HeathCo 60WRC05TX Remote Control User Manual 598 1116 rev00

HeathCo LLC Remote Control 598 1116 rev00

Manual

DRAFT COPY© 2001 DESA International 598-1116-00Features•Eight selectable channels available, so multiple remotes can be used in thesame home.•Car visor clip included for convenience.Wireless 6-ButtonRemote ControlModel SL-6005OperationEight selectable channels allow the user to operate severalsystems at different locations in your home. If purchasingmore than one wireless control system, select differentoperating channels for each system or they will interact witheach other.1. Install alkaline 12-volt remote battery (A23 type).Remove cover from back of transmitter by pressing onit with your thumb and sliding it off as shown in Figure1. Using outline of battery chamber as a guide, alignbattery with chamber and insert battery into remote.Slide cover back onto transmitter.2. Remote Control Functions.Channel 1/2 ON: Turns ON any devices set to the samechannel as this remote control.Channel 1/2 OFF: Turns OFF any devices set to thesame channel as this remote control.Channel 1/2 DIM: Activates the DIM feature for any devices used with thisremote control that have the DIM feature built-in.ON1 2 3 4Battery CoverBatteryChannel 1, ONChannel 1, OFFChannel 2,ONChannel 2, OFFLED Indicator LightRemote Control12-Volt (A23 Type)Battery (Included)Car Visor ClipFigure 1JumpersPositiveTerminalChannel 1, DIM Channel 2, DIM
2598-1116-00DRAFT COPYCar Visor ClipThe remote control is equipped with a removable car visor clip for addedconvenience. The car visor clip may be removed to allow the remote to lie flat ontable tops or other horizontal surfaces.1. Attach car visor clip to car visor as shown in Figure 3.2. To remove car visor clip. Insert a small flat-head screw driver into slot onback of remote. Gently push portion of clip inside of remote with screwdriverwhile pulling clip out of remote from top (see Figure 4).Figure 3 Figure 4Car VisorRemoteControlVisor ClipScrewdriver
3598-1116-00DRAFT COPYChannel SettingsNote: Most installations will not require you to change any of the dipswitches on your plug-in module or remote control.The remote control communicatesby using channels that can bechanged by sliding dip switches intothe ON or OFF [on some switchesthe numbers 1 (ON) and/or 0 (OFF)are used] position on the remotecontrol. The channel is factory set;however, there are 3 switches (8selectable channels) that allow youto expand your system and preventoutside interference. Other wirelessproducts may cause interferenceand the system may not function properly. Follow the instructions below forsetting a new channel.1. Open the cases and locate dip switches on both the remote control andoutdoor module (see Figure 5).2. The remote control and outdoor module both have two positions (ON andOFF) on each of the four dip switches. Dip switches 1 through 3 are used forsetting the channel. Position 4 is not used and must remain in OFF position.3. To change the channel, slide dip switches to ON or OFF as needed. It isrecommended to only change one dip switch at a time and then check to seeif system is functioning properly. Note: Dip switches in positions 1 through3 must be in the exact same configuration on both the remote control and thedevice it is intended to operate to function properly.Dip Switches - Shownin the OFF Position(Factory Default)ON1 2 3 4ON1 2 3 4Figure 5
4598-1116-00DRAFT COPYSpecificationsRange.......................................................................... Up to 100 feet (30.5 m)Battery ..................................................................... 12-volt alkaline (A23 type)POSSIBLE CAUSE1. Device is defective. Try remote using different device.2. Signals from transmitter are being blocked, or transmitteris out of range. Check for metal objects that could blockthe signal, or reposition the transmitter.3. Weak battery in the transmitter.4. Dip switches on remote and receiver module do not match.Same as above.1. Short term power line failure.2. Another transmitter using same channel.Troubleshooting GuideIf you experience a problem, follow this guide. You may also want to visit our Website at: www.desatech.com. If the problem persists, call for assistance at 1-800-858-8501, 7:30 AM to 4:30 PM Central Time weekdays. You may also write to:DESA International, Inc.P.O. Box 90004, Bowling Green, KY 42102-9004Do not send products.Regulatory InformationThis device complies with Part 15 of the FCC Rules and RSS-210 of IndustryCanada. Operation is subject to the following two conditions: (1) this device maynot cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.The user is cautioned that changes or modifications not expressly approved bythe party responsible for regulatory compliance could void the user’s authorityto operate the equipment.SYMPTOMDevice doesnot come on.Device doesnot turn off.Device comeson randomly.
5598-1116-00DRAFT COPYYOUR HEATH®/ZENITH ONE YEAR LIMITED WARRANTYThis is a "Limited Warranty" which gives you specific legal rights. You mayalso have other rights which vary from state to state or province to province.For a period of one year from the date of purchase, any malfunction causedby factory defective parts or workmanship will be corrected at no charge toyou. Batteries are not covered. To obtain a refund or a replacement, returnthe product to the place of purchase.Not Covered - Repair service, adjustment and calibration due to misuse,abuse or negligence, light bulbs and other expendable items are not coveredby this warranty. Unauthorized service or modification of the product or ofany furnished component will void this warranty in its entirety. This warrantydoes not include reimbursement for inconvenience, installation, setup time,loss of use, or unauthorized service.This warranty covers only Heath®/Zenith assembled products and is notextended to other equipment and components that a customer uses inconjunction with our products.THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRAN-TIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY, REPRE-SENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THEPRODUCTS ARE FIT FOR ANY PARTICULAR PURPOSE OR USE, ANDSPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, ORCONSEQUENTIAL DAMAGES.REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THECUSTOMER AND THERE SHALL BE NO LIABILITY ON THE PART OFDESA FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUEN-TIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OFBUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Somestates or provinces do not allow the exclusion or limitation of incidental orconsequential damages, so the above limitation or exclusion may not applyto you. Retain receipt for warranty claims.Heath®/Zenith reserves the right to discontinue products and to change specifica-tions at any time without incurring any obligation to incorporate new features inproducts previously sold.

Navigation menu