Helicomm IPLINK1000 LOW POWER TRANSCEIVER User Manual Operation Instructions

Helicomm, Inc. LOW POWER TRANSCEIVER Operation Instructions

MANUAL

Preliminary Manual The following is the layout instructions for your IP-Link 1000. This module should be installed in the same PCB as your system. The following is the layout rules/design rules: 1. The layout should include a ground plane under the module. The size of the ground plane is 4 by 6inches. 2. The Digital Input/ Output pins should be filtered. 3. Supply pin should have filter cut off in the hundred of hertz. Pin 14 is the supply pin. 4. FFC certification on the IP-Link 1000 was done using the following antenna: Nearson C321AT-925. In order to make Certification easier use the recommended antenna. 5. IP-Link 1000 has been certified to TCB, however your responsible for the your PCB certification. The following is the operational instruction for your IP-Link 1000. 1) Install the IP-Link 1000 on your board. 2) Using your installation CD, install the Helicomm IP-Software into you computer. 3) Apply power to your module. 4) Down load the firmware into the IP-Link 1000 module. "This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation."

Navigation menu