Honeywell 202125TXR Wireless Repeater Module User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2361557
Application ID	+jvU1K4lpfjQVLU7kyYsEw==
Document Description	User Manual.pdf
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	34.3kB (428781 bits)
Date Submitted	2014-08-18 00:00:00
Date Available	2014-08-18 00:00:00
Creation Date	2013-09-25 15:19:19
Producing Software	Microsoft® Word 2010
Document Lastmod	2013-09-25 15:19:19
Document Title	User Manual.pdf
Document Creator	Microsoft® Word 2010
Document Author:	Philipp Roosli

INNCOM PC-502.2 Datasheet
Overview
The INNCOM PC-502 wall mounted module can be used to expand the range of a
network (IR or Layer-1 or Layer-2 RF) or to provide the protocol gateway from
INNCOM S5-bus to Layer-1 or Layer-2 RF protocol.
In an IR network, the PC-502 module can be used to provide remote eye functionality
or protocol gateway from INNCOM S5-bus to IR wireless protocols. The PC-502 adds
functionality beyond the traditional remote eye because, as a smart 5-bus device, it can
be powered from a standard 3-pin 5-bus connection.
In a Layer-1 RF network, the PC-502 provides S5-bus to RF protocol conversion, giving any
INNCOM product participating in the INNCOM Integrated Room Automation System
(IRAS) an RF transceiver for control of wireless products in the guestroom.
Figure 1 PC-502
In the Deep Mesh 802.15.4 network, the PC-502 is designed to patch areas within the
network where signal strength is lost due to distance limitations or interference. It
also serves to create multiple pathways, increasing the redundancy of the mesh communications to ensure
maximum network reliability.
Features

Small wall mountable form factor

2.4Ghz IEEE 802.15.4 compliant RF transceiver (CC2430 radio core)

Medium and long range variants available

Industrial temperature ratings 0–65 degrees C

FCC Part 15b listed
Specification
Parameter
RF Data Rate
Antenna Type
Indoor Range
Outdoor/ RF line-of-sight range
Transmit Power
Receive Sensitivity
Frequency Band
Encryption
Protocol
Frequency Channels
Input Voltage
Current Consumption
Operating Ambient Temperature
PC-502.2
250kbps
SMT
100ft
1000ft+
10mW (+18dBm)
-94.6dBm
2.4Ghz
AES-128
802.15.4
11-26
12VDC
100mA (Peak)
40°C
INNCOM PC-502 Datasheet
Page |2
Network Topology
X 07 HVAC
Controller
L 208 Lamp
Controller
e527
PC-502..IR
S55 x Lamp
Controller
S5bus
D254. DIN
Figure 2 PC-502.IR Topology
In this application, the PC-502 provides S5-bus to IR protocol conversion giving any INNCOM product
participating in the INNCOM Integrated Room Automation System (IRAS) an IR transceiver for control of
wireless products in the guestroom.
X07 HVAC
Controller
L208 Lamp
Controller
Layer-1 RF Network
e527
PC-502.1
S55x Lamp
Controller
S5bus
D254.DIN
Figure 3 PC-502 Layer-1 Topology
In this application, the PC-502 is providing S5-bus to RF protocol conversion, giving any INNCOM product
participating in the INNCOM Integrated Room Automation System (IRAS) an RF transceiver for control of
wireless products in the guestroom.
INNCOM PC-502 Datasheet
Page |3
X07 HVAC
Controller
L208 Lamp
Controller
Layer-1 RF Network
GS-528H
E528.3G
S55x Lamp
Controller
S5bus
PC-502.2
Layer-2 RF Network
TCT.RF
Ethernet
B573-MBX
Figure 4 PC-502 Layer-2 Topology
In this application, the PC-502 in participation with the e528.3G provides the Layer-1 to Layer-2 RF Bridge where
both wireless in-room and wireless back-end networking are required. The PC-502 can also patch areas within the
Layer-2 network where signal strength is lost due to distance limitations or interference.
Safety/Regulatory
Parameter
FCC
Condition
Part 15b
Status
This device contains FCC ID: FCC ID: GTC202125TXR
Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This
equipment should be installed and operated with minimum distance 20 cm between the radiator& your body
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off
INNCOM PC-502 Datasheet
Page |4
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
 Receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
IC ID: 1609A-202125TXR,
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
PC-502 Dimensions
48mm
44mm
System-5
S5-In
S5-Out
74mm
FCC Part 15, Class B
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation
70mm
Model: Remote PC-502
P/N 01-5010.__
Date Code _______________
Diag
ICP
Radio ICP
PC-502 Front View
PC-502 Back View
21mm
Mounting Plate
Front View
2mm
Mounting Plate
Side View
70mm
PC-502 Side View
Header and Connections
H3 (In System Programming)
Pin
1-8
Function
Programming
Type
H4 / H5 (S5-bus In/Out)
Min
Max
INNCOM PC-502 Datasheet
Pin
1-GND
2-12VDC
3-S5-bus
Page |5
Function
Type
Common
Input voltage
Multi-drop
In
In/Out
Min
11.75
Max
12.25
H6 (System-5)
Pin
1-GND
2-12VDC
3-S5-bus
4 –InOut1
5- InOut2
Function
Common
Input voltage
Multi-drop
TTL
TTL
Type
In
In/Out
In/Out
In/Out
Min
11.75
3-pin-to-3-pin harness, PN 62-2035,
length 12" (300 mm)
3-pin to 3-pin harness for 12VDC and 5-bus connection
Max
12.25
INNCOM PC-502 Datasheet
Page |6
Ordering Information
Part Number
201-502.2
OPN
Description
PC-502 with 20dB Transceiver
PC-502.2
Document Revision History
Revision
0.1
Date Issued
14-May-2013
Reason
FCC for PC-502

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 6
Language                        : en-US
Tagged PDF                      : Yes
Author                          : Philipp Roosli
Creator                         : Microsoft® Word 2010
Create Date                     : 2013:09:25 15:19:19-04:00
Modify Date                     : 2013:09:25 15:19:19-04:00
Producer                        : Microsoft® Word 2010

EXIF Metadata provided by EXIF.tools