Hanwha Techwin SEW3041W Wireless Baby Monitor User Manual Part 1

Download:
Mirror Download [FCC.gov]
Document ID	2294792
Application ID	Ec7IkRVb0G+yHQ4JgS9zZA==
Document Description	User Manual Part 1
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	97.74kB (1221720 bits)
Date Submitted	2014-06-13 00:00:00
Date Available	2014-06-13 00:00:00
Creation Date	2014-05-27 13:48:56
Producing Software	Adobe PDF Library 9.9
Document Lastmod	2014-06-13 16:31:30
Document Title	User Manual Part 1
Document Creator	Adobe InDesign CS5.5 (7.5)

FCC TEST REPORT
Report No.: EMC-FCC-R0163
http://www.emc2000.co.kr
User Manual
EMC compliance Ltd.
65, Sinwon-ro, Yeongtong-gu, Suwon-si, Gyeonggi-do, 443-390, Korea
82-31-336-9919 (Main) 82-505-299-8311 (Fax)
This test report shall not be reproduced, except in full, Without the written approval.
BrilliantVIEW
User Manual
SEW-3041W
English
IMPORTANT SAFETY INSTRUCTIONS
1.
Read these instructions.
3.
Heed all warnings.
2.
4.
5.
6.
7.
BrilliantVIEW
User Manual
Copyright
©2014 Samsung Techwin Co., Ltd. All rights reserved.
Trademark
is the registered logo of Samsung Techwin Co., Ltd.
The name of this product is the registered trademark of Samsung Techwin Co., Ltd.
Other trademarks mentioned in this manual are the registered trademark of their
respective company.
Restriction
Samsung Techwin Co., Ltd shall reserve the copyright of this document. Under no
circumstances, this document shall be reproduced, distributed or changed, partially or
wholly, without formal authorization of Samsung Techwin.
Disclaimer
Samsung Techwin makes the best to verify the integrity and correctness of the contents
in this document, but no formal guarantee shall be provided. Use of this document
and the subsequent results shall be entirely on the user’s own responsibility. Samsung
Techwin reserves the right to change the contents of this document without prior notice.
8.
9.
Keep these instructions.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings, Install in accordance with the manufacturer’s
instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/ accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lighting storms or when unused for
long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
SPECIFY SERVICE INSTRUCTIONS AND WARRANTY
TERMS
FCC Caution :
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions :
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note :
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and monitor.
• Connect the equipment into an outlet on a circuit different from that to which the monitor is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
• STRANGULATION HAZARD - Keep cord out of child's reach. NEVER place camera or cords
within 3 feet of crib or playpen. Never use extension cords with AC Adapters. Only use the AC
Adapters provided.
• Some adult assembly or installation required.
• This product contains small parts that may cause choking. Keep small parts away from children.
• This product is NOT intended to replace proper supervision of children. You MUST check your
child’s activity regularly, as this product will not alert parents to silent activities of a child.
• Before using this product, read and follow all instructions contained in this booklet, and read and
follow all instructions and warnings on the product.
• NEVER use the transmitter or monitor near water, including near a bathtub, sink, laundry tub, wet
basement, etc.
• This product is intended for indoor use only.
• This product is not intended for use as a medical monitor and its use should not replace adult
supervision.
• The transmitter detects normal sound levels within a range of 2 to 3 meters (6 to 10 feet) from a
child. If the child moves outside of this range, if may not be able to detect sounds from him or her.
• It is essential that you check the operating range and condition of the transmitter monitor on initial
installation, and on a regular basis after that.
• Check reception regularly. Test monitor before use and after changing camera location.
The wireless signal transfer range may be shortened if an obstacle such as a
concrete wall is in between the camera and monitor.
• To prevent overheating, keep the product and AC power adapters away from any direct sunlight
and heat sources such as radiators, heat registers, cooking devices (e.g., stoves and ovens) and
other appliances that produce heat (e.g., amplifiers, televisions and stereos).
• Ensure that the product is well ventilated during use. Avoid contact with pillows and furniture that
may block ventilation.
• Use only the AC adapters provided with the product, as other adapters may damage the product.
Plug the adapters only into standard household current (100~240 volts AC).
Place the AC adapters avoiding pinch points otherwise you can damage the adapters.
• When an AC adapter is plugged into a power source, DO NOT touch the exposed end of the AC
adapter’s cord.
• Do not use extension cords with the AC power adapters to avoid entanglement.
• This product should only be serviced by qualified and authorized Samsung service centers.
• Images and sounds are transmitted by the product over public airwaves and transmissions may
be picked up by other units.
• Caution if you use the system to watch a young child, do not place the camera where the child
can reach.
• When using the system with only battery power and the charge is low, then the picture and or
sound may affected.
• If this occurs then please connect the AC power adapter.
