 2
Content
1 FCC STATEMENT 3
2 PRODUCT INTRODUCTION 4
Hangzhou H3C Technologies Co., Ltd.
2008-12-12 版权所有，未经许可，请勿复制 3
EWPA1PCIGA User Manual
1 FCC Statement
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to
channels 1 through 11.
To comply with FCC RF exposure compliance requirements, a separation distance of at least
20 cm must be maintained between the antenna of this device and all persons.
This Transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter This device is intended only for OEM integrators under the following
conditions:
The antenna must be installed such that 20 cm is maintained between the antenna and users.
For laptop installations, the antenna must be installed to ensure that the proper spacing is
Hangzhou H3C Technologies Co., Ltd.
2008-12-12 版权所有，未经许可，请勿复制 4
maintained in the event the users places the device in their lap during use (i.e. positioning of
antennas must be placed in the upper portion of the LCD panel only to ensure 20 cm will be
maintained if the user places the device in their lap for use) and The transmitter module may
not be co-located with any other transmitter or antenna. As long as the 2 conditions above are
met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the final product.
In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for example
access points, routers, wireless ASDL modems, certain laptop configurations, and similar
equipment). The final end product must be labeled in a visible area with the following:
"Contains TX FCC ID:U6I-EWPA1PICGA ".
RF Exposure Manual Information That Must be Included
The users manual for end users must include the following information in a prominent
location
NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter."
Additional Information That Must be Provided to OEM Integrators
The end user should NOT be provided any instructions on how to remove or install the device.
Service Center in U.S.A
Company Name : H3C USA Co., Ltd
Company Address: 2301 N. Greenville Ave Suite 200, Richardson, Texas, USA 75082
2 Product Introduction
802.11b/g Wireless MiniPCI Card is the perfect solution for your wireless network applications
Hangzhou H3C Technologies Co., Ltd.
2008-12-12 版权所有，未经许可，请勿复制 5
based on the IEEE 802.11g standard offering a data rate of 54Mbps in a wireless LAN
environment. EWPA1PCIGA is designed for Access Point, Router, you wireless access the web
and network resource without the wire.
EWPA1PCIGA provides high-speed access to network resources and has built-in 40/64-bit,
and 128 bit of WEP (Wired Equivalent Privacy) data encryption. With Direct Spread Spectrum
Signaling (DSSS) and Orthogonal Frequency Division Multiplexing (OFDM), domain access
control, WEP encryption and group security, the modules will safeguard all your wireless data
transmissions from your nosy neighbors.
EWPA1PCIGA allows you to take full advantage of your devices mobility with access to
real-time information and online services anytime and anywhere.
2. Feature
. Complies with IEEE 802.11b/g Standard for 2.4GHz Wireless LAN.
. Works with All Existing Network Infrastructures.
. Compatible with Wi-Fi Wireless Products and Services
. Capable of up to 128-Bit WEP Encryption.
. Freedom to Roam While staying Connected
. 54 Mbps High-Speed Transfer Rate
. Two UF-L Connectors for External Antenna
. Support Antenna diversity for Better Sensitivity
. Lower Power Consumption.