Harbor Freight T Post Lifter Product Manual 38444

: Harbor-Freight Harbor-Freight-T-Post-Lifter-Product-Manual-724130 harbor-freight-t-post-lifter-product-manual-724130 harbor-freight pdf

Open the PDF directly: View PDF .
Page Count: 3

38444

T-POST LIFTER

ASSEMBLY & OPERATING INSTRUCTIONS

Revised 03/07

THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete

the owner’s record below:

Model Serial No Purchase Date

SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire

manual to become familiar with the unit BEFORE you begin assembly.

The Operator

COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY PRODUCT.

THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR. PLEASE REMEMBER:

Do not use the product if under the influence of alcohol or drugs. Read warning labels on prescriptions to

determine if your judgment/reflexes might be impaired.

Do not wear loose clothing or jewelry as they can be caught in moving parts.

Protective gloves and non-skid footwear is recommended.

Use eye and ear protection. Always wear: ANSI-approved impact safety goggles.

Maintain proper footing and balance at all times.

Work Area

TO AVOID RISK OF PERSONAL INJURY, EQUIPMENT DAMAGE, FIRE AND SHOCK, MAKE SURE YOUR

WORK AREA IS:

Free of damp, wet or rainy conditions

Free of children (never let them handle tools or machinery)

Well-lit

Clean and uncluttered

Before Operating

Before using any tool, any part that appears damaged should be carefully checked to determine that it will

operate properly and perform its intended function.

Before using your T-Post Lifter check for damaged parts. You should also make sure all clamps, locks and

bolts are tight.

IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO NOT OPERATE THE TOOL.

#38444 Page 2

Technical Specifications

Tool Name: T-Post Lifter

SKU: 38444

Base Dimensions: 37 1/2" x 1 3/4“ x 7/64”

Base: 34“ x 1“ x 1/8“ Thick Steel Tubing

Weight: 10 Lbs.

Product Use: The T-Post Lifter lifts up used T-Posts with ease, even from hard or frozen ground.

Assembly

Step 1) Attach Handle (part #3) to Base (part #1) by inserting the Axle (part #7)

into the Base and through the holes in the Handle. Insert Cotter Pin (part # 6)

into Axle to firmly secure Handle (See Parts Diagram below).

Step 2) Line up the upper circular tube portion of U-Block (part #2) with tubing at the top

of the Handle (part #3). Insert the Shaft (part # 5) through the Washer (part # 4)and

secure with the Cotter Pin (part # 6) (See Parts Diagram below).

Operation

Making sure Base (part #1) is stable, insert T-Post into open end of U-Block (part #2). Push down on Handle

to pull up T-Post.

Parts List

Part Number Description Quantity

1 Base 1

2 U - Block 1

3 Handle 1

4 Washer 1

5 Shaft 1

6 Cotter Pin 2

7 Axle 1

#38444 Page 3