Hisense Broand Multimedia Technologies 002 Gigabit-Capable Passive Optical Network Single Family Unit User Manual

Hisense Broadband Multimedia Technologies Co.,Ltd Gigabit-Capable Passive Optical Network Single Family Unit

R66002_User manual

2600 N. Central Expressway Suite 950Richardson, TX 75080© Copyright 2014, iPhotonix UPS port USB port port port the production line. All products for North America the channels 12 & 13.the factory. Customers have no way to choosewere programmed with the correct Channels atsoftware and was done before the product came offchannel 1-11. This channel limit can be only set byPage 6214-575-9300 Page 1Page 7FCC Notice -1This device complies with part 15 of the FCCRules. Operation is subject to the following twoconditions: (1) This device may not cause harm-ful interference, and (2) this device must acceptany interference received, including interferencethat may cause undesired operation.This equipment has been tested and found tocomply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonableprotection against harmful interference in a resi-dential installation. This equipment generates,uses and can radiate radio frequency energy, andif not installed and used in accordance with theinstructions, may cause harmful interference toradio communications. However, there is noguarantee that interference will not occur in aparticular installation.If this equipment does cause harmful interferenceto radio or television reception, which can bedetermined by turning the equipment OFF andON, the user is encouraged to try to correct theinterference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna• Increase the separation between the equip-ment and receiver• Connect the equipment to an outlet on a cir-cuit different from that to which the receiver is connected• Consult the dealer or an experienced radio/TV technician for helpThe manufacturer is not responsible for any radioor TV interference caused by unauthorized modi-fications to this equipment. Such modificationscould void the user’s authority to operate theequipment.FCC RF Safety Caution StatementTo satisfy FCC RF exposure requirement formobile and base station transmission devices, aseparation distance of 20cm or more should bemaintained between the antenna of this deviceand persons during operation. To ensure compli-ance, operation at closer than this distance is notrecommended. The antenna(s) used for this trans-mitter must not be co-located or operating in con-junction with any other antenna or transmitter.GPON SFU ONTQuick Install GuideFCC Notice -2This device is intended to be attached to a receiverthat is not used to receive over-the-air broadcast sig-nals. Connection of this device in any other fashionmay cause harmful interference to radio communica-tions and is in violation of the FCC Rules, part 15.The 72xxG North America edition is limited usingOVERVIEWThe 72xx SFU residential ONT delivers highquality VoIP voice service, Ethernet data servicefor high-speed internet access and IPTV broad-cast video plus video on demand services. Theyprovide the following user features: (see ModelList for exact features)– 2 POTS ports - voice telephone service – 2 LAN ports - Ethernet connectivity– WiFi - WiFi connectivity– CATV -– - data backups service– - UPS serviceINSTALLATIONThe 72xx SFU ONT can be mounted vertically orhorizontally on any flat surface.UnpackUnpack the unit and verify that it is free fromshipping damage.:Desk Mount1.) Set the unit on a flat surface considering thefollowing:– within reach of the power source– no thermal obstructions– not in direct sunlight– user ability to monitor/operate the unitWall Mount1.) Use wall anchors or wood screws (if mountingto plywood mounted on a wall), spaced 5.709”apart center to center for horizontal mounting or3.543” apart center to center for vertical mount-ing. CATV, Return and HPNA servicesModel ListModel Functions Select2POTS+2GE+HPNA+CATV+Return+WiFi7269G2POTS+2GE+HPNA+CATV+WiFi7268G2POTS+2GE+HPNA+CATV+Return7267G2POTS+2GE+HPNA+CATV7263G2POTS+2GE+HPNA+WiFi7262G2POTS+2GE+HPNA7261G
Connect the 2.1mm DC power plug to theWiFi function is active port is not provisioned.and connected.No Ethernet link or port is not provisionedSoftware upgrade is in progress.The 72xx SFU ONT is equipped with an ON/OFFlabeled USB on the left side of the units.Connect a flash-disk/portable hard disk to the portChange the notebook/computer WiFi networkthe same port with CATV.Coax Network,using a splitter to connect to Connect the coaxial cable to the port labled labeled Coax Network. This port also supports Return Service on select models. Connect the Television or Set Top Box to the port ETH1 or ETH2.put uses a MOLEX 43025-The UPS power/alarm in-tion as shown is viewed fromlabeled POTS1 and POTS2.Connect up to 2 phones to the unit. There are 2 pots, Connect the computers/routers to the ports labeledcertified Please use UPS Status: Replace BatteryPins for the connector are Molex 46235-5002Page 2 Page 3 Page 4 Page 5Fiber Connection1.) On the back left side of the unit is fiber cover.Slide it off as shown. 2.) With the fiber connector exposed, remove thedust plug, clean the fiber ends and terminate theSC equipped fiber. Danger! . Exposure to invisible LASER radiation may cause serious retinal damage or even blindness. Verify the optical source is disabled through the use of an optical power meter before handling optical fibers.3.) Insert the fiber into the cover slot and slide thecover back onto the 72xx unit.DC Power Inputport labeled PWR.UPS Power and Alarms0800 connector. Pin orienta-the rear.NOTICE: UL UPS whichmeets Limited Power Source standard.POTS ConnectionsLAN ConnectionsCATV ConnectionPIN NAME ALM1 Power Input (+12 VDC) –2 UPS Status: On Battery 13 UPS Status: Battery Missing 24 Signal Return –5 Power 12V Return –6 37 UPS Status: Low Battery 48 No Connection (N/A) –WiFi ConnectionSSID to “iphotonix-ONTxxxx”. This may be changedmanually.USB ConnectionUser Controlsbutton. User functionality should be limited to thisbutton.LED DescriptionsThe 72xx SFU ONT has visual LED indicators tohelp the user determine the operational state of theunit. The LEDs are defined as follows:PowerBatteryMGMTON Unit is powered onOFF Unit is powered offON Battery is charged and unit is operating nor-mally on external power.Flashing Slow Unit is running off of battery power only. Check power supply to unit.Flashing Fast Battery is low and unit may turn off if exter-nal power is not restored.OFF Battery is missing or defective.ON Management channel (OMCI) is activeOFF Management channel (OMCI) is not active.ETH 1- 2POTS FAILWLAN Environmental RequirementsON Ethernet link is operational.Flashing Indicates data transmission / reception.OFFON Line is off hook (call active or in process)Flashing Slow Indicates ringing line.OFF Line is on hook (no call in process) or ON Indicates Loss Of Signal (LOS). No opti-cal signal is present.Flashing SlowMarginal signal indicates a weak optical signal from carrier. Clean fiber connection per local practice and check power with an optical meter.Flashing FastOFF Optical signal is present and operating nor-mally.ONFlashing Indicates active data TX/RXOFF WiFi function is not activeRated Voltage: DC 12VRated Current: 2AOperating Temperature: +5°C to +40°COperating Relative Humidity: 5% to 85% Storage Temperature: -40°C to +60°CStorage Relative Humidity: 0% to 95%HPNA ConnectionHPNAON HPNA link activeOFF No HPNA link active

Navigation menu