Heui Xint Technology M17 Bluetooth Speaker User Manual
Shenzhen Heui Xint Technology Co., Ltd Bluetooth Speaker
User Manual
Shenzhen Heui Xint Technology Co.,Ltd
Address: 6/F ,Building 2,Hengchangrong High Tech Industrial Park,
No.128 East Road,Shangnan,Shajing Street,Baoan
District,Shenzhen
Tel : 0755-29784940 29784553
Fax : 0755-29784376
http://www.heuixint.com
Bluetooth Speaker
User Manual
MIC
W(68+68)×H100mm
1. Last song / decrease volume
2. Next song / increase volume
3. Pick up phone / Pause / Play
4. Microphone / Indicator light
1. Speaker
2. Audio Cable
3. Micro USB Cable
4.
3
●
●
1. Bluetooth
Turn on the speaker will enter the Bluetooth mode, make sure your mobile
phone has its Bluetooth turned on and search for devices, wait your mobile
phone finds "STREETZ CM718-19", your devices would now be connected
to your mobile phone.
User Manual
4
3. Micro usb charge
Micro usb cable connect the PC usb jack for charging. indicator light is red
color,finish charging, indicator light off.
Product Parameters
Power
Effective power
Freq uency response
Impedance
SNR
Distortion
Transmission distance
Charging Interface
Dimension
Charging time
3.7V, 500MAH Lithium Battery
≤3W×2
60Hz—20KHz
3Ω3W x2
80dB
THD<1%
10M
Micro USB 5V
W180*D40*H78mm
3H
2. Aux in
Attached 3.5mm audio cable, connect with
1
2
5. ON / OFF
6. Micro usb Slot
7. Aux in
PC、MP3/MP4、IPOD/iphone.
6 7
Bluetooth versio BK 2.0+EDR
Charging indictor Red
Full charging Indicator off
MIC
W(68+68)×H100mm
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.