Harbor Freight Swivel Handle For Wooden Dolly Product Manual 94354

Manual for the 94354 Swivel Handle for Wooden Dolly 94354 Swivel Handle for Wooden Dolly

: Harbor-Freight Harbor-Freight-Swivel-Handle-For-Wooden-Dolly-Product-Manual-724219 harbor-freight-swivel-handle-for-wooden-dolly-product-manual-724219 harbor-freight pdf

Open the PDF directly: View PDF .
Page Count: 2

Swivel Handle For Wooden Dolly

Copyright © 2006 by Harbor Freight Tools. All rights reserved. No portion of this manual or any

artwork contained herein may be reproduced in any shape or form without the express written

consent of Harbor Freight Tools.

For technical questions please call 1-800-444-3353

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web site at: http://www.harborfreight.com

94354

660 Lb. Towing Ability

( Works with Harbor Freight Tools SKU # 92486, 93888 and 38970 Furniture Dollys)

ASSEMBLY & OPERATING INSTRUCTIONS

1. Read and fully understand this instruction sheet before using the Handle.

2. The maximum towing capacity is 660 LBS. Do not exceed this limit.

3. Always wear ANSI-approved safety goggles when working with tools and equipment.

4. Always keep arms, feet, legs, etc. out from under the furniture dolly. Children should

always be kept at a safe distance. Never allow children to play with or ride on a dolly.

5. Make sure the Handle for the Wooden Dolly is securely connected to the furniture dolly

before attempting to move any furniture.

6. The furniture dolly should only be used on a flat and level surface. Make sure the load is

evenly distributed on the furniture dolly before moving it.

SKU 94354 Page 2

ASSEMBLY & OPERATING INSTRUCTIONS

Figure 1

The Handle for Wooden Dolly is attached to a furniture dolly (not included) using the four

screws included with this product. Position the Handle in the middle of the furniture

dolly, as shown in Figure 2. Mark the placement for the screws. Use a small diameter

drill bit (one smaller than the screws) to drill four pilot holes. Use a Philips Head screw-

driver to thread the screw through the Handle and into the furniture dolly (not included), as

shown in Figure 2.

The Handle is adjustable from 27-1/2” to 38-1/4”. Remove the Adjusting Bolts, as shown in

Figure 1, and move the handle to the desired length. Then insert the same bolts back into

the handle and tighten them using a wrench.

Adjusting

Bolts

Figure 2

Holding Bracket

The Handle comes with a plastic Holding Bracket, as shown in Figure 2. After installing the

Handle, mark the spot for the Holding Bracket. Drill pilot holes and screw the Bracket into

the furniture dolly to secure it.

Mounting Screws