Hi G Tek IGSA125 DataSeal-125 User Manual DataSeal 125

Hi-G-Tek Ltd DataSeal-125 DataSeal 125

Users Manual

Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology 1DataSeal-125 Installationstep 1.Fig. 1Fig. 3To install the DataSeal-125 Mounting Fixture, attachthe fixture to the keeper bar at the back of the container (fig.1). A click indicates that thefixture is in place. Fig. 20To install the DataSeal-125, hold the unit at a 45 angle as illustrated and snap it into place in itscradle on the DataSeal Mounting Fixture. (fig. 3)step 2. DataSeal InstallationThe two side slots may be used to secure the mounting fixture to the container, using a 3-5mm width by 180-250 mm length plastic strap (fig 2).
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology 2DataSeal-125 InstallationFig. 5 To connect the DataSeal Wire, simply attachone end of the seal wire conectors to either ofthe sockets at the base of the DataSeal (fig 4).Fig. 4 Loop the wire through the container locking ringand the keeper bar, then insert the end intothe other socket (fig. 5).step 3.Fig. 6 Alternatively, you may loop the wire through both keeper bars then insert the end into the other socket (fig. 6).
DataSeal-125 InstallationHi-G-Tek Ltd. Microelectronics & Asset Tracking Technology 3FCC ID: OB6-IGSA125This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:-Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-Consult the dealer or an experienced radio/TV technician for help.Changes or modifications to this equipment not expressly approved by Hi-G-Tek Ltd. could void the user's authority to operate the equipment.

Navigation menu