Hanwha Techwin SNC79440BWN DIGITAL COLOR CAMERA User Manual

Hanwha Techwin Co., Ltd. DIGITAL COLOR CAMERA

User manual

SNC-79440BWNDigital Color CameraUser ManualCAUTION : Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense.
Copyright ©2017 Hanwha Techwin Co., Ltd. All rights reserved.TrademarkEach of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are the registered trademark of their respective company.RestrictionCopyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or changed, partially or wholly, without formal authorization. DisclaimerHanwha Techwin makes the best to verify the integrity and correctness of the contents in this document, but no formal guarantee shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own responsibility. Hanwha Techwin reserves the right to change the contents of this document without prior notice. Design and specications are subject to change without prior notice.User Manual
part names and functionsEquipped with the IR LED lights and the illumination sensor, the camera enables you to monitor at all times, day and night. The camera is suitable for both indoor and ourtdoor use.Do not fully expose the camera to rain. The camera must be installed under a shelter to avoid exposure to excessive rain or moisture.Name DescriptionaLens 3.6mm focal length enables you to monitor at a wider field of viewbIR LED Infrared LED lights are controlled by the illumination sensor.cIllumination Sensor Detects incoming light to control the IR LED.dPairing Button Click to do pairing manually.ePower Cable Use to power the camera.English _3d eabc
precautionsEnsure you read out the following instructions before installing the camera:•Select an area (ceiling or wall) that can withstand 5 times the camera weight•Stuck-in or peeled-off cables can cause damage to the product or a fire.•For safety purposes, keep anyone else away from the installation site. And put aside personal belongings from the site, just in case.installing the cameraThe camera can be installed on the wall, ceiling, shelf or a desired position using the provided mounting bracket.1. Choose an installation site that can sufficiently support the weight of the camera to be installed.2. Adhere the installation template onto the ceiling and use it as installation locating tool. "Please refer to Page15 (Quick Guide)"3. Attach the camera mount to the wall using the supplied screws.4. Adjust the direction of the camera to the desired direction, and tighten the bracket.5. Adjust camera angle as needed.6. Connect the camera cable to the camera. Take caution when installing the camera outdoors because the cable connectors may be wet with moisture or pile up with impurities. Although the camera is IP66 rated, direct exposure to water or moisture may cause problem such as condensation.English _4CAMERA FRONTScrew holes for the Camera installation
protection of cable from WaterIf this product is mounted outdoor, water leakage may occur at gap between cables. As shown below, butyl rubber (available on the market) shall be used to protect from water.1. Connect power supply and BNC power source.2. Cover black sheath of the cable (Zone A), and ensure half of butyl rubber can cover the cable joint. J `Poor water protection at the cable sheath may cause water leakage. Make sure to wrap tightly. `The water-proof butyl rubber is made of rubber that expands to twice the original length. `If you do not use cable joint, it must be covered with water-proof tape.connecting the nVrUse a 12V 0.5A power adpator to power each wireless camera. There is no need to connect cameras to NVR as it is wireless AIO.HDMIVGA 12VCAUTIONRISK OF ELECTRI SHOCKDO NOT OPENCAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK DO NOT OPEN COVERS. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE UNITS NOT SPECIFICALLY DESIGNED FOR OUTDOOR USE TO RAIN OR MOISTURE.WANEnglish _5
specificationscamera model: snc-79440bWnItem DetailsVideoImaging Device 2M CMOS (1/2.9")Effective Pixels 1,920(H)x1,080(v) Scanning System ProgressiveSynchronization InternalHorizontal Resolution 1080PMin. Illumination 0 Lux (IR LED ON)Camera Output RJ45LensFocal Length 3.6mmMax. Aperture Ratio F2.1Angular Field of ViewDiagonal : 105°OperationalShutter Mode AutoGain Control AutoWhite Balance AutoWide Dynamic Range D-WDRContrast Enhancement AutoDigital Noise Reduction 3DNRFlickerless Manual(50Hz/60Hz optional)Day & Night TRUE D/N, AutoIR Distance 82ft(Total Darkness)/130ft(Ambient Lighting)EnvironmentalOperating Temperature / Humidity -30°C ~ +50°C (-22°F ~ +122°F) / Less than 90% RH ※ Startup : -10°C ~ +50°CIngress Protection IP66English _6
