Honeywell 8DLRF6C Lyric Smart Peripheral - Contact User Manual Quick Installation Manual

Download:
Mirror Download [FCC.gov]
Document ID	2714165
Application ID	xVxrrEtvPnpYBpKpyw5Deg==
Document Description	Quick Installation Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	30.36kB (379477 bits)
Date Submitted	2015-08-13 00:00:00
Date Available	2016-02-09 00:00:00
Creation Date	2015-04-30 05:35:20
Producing Software	Adobe PDF Library 11.0
Document Lastmod	2015-07-28 10:26:50
Document Title	Quick Installation Manual
Document Creator	Acrobat PDFMaker 11 for Word
Document Author:	E727032

PLEASE GO TO THE LAST PAGE FOR FCC/IC AGENCY STATEMENTS
This wireless door / window
contact is intended for use with
Honeywell controls that
support SiX™ series devices.
FC: This wireless door / window
contact is intended for use with
Honeywell controls that
support SiX™ series devices.
A Terminal Block
B Reed Switch
C Magnet
D Tamper
E LED
SP: This wireless door / window
contact is intended for use with
Honeywell controls that
support SiX™ series devices.
PA: This wireless door /
window contact is intended for
use with Honeywell controls
that support SiX™ series
devices.
After enrolling and before mounting permanently, conduct Go/No Go
tests (see the controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
FC: After enrolling and before mounting permanently, conduct Go/No
Go tests (see controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
SP:: After enrolling and before mounting permanently, conduct Go/No
Go tests (see controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
PA:: After enrolling and before mounting permanently, conduct Go/No
Go tests (see controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
NOTE: Once enrolled, the device cannot be used with another system until it is removed
from the current controller. See the controller’s instructions.
NOTE: Once enrolled, the sensor cannot be used with another system until it is removed
from the current controller. See the controller’s instructions..
NOTE: Once enrolled, the sensor cannot be used with another system until it is removed
from the current controller. See the controller’s instructions..
NOTE: Once enrolled in a system, the RF6GB cannot be used with another control panel
until it is removed from the current control panel. See the Control’s instructions.
Enroll / Enroll / Enroll / Enroll
Product must be tested at least once each year / Le fonctionnement du produit doit être vérifié au moins une fois par année /
El producto debe ser probado al menos una vez al año / O produto deve ser testado pelo menos uma vez por ano
BATTERY CAUTION: Risk of
fire, explosion and burns. Do
not recharge, disassemble,
heat above 212° F (100° C) or
incinerate. Dispose of used
batteries promptly. Keep
away from children.
FEDERAL COMMUNICATIONS COMMISSION & INDUSTRY CANADA STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or
User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following
statement for your information: This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the
specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated.
• Move the radio or television receiver away from the receiver/control.
• Move the antenna leads away from any wire runs to the receiver/control.
• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch
circuits.
• Consult the dealer or an experienced radio/TV technician for help.
FC:BATTERY CAUTION: Risk
of fire, explosion and burns.
Do not recharge,
disassemble, heat above
212° F (100° C) or incinerate.
Dispose of used batteries
promptly. Keep away from
children.
INDUSTRY CANADA CLASS B STATEMENT
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
SP: BATTERY CAUTION: Risk
of fire, explosion and burns.
Do not recharge,
disassemble, heat above
212° F (100° C) or incinerate.
Dispose of used batteries
promptly. Keep away from
children.
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules, and RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS-210 des Industries Canada. Son fonctionnement est
soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit accepter
toute interférence reçue y compris les interférences causant une reception indésirable.
RF Exposure
Warning – The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20
cm) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter except in
accordance with FCC multi-transmitter product procedures.
PA: BATTERY CAUTION:
Risk of fire, explosion and
burns. Do not recharge,
disassemble, heat above
212° F (100° C) or incinerate.
Dispose of used batteries
promptly. Keep away from
children.
Mise en Garde
Exposition aux Frequences Radio: L'antenne (s) utilisée pour cet émetteur doit être installée à une distance de séparation
d'au moins 7,8 pouces (20 cm) de toutes les personnes.
Support and Warranty
Replace Battery / Replace Battery /
Replace Battery / Replace Battery
Approval Listings:
RoHS
FCC / IC
ETL listed to UL1023 &
UL 634
cETL Listed to ULC/ORD
1023 & ULC/ORD 634
Specifications:
Battery: 1 x 3V, Lithium; Panasonic CR123A, Duracell DL
123, Duracell DL 123A, Honeywell 466
Tamper: Cover and Wall – reported separately to panel.
RF Frequency: 2.4GHz
Operating Temperature: 32° to 122° F / 0° – 50° C
Relative Humidity: 5 – 95%, non-condensing
Dimensions: 1” H x 3.13” L x 1.61” W /25.5 mm H x
79.5 mm L x 41 mm W
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED,
FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
For the latest documentation and online support information, please go to:
Pour de l’assistance en ligne, visitez :
Para recibir soporte en línea, visite:
Para qualquer informação adicional, contacte:
https://mywebtech.honeywell.com//
MyWebTech
Warranty
For the latest U.S. warranty information, please go to www.honeywell.com/security/hsc/resources/wa or
Please contact your local authorized Honeywell representative for product warranty information.
Pour obtenir de l'information sur la garantie de ce produit, veuillez communiquer avec le représentant
autorisé de Honeywell de votre région.
Por favor contacte con su distribuidor Honeywell Security para información sobre la garantía del producto.
Contacte o representante autorizado Honeywell local para obter informações relativas a garantia.
To protect the environment, a detailed installation guide is available on
the Honeywell website – Please consider before printing the document!
 2014 Honeywell International Inc. Honeywell and is a registered trademark of Honeywell International Inc.
All other trademarks are the properties of their respective owners. All rights reserved
www.honeywell.com/security
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Ê800-15959)Š
800-15959 04/15 Rev A BETA

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Has XFA                         : No
Language                        : EN-US
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Modify Date                     : 2015:07:28 10:26:50-04:00
Create Date                     : 2015:04:30 05:35:20-07:00
Metadata Date                   : 2015:07:28 10:26:50-04:00
Creator Tool                    : Acrobat PDFMaker 11 for Word
Document ID                     : uuid:fc29130b-921a-4b45-b004-c949f5859f57
Instance ID                     : uuid:85da8573-043a-43be-9fcd-944c4814175a
Subject                         : 2
Format                          : application/pdf
Creator                         : E727032
Producer                        : Adobe PDF Library 11.0
Source Modified                 : D:20150430122503
Company                         : Honeywell
Page Layout                     : OneColumn
Page Count                      : 2
Author                          : E727032

EXIF Metadata provided by EXIF.tools