Hansong 56AIRDOCK Wi-Fi Speaker User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2168355
Application ID	qzOja2KEvZ0vepkNh4XQUA==
Document Description	XCO-56AIRDOCK_User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	14.71kB (183890 bits)
Date Submitted	2014-01-16 00:00:00
Date Available	2014-01-22 00:00:00
Creation Date	2013-02-07 14:47:51
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2013-12-11 10:14:20
Document Title	Microsoft Word - User Manual.doc
Document Creator	PScript5.dll Version 5.2.2
Document Author:	hp0282

Aiplay Unit User Manual
LED status and Description
LED Color
Description
Solid Red
The unit is in power off state. No Audio can be played.
Blinking Blue
When the power button is pressed the led will blink.
This indicates that the system is starting.
Solid Blue
This indicates that the system has connected with
WI-FI router.
Solid Purple
The system will get into power save mode if there is no
operation on it ,and LED will become solid purple
LED Color
Description
Solid Green
When the adaptor is plugged in and the unit is in
charging mode.
Blinking Green
There is something wrong in charging process
Button Controls
Button
Description
Vol+
Volume up
Vol-
Volume down
Power
Power on the unit
WPS
Connect with WI-FI
SOURCE
Change Audio Source
Battery Off
disconnect with battery
Power Button
·The system can be turn on and off by “Power” button in short press
Volume Button
·The system has two volume buttons located on the left side. Volume up
is labled “Vol+” volume down is labled”Vol-“.
WPS Button
·shrot Press: If your home or office network router has a WPS button
then pressing this button allows you to authenticate onto your network
without entering any password/pass key information.
Source Button
·. If you plug in aux cable and play back, and now unit in airplay mode,
Press the Source button on side of the unit it can change to MP3 mode .
Battery off
·. If software crashes, firstly pull out the adaptor, then you should stab
the key with pointed things for more than 3 seconds, later you can
power on it again.
WI-FI Connection Method
① WPS network setup
·Press the Power button on the side of the unit
·The indicator light above the “Vol-“ button will flash rapidly to indicate
that the unit is starting up . When the indicator light starts to flash
slowly move on to the next step
·Follow the instructions on your WPS enable network router and start the
WPS pairing function.
·Press the WPS button on side of the unit. The indicator will repeatedly
flash red ,blue and purple to indicate that the WPS pairing has started.
·When the process is completed the WPS indicator will illuminate solid
blue to indicate that the unit has successfully connected to your
network.
·You are know ready to use the Airplay
② Log share network setup
·Press the Power button on the side of the unit
·The indicator light above the “Vol-“ button will flash rapidly to indicate
that the unit is starting up . When the indicator light starts to flash
slowly move on to the next step.
·Plug in the Ipad or Iphone by Docket or USB, Press WPS button short,
and then you should see a popup window means that do you want to
share the wi-fi setup and let the accessories access the wi-fi network.
Then you should press “Apply” button and the unit has successfully
connected to your network.
③ JB direct connect setup
·Press the Power button on the side of the unit
·Press the WPS button until the led blinking rapidly.
·Turn on the WIFI from your apple device,and you will find the unit
name.Connect it and you can playback the music by airplay unit.
Audio playback function setup
① MP3 playback setup
·Press the Power button on the side of the unit
·The indicator light above the Vol- button will flash rapidly to indicate
that the unit is starting up . When the indicator light starts to flash
slowly ,put 3.5 mm headphone plug to MP3 socket, after a few seconds
audio should be heard from the unit
② Docket playback setup
·Press the Power button on the side of the unit
·The indicator light above the Vol- button will flash rapidly to indicate
that the unit is starting up . When the indicator light starts to flash
slowly ,put ipad or iphone plug to the docket, and then play the ipod
music you can listen to the music.
③ Airplay playback setup
·Press the Power button on the side of the unit
·The indicator light above the Vol- button will flash rapidly to indicate
that the unit is starting up . When the indicator light starts to flash
slowly move on to the next step
·Connect the unit to network following the above method
·After unit connected with the network and connect the ipad or iphone as
well, you will found the unit in ipod window and select the unit name
“56°Air“ playback the music and you will hear it .
Caution:
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de
brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente
(p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication
satisfaisante.
MPE Reminding
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or
more should be maintained between the antenna of this device and persons during
device operation.
To ensure compliance, operations at closer than this distance is not recommended.
Les antennes installées doivent être situées de facon à ce que la population ne puisse
y être exposée à une distance de moin de 20 cm. Installer les antennes de facon à ce
que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’
antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout temps éloigné d’au
moins 20 cm des personnes pendant son functionnement.
Only for detachable antennas:
This radio transmitter (identify the device by certification number, or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for
each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Gain of antenna: 1.5dBi max.
Type of antenna: Omni-directional
Impedance of antenna: 50ohm
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou
son numéro de modèle s'il fait partie du matériel de catégorie I) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et
ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain
maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
Gain d'antenne: 1.5dBi maximal
Type d'antenne: 50 ohm, Omni-directionnel

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Author                          : hp0282
Create Date                     : 2013:02:07 14:47:51+08:00
Modify Date                     : 2013:12:11 10:14:20+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Format                          : application/pdf
Creator                         : hp0282
Title                           : Microsoft Word - User Manual.doc
Creator Tool                    : PScript5.dll Version 5.2.2
Metadata Date                   : 2013:12:11 10:14:20+08:00
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Document ID                     : uuid:a7daa4aa-fd84-436b-bf61-a67374fee81b
Instance ID                     : uuid:3571cbe5-ef07-433b-b100-a84516dddce9
Page Count                      : 8

EXIF Metadata provided by EXIF.tools