Item DetailsElectricalInput Voltage 12V/500mA DC AdaptorPower Consumption 5.4W(IR LEDS ON)Mechanical / Package informationColor / Material White / MetalDimension (Ø x D) Ø69.3 x D147.2mm (2.73" x 5.79")Weight 0.34kg prox.AccessoryPrinted material Quick guideBracket one body (assembled)Screw 3 EA (per camera)Anchor 3 EA (per camera)Hex key 1 EA (per camera)Power Adaptor 12V 0.5A 1 EA (per camera)Cable (65ft ) 4EA 65ft power CableEnglish _7
dimensioncameraUnit: mm (inch)English _8134.5 (5.30")77.6 (3.06")147.2 (5.80")117.3 (4.62")117.3 (4.62")Ø69.30 (2.73")87.47 (3.44")Ø6 (0.24")Ø54.2 (2.13")Ø69.30 (2.73")3-Ø3.60 (0.12"-0.14")
FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.
Industry Canada Statement This device complies with RSS-247 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-247 d’Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Industry Canada Radiation Exposure Statement This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Déclaration d’exposition aux radiations Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non con trôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. Antennas Statement This radio transmitter (identify the device by certification number or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Le present emetteur radio (identifier le dispositif par son numero de certification ou son numero de modele s'il fait partie du materiel de categorie II) a ete approuve par Industrie Canada pour fonctionner avec les types d'antenne enumeres ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est superieur au gain maximal indique, sont strictement interdits pour l'exploitation de l'emetteur. Antenna List No. Model Type Gain[dBi] Impedance 1 YH2400-SMAJ-108 Dipole antenna (Reversed SMA Jack type) 1.87 50
English _9Correct Disposal of This Product (Waste Electrical & Electronic Equipment)(Applicable in the European Union and other European countries with separate collection systems)This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with other household waste at the end of their working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate these items from other types of waste and recycle them responsibly to promote the sustainable reuse of material resources.Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take these items for environmentally safe recycling.Business users should contact their supplier and check the terms and conditions of the purchase contract. This product and its electronic accessories should not be mixed with other commercial wastes for disposal.Hanwha Techwin cares for the environment at all product manufacturing stages, and is taking measures to provide customers with more environmentally friendly products. The Eco mark represents Hanwha Techwin's devotion to creating environmentally friendly products, and indicates that the product satisfies the EU RoHS Directive. Correct disposal of batteries in this product(Applicable in the European Union and other European countries with separate battery return systems.)This marking on the battery, manual or packaging indicates that the batteries in this product should not be disposed of with other household waste at the end of their working life. Where marked, the chemical symbols Hg, Cd or Pb indicate that the battery contains mercury, cadmium or lead above the reference levels in EC Directive 2006/66. If batteries are not properly disposed of, these substances can cause harm to human health or the environment. To protect natural resources and to promote material reuse, please separate batteries from other types of waste and recycle them through your local, free battery return system.
Head Oce6, Pangyo-ro 319 beon-gil, Bundang-gu, Seongnam-si,Gyeonggi-do, 463-400 Rep. of KOREATel : +82.70.7147.8753 Fax : +82.31.8018.3740www.hanwha-security.comHanwha Techwin America500 Frank W. Burr Blvd. Suite 43 Teaneck, NJ 07666Toll Free +1.877.213.1222 Direct +1.201.325.6920 Fax +1.201.373.0124www.hanwha-security.comHanwha Techwin EuropeHeriot House, Heriot Road, Chertsey, Surrey, KT16 9DT, United KingdomTel +44.1932.57.8100 Fax +44.1932.57.8101www.hanwha-security.eu

Navigation menu