Harman SOUNDSTWIGG Speaker system User Manual TempConfidential SafetySheet

Download:
Mirror Download [FCC.gov]
Document ID	1707655
Application ID	rpO0rE1Q+QYqcrw5OHACLQ==
Document Description	TempConfidential_SafetySheet
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	80.84kB (1010511 bits)
Date Submitted	2012-05-26 00:00:00
Date Available	2012-07-12 00:00:00
Creation Date	2012-01-16 11:35:14
Producing Software	Adobe PDF Library 9.9
Document Lastmod	2012-05-10 09:44:52
Document Title	TempConfidential_SafetySheet
Document Creator	Adobe InDesign CS5 (7.0)

IMPORTANT SAFETY INSTRUCTIONS
For All Products:
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Do not block any ventilation openings.
Install this apparatus in accordance with
the manufacturer’s instructions.
Do not install this apparatus near any heat
sources such as radiators, heat registers,
stoves or other apparatus (including
amplifiers) that produce heat.
Do not defeat the safety purpose of
the polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding-type
plug has two blades and a third grounding
prong. The wide blade or the third prong
is provided for your safety. If the provided
plug does not fit into your outlet, consult an
electrician for replacement of the obsolete
outlet.
Protect the power cord from being walked
on or pinched, particularly at plugs,
convenience receptacles and the point
where they exit from the apparatus.
Use only attachments/accessories specified
by the manufacturer.
Use only with the cart, stand,
tripod, bracket or table
specified by the manufacturer
or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination to
avoid injury from tip-over.
Unplug this apparatus during lightning
storms or when unused for long periods
of time.
Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as when the power-supply cord or
plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, or
the apparatus has been exposed to rain or
moisture, does not operate normally or has
been dropped.
Do not expose this apparatus to dripping or
splashing, and ensure that no objects filled
with liquids, such as vases, are placed on
the apparatus.
To disconnect this apparatus from the AC
mains completely, disconnect the powersupply cord plug from the AC receptacle.
The mains plug of the power-supply cord
shall remain readily operable.
Do not expose batteries to excessive heat
such as sunshine, fire or the like.
THE LIGHTNING FLASH WITH AN ARROWHEAD
SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED “DANGEROUS
VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE
THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO
PERSONS.
and then on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•• Increase the separation between the equipment and
the receiver.
•• Connect the equipment to a different outlet so that
the equipment and receiver are on different branch
circuits.
•• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly approved
by HARMAN could void the user’s authority to operate the
equipment.
IC Statement and Warning
(Canada Only)
This Class B digital apparatus complies with Canadian
ICES-003. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
THE EXCLAMATION POINT WITHIN AN
EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE LITERATURE
ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
For Canadian Model
This Class B digital apparatus complies with
Canadian ICES-003.
Modèle pour les Canadien
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
For Products That Transmit
and Receive RF Energy:
For Products with Radio
Receivers That Can Use an
External Antenna:
FCC and IC Regulations (USA and
Canada Only)
CATV (Cable TV) or Antenna Grounding
FCC and IC Information For Users
This device complies with Part 15 of the FCC rules and
Industry Canada license-exempt RSS 210. Operation is
subject to the following two conditions: (1) This device
may not cause harmful interference; and (2) this device
must accept any interference received, including
interference that may cause undesired operation.
Radio and Television Interference
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio-frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause interference to radio or television reception,
which can be determined by turning the equipment off
If an outside antenna or cable system is connected
to this product, be certain that it is grounded so as to
provide some protection against voltage surges and static
charges. Section 810 of the National Electrical Code
(NEC), ANSI/NFPA No. 70-1984, provides information with
respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location
of antenna discharge unit, connection to grounding
electrodes and requirements of the grounding electrode.
Note to CATV System Installer:
This reminder is provided to call the CATV (cable TV)
system installer’s attention to article 820-40 of the NEC,
which provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as possible.
¶
French RSS GEN 7.1.3 statement
anuel d'utilisation des appareils radio exempts de
licence doit contenir l'énoncé qui suit, ou
l'équivalent, à un endroit bien en vue et/ou sur les
appareils : Le présent appareil est conforme aux
CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 2
Has XFA                         : No
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:f64ca276-7c83-4d63-acb4-ad87b7e0d41a
Producer                        : Adobe PDF Library 9.9
Trapped                         : False
Metadata Date                   : 2012:05:10 09:44:52+08:00
Modify Date                     : 2012:05:10 09:44:52+08:00
Creator Tool                    : Adobe InDesign CS5 (7.0)
Create Date                     : 2012:01:16 11:35:14-08:00
Page Image Page Number          : 1, 2
Page Image Format               : JPEG, JPEG
Page Image Width                : 256, 256
Page Image Height               : 256, 256
Page Image                      : (Binary data 13215 bytes, use -b option to extract), (Binary data 8406 bytes, use -b option to extract)
Instance ID                     : uuid:6184ca20-1888-466e-891f-16c1e51409ff
Document ID                     : xmp.did:E43B339F2C2068118A6DC082F34B4557
Original Document ID            : xmp.did:E43B339F2C2068118A6DC082F34B4557
Rendition Class                 : proof:pdf
History Action                  : saved, saved, saved, saved, saved
History Instance ID             : xmp.iid:E43B339F2C2068118A6DC082F34B4557, xmp.iid:E53B339F2C2068118A6DC082F34B4557, xmp.iid:E66F41F0222068118C149145DF251537, xmp.iid:DB0E311E082068118A6DA40D957B0FD2, xmp.iid:F46B1DD1082068118A6DA40D957B0FD2
History When                    : 2012:01:11 16:15:43-08:00, 2012:01:11 16:15:43-08:00, 2012:01:12 14:32:40-08:00, 2012:01:16 11:30:17-08:00, 2012:01:16 11:34:45-08:00
History Software Agent          : Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0
History Changed                 : /;/metadata, /metadata, /;/metadata, /;/metadata, /;/metadata
Doc Change Count                : 217
Format                          : application/pdf
Creator                         : Adobe InDesign CS5 (7.0)

EXIF Metadata provided by EXIF.tools