Honeywell 8650 Bluetooth Ring Scanner User’s Guide User Manual To The 0846eec3 F714 4563 Bfd5 E0c3436f7948
User Manual: Honeywell 8650 to the manual
Open the PDF directly: View PDF
Page Count: 244 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- 8650 Bluetooth Ring Scanner User's Guide
- Disclaimer
- Trademarks
- Patents
- Table of Contents
- Bluetooth Ring Scanner Agency Compliance
- Getting Started
- Overview
- About this Guide
- Out of the Box
- Initial Setup
- Components
- Assembly
- Adjusting the Ring Device Strap
- Status LEDs and Beep Indicators
- Bluetooth Module Status LED and Beep Indicators
- Bluetooth Ring Device LED
- Rebooting the Bluetooth Module
- Battery
- Pairing Bluetooth Devices
- Clearing Paired Status
- Removing / Replacing the Trigger Module
- How To Scan a Bar Code
- Factors That May Impact Scanner Performance
- Bar Code Scanning Help
- Miscellaneous Programmable Bar Codes
- Bluetooth Module Programming Bar Codes
- 1D Laser Scanner Programming Bar Codes
- Introduction
- Aiming Modes
- Prefix / Suffix
- Scanner Parameters – General
- Data Options
- Prefix and Suffix
- Scan Data Transmission Format
- Transmit Code ID Character
- Laser On Time
- Linear Code Type Security Level (Redundancy Level)
- Parameter Pass Through
- Parameter Scanning
- Power Mode
- Scan Angle (SE955 only)
- Simple Serial Interface (SSI) Options
- Time-out Between Decodes, Same Symbol
- Transmit “No Read / Decode” Message
- Trigger Mode
- Scanner Parameters – Bar Code Type Specific
- Appendix
- Keypad Number Symbols
- 2D Laser Imager Programming Bar Codes
- Introduction
- Set All Defaults/Cancel Bar Codes
- Enable / Disable Parameter Scanning
- Imager Parameters – General
- Decode Session Timeout
- Decode Aiming Pattern
- Decoding Autoexposure
- Decoding Illumination
- Focus Mode
- LED Illumination
- Operational Mode
- Power Mode
- Presentation Mode Session Timeout
- Time Delay to Low Power Mode
- Time-out between Decodes, Same Symbol
- Trigger Modes
- Report Version
- Transmit Code ID Character
- Prefix / Suffix Values
- Scan Data Transmission Format
- Transmit “No Read” Message
- UPC/EAN
- UPC-A
- UPC-E
- UPC-E1
- EAN-8/JAN-8
- EAN-13/JAN-13
- Bookland EAN
- Bookland Format
- Decode UPC/EAN/JAN Supplementals (2 and 5 digits)
- UPC/EAN/JAN Supplemental Redundancy
- Transmit UPC-A Check Digit
- Transmit UPC-E Check Digit
- Transmit UPC-E1 Check Digit
- UPC-A Preamble
- UPC-E Preamble
- UPC-E1 Preamble
- Convert UPC-E to UPC-A
- Convert UPC-E1 to UPC-A
- EAN-8/JAN-8 Extend
- UCC Coupon Extended Code
- Code 128
- Code 93
- Code 11
- Interleaved 2 of 5 (ITF)
- Discrete 2 of 5 (DTF)
- Codabar
- MSI
- Postal Codes
- Composite
- 2D Symbologies
- Redundancy Level
- Security Level
- Intercharacter Gap Size
- Imager Keypad Number Symbols
- Firmware Upgrade
- Decode Zones
- Battery Chargers
- Unpacking your Battery Charger
- Introduction
- Cautions and Warnings
- Charging Batteries
- Eight Bay Battery Charger
- Front View
- Charging Pocket
- Footprint and Mounting Hole Location
- Installation
- Inserting a Battery into the Charging Pocket
- Removing the Battery from the Charging Pocket
- Interpreting the Charging Pocket LEDs
- Charge Timer
- Charging Pocket
- Inserting a Battery into the Charging Pocket
- Removing the Battery from the Charging Pocket
- Interpreting the Charging LED
- Charge Timer
- Battery Charger Help
- Charger Cleaning, Storage and Service
- Battery Cleaning, Storage and Service
- Technical Specifications
- Customer Support
- Manual Part Number, Revision, and Date