Heiman Technology HS1GW-E-2 Smart Gateway User Manual
Shenzhen Heiman Technology Co.,Ltd. Smart Gateway Users Manual
Users Manual
yellow
red
DC5V/1A
b
4
6
5
7
Mini Gateway
gateway
(Reset)
(State)
V
After tap "+" in the gateway,
according to APP instructions, press and
hold the networking button of Zigbee device
for 2 seconds,till the green LED of device
flashes quickly,next,the green LED of the
device will keep on for 3 seconds, after that,
the device photo will be shown in APP,indicating
that device is added to gateway successfully.
Press and hold the
networking button of Zigbee device for 5
seconds,
ND
T
H
b
b
b
b
b
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate
this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
To comply with FCC RF exposure compliance requirements, this
grant is applicable to only mobile configurations. The antennas
used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or
transmitter.
FCC Warning Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful