Hitron TECHNOLOGIES CODA4782 DOCSIS 3.1 wifi Gateway User Manual 0440010242N0 1A 1025

Hitron Technologies Inc. DOCSIS 3.1 wifi Gateway 0440010242N0 1A 1025

Contents

Users Manual_Statement

FCC STATEMENTSFCC STATEMENTSFederal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:● Reorient or relocate the receiving antenna.● Increase the separation between the equipment and receiver.● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.● Consult the dealer or an experienced radio/TV technician for help.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only.IMPORTANT NOTE:FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 21cm between the radiator & your body. Warning:the cable distribution system should be grounded (earthed) in accordance with ANSI / NFPA 70, National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable."CAUTION"1. RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE TO DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTED.2. Unambiguous reference to service documentation for instructions for replacement of fuses replaceable only by service personnel 3. For telecommunication type connectors and terminals not used for connection to the telecommunication network should be provided with a marking identifying the specific function or circuit characteristic the connector or terminal is used for. Connector: RJ-45 'Ethernet 1, 2, 3, 4' advertencia:el sistema de distribución de cable debe estar conectado a tierra (masa) de acuerdo con ANSI / NFPA 70, Código Eléctrico Nacional (NEC), en particular la Sección 820.93, Conexión a tierra de revestimientos conductores externos de un cable coaxial.“PRECAUCIÓN"1. RIESGO DE EXPLOSIÓN SI SE SUSTITUYE LA BATERÍA POR UN TIPO INCORRECTO PARA ELIMINAR LAS BATERÍAS USADAS SEGÚN LAS INSTRUCCIONES.2. Referencia inequívoca a la documentación de servicio para obtener instrucciones sobre la sustitución de fusibles sustituibles sólo por personal de servicio3. Para conectores de tipo de telecomunicaciones y terminales no usados para la conexión a la red de telecomunicaciones deben estar provistos de un marcado identificación de la función o característica específica del circuito del conector o terminal se utiliza para.Conector: RJ-45 'Ethernet 1, 2, 3, 4'FCC STATEMENTSUL and NOM-019FCC STATEMENTS NOM-121La operación de este equipo está sujeta a las siguientes dos condiciones:(1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.CAUTION:Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions.The cable distribution system should be grounded (earthed) in accordance with ANSI / NFPA 70, National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable.Unambiguous reference to service documentation for instructions for replacement of fuses replaceable only by service personnel.For telecommunication type connectors and terminals not used for connection to the telecommunication network should be provided with a marking identifying the specific function or circuit characteristic the connector or terminal is used for.ATTENTION:Il y a risque d’explosion si la batterie est remplacée par une batterie de type incorrect.Mettre au rebut les batteries usagées conformément aux instructions.le système de distribution par câble doit être mis à la terre ( la terre) conformément à la norme ANSI / NFPA 70 , National Electrical Code ( NEC ), en particulier l'article 820.93 , la terre du blindage conducteur extérieur d'un câble coaxial.Référence sans ambiguïté à la documentation de service pour obtenir des instructions pour le remplacement des fusibles remplaçables par un personnel de service.Pour les connecteurs de type de télécommunication et les terminaux ne sont pas utilisées pour le raccordement au réseau de télécommunication doivent être pourvus d'un marquage d'identification de la fonction spécifique ou une caractéristique du circuit du connecteur ou d'un terminal est utilisé pour.FCC STATEMENTScULLISTED

Navigation menu