• This appliance and its antenna must not be co-located or operation in conjunction with any other
antenna or transmitter. A minimum separation distance of 20 ㎝ must be maintained between the
antenna and the person for this appliance to satisfy the RF exposure requirements.
• When device is operating, please use the device at the flat place and do not carry in person pocket.
This device must be use at least 20 ㎝ away and The MIC sensitivity is also fine at the distance longer
.than 20 ㎝.
Contents
What’s Included
Package Contents…………………………………………………… 5
Getting Started
Functional Description………………………………………………… 6
Powering your monitor………………………………………………………… 6
Operating the System………………………………………………………… 6
Viewing Mode Display
Indicator Description………………………………………………… 8
How to use the indicator……………………………………………………… 8
Menu Operation……………………………………………………… 8
How to use the setup buttons………………………………………………… 8
How to use the setup icon…………………………………………………… 9
Overview
Getting to know your Monitoring system………………………… 10
Wireless Monitor……………………………………………………………… 10
Wireless Camera……………………………………………………………… 12
Installation
How to Install………………………………………………………… 13
Wireless Monitor……………………………………………………………… 13
Wireless Camera……………………………………………………………… 13
Appendix
Specifications……………………………………………………… 14
Troubleshooting…………………………………………………… 15
01
What’s Included
What’s Included
Package Contents
The system comes with the following components:
Wireless camera
Wireless monitor
User Manual & Warranty Card
Camera Adapter
Monitor Adapter
Plastic anchor (1EA) & Screw (1EA)
Check your package to confirm that you have received the complete system, including all components shown above.
English · 5
Getting Started
Functional Description
Powering your monitor
After opening the box, fully charge the monitor before use. After initial charge, recharge
as needed.
Wireless Monitor
You can use the device while charging with connected adapter, and the device is
portable if charged.
Wireless Camera
The Wireless Camera must be plugged in at all times in order to view.
nn `` Check if the Power LEDs of wireless monitor is turned on.
6 · Getting Started
Operating the System
The basic operation is as follows:
Pairing
The units already come paired for your convenience. This button is
used to add an additional camera. User can select camera number
to assign. Up to 4 Cameras may be paired.
1.
Power on and turn the switch ON.
The power LED for the monitor should be ON.
2.
Press the [MENU] button on the monitor.
3.
Select [
4.
Select camera number by pressing the [$] or [%] button. Press [
] button to
confirm.
A pairing icon comes out and search a camera which sets to pairing mode.
A count down clock appears at the middle of top icon bar which starts counting
from 30 to 0.
5.
Press the [PAIR] button on the camera.
6.
Within 30 seconds, if the monitor successfully pairs with the camera, the monitor
will automatically switch to the camera's current view.
] by pressing [_] or [+] button.
30 seconds, if no camera registered, it will show “Out of Range” icon and user
nn `` After
needs to switch back to previous camera number through menu operation.
Voice activated (VOX)
Sound level
The louder the sound around the camera, the more LEDs turn on.
02
Select to monitor significant sound with reduced ambient noise.
The screen goes off in “VOX” mode if there is no significant sound
louder than a certain level within 1 minute. Meanwhile, the monitor
screen turns on as soon as detecting sound around the camera. In
“VOX” mode, you can set the sensitivity with [
] in menu.
Night Light
Camera/Sleep
1.
Press camera icon once to go to the next camera.
2.
Press and hold for 3 seconds to turn on the sleep mode. Your
monitor will continue to detect sound around the camera. Press
any button to turn the screen on again.
If camera is disconnected, monitor screen would be turned on
automatically in Sleep mode.
Out of Range
If the camera and monitor are not paired or if the monitor is outside
of transmission range with the paired camera, the “Out of Range”
message appears with warning beeps at regular intervals.
SEW-3036W
Press the [
] button on the camera or
press and hold the [
] button for 3 seconds on
the monitor to remotely activate or deactivate the
night light on the camera.
Getting Started
• H(High) : Sets to higher sensitivity.
• L(Low) : Sets to lower sensitivity.
DC IN 6V
[Camera]
[Monitor]
Remote PTZ and Zoom
You can remotely control the camera to pan, tilt and digital zoom.
Use [$/%/_/+] buttons on the wireless monitor to control the camera.
Use [
] button to zoom in and out.
Two-way talk
■■■■■■■■■■■
■■■■■■■■■■■ㅇㅀㄴㅇㅀㄴㄻㅇㄹ
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■■■■■■■■■■■
■■■■■■■■■■■
Press■■■■■■■■■■■
the [TALK] button while talking.
■■■■■■■■■■■
■■■■■■■■■■■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
English · 7

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Create Date                     : 2014:05:27 13:48:56+09:00
Creator                         : Adobe InDesign CS5.5 (7.5)
Modify Date                     : 2014:06:13 16:31:30+09:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Metadata Date                   : 2014:06:13 16:31:30+09:00
Creator Tool                    : Adobe InDesign CS5.5 (7.5)
Format                          : application/pdf
Document ID                     : uuid:e9ae8c67-b763-4aa7-8093-7eddec6d3e0c
Instance ID                     : uuid:65377bf7-f8dc-481f-a5b7-51be806a0c1f
Producer                        : Adobe PDF Library 9.9
Page Count                      : 8

EXIF Metadata provided by EXIF.tools