Honeywell TL8130A 69 1805 Programmable Thermostat User Guide Manual To The A39b97d1 A145 4f40 Bb18 6c5510b0985b

User Manual: Honeywell TL8130A to the manual

Open the PDF directly: View PDF .
Page Count: 2

Download
Open PDF In Browser	View PDF

TL8130A
User Guide
Programmable Thermostat

Description

Honeywell’s TL8130A programmable thermostat can be connected to an
electric heater to control the room temperature.
On/Standby
switch *

Temperature display

Period display

Program button

Backlight button
*
**

Temperature
adjustment
buttons

Mode selection /
program exit

o
•

•

100%
2.

Assembly/Disassembly

Setpoint

To change the setpoint, press one of the
buttons until the desired temperature is displayed. To scroll faster, hold the button.
Preset buttons

To remove the control module from the power
base, loosen the captive screw underneath the
thermostat and pull the two components apart as
shown.

The thermostat has 3 temperature preset buttons:
Comfort preset button
Economy preset button
Vacation preset button
To use a preset temperature, press the appropriate button. The corresponding
icon
,
or
will be displayed.

To install the control module onto the power
base, reverse the above procedure.

NOTE: Always keep the thermostat's vents clean and
unobstructed.

The following table shows the intended use and the default setting of each of
the preset buttons.
3.

Configuration

Icon

SW1
SW2
SW3
a.
b.

Temperature format
Early Start b
Time format

New

21°C (70°F)

Vacation
(during prolonged absence)

10°C (50°F)

To store a preset temperature:

°F

°C

Disable

Enable

Set the desired temperature using the

12-hour

24-hour

n
o
p

Press Mode/Ret to exit.

If you change the temperature display format, the preset buttons ( , and
)
will return to their default settings.
Early Start can be used in Automatic mode only. When this function is enabled, the
thermostat calculates the optimal time to start heating in order to obtain the desired
temperature by the set time. The thermostat re-assesses the start time daily based
on the previous day’s performance.

TL8130A

Default setting

Economy
16.5°C (62°F)
(when asleep or away from home)

Default (factory) settings are inside the gray cells.
Configurations

Intended use
Comfort
(when at home)

Some thermostat configurations can be
modified via the switches on the back of the
control module.

Temperature Setting

The thermostat normally displays the actual temperature. To view the setpoint, press one of the
buttons once or press the backlight button. The
setpoint will appear for the next 5 seconds.

Display
1 to 24% 25 to 49% 50 to 74% 75 to 99%

Backlight

When the backlight button is pressed, the display illuminates for 5 seconds.
When either of the
buttons is pressed, the display illuminates for 10 seconds.

Set the switch to Standby to cut power to the heater. This will not affect the time
and temperature settings.
The thermostat displays the heater duty cycle required to maintain the desired temperature. For example,
appears when the heater is activated 40 percent of the
time.

% of duty cycle

Error Messages

HI: The measured temperature is above 50°C (122°F).

Temperature
preset buttons

Program
clear button

Press the Day button to set the day.

LO: The measured temperature is below 0°C (32°F).
Heating is activated.

Preset temperature
icon

Heating power **

) and displays the

Press the Hour and Min buttons to set the time.

Mode display

Day and time
settings

Upon power-up, the thermostat is in manual mode (
actual temperature.

n
o

Time and day display

Appears when
the setpoint is
displayed

Power-up

buttons.

Press and hold the appropriate preset button until the corresponding
icon is displayed.

69-1805

3/5/05

1/2

Use the following grid to record the new schedule.
8.

Operating Modes

Period

Setting

The thermostat has 3 operating modes.

Automatic - The temperature is set according to the energy-saving
schedule. To place the thermostat in this mode, press Mode/Ret until
is
displayed. The current period setting is also displayed.
Temporary Bypass: If you modify the setpoint (by pressing the
,
or
button) when the thermostat is in automatic mode, the new setpoint
will be used until the beginning of the next period.

Manual - The energy-saving schedule is not used. The temperature must
be set manually. To place the thermostat in this mode:

n
o

Press Mode/Ret until

is displayed.

Set the temperature using the

button.

Vacation - The thermostat is set to the Vacation temperature. Press
to place the thermostat in Vacation mode.

Energy-saving Schedule

The schedule consists of 4 periods per day which represents a typical week
day. You can program the thermostat to skip the periods that do not apply to
your situation. For example, you can skip periods 2 and 3 for the weekend.
Period

Description

Associated temperature setting

Wake-up
Away from home
Return home
Sleep
The Comfort ( ) temperature is used in periods 1 and 3 and the Economy
( ) temperature is used in periods 2 and 4. For example, when the period
changes from 1 to 2, the setpoint automatically changes from Comfort setting
( ) to Economy setting ( ).
You can have a different program for each day of the week; i.e., each period
can start at different time for each day of the week. The thermostat has been
programmed with the following schedule.
Period

Setting

6:00

8:00

--:--

18:00

--:--

22:00

To modify the schedule:

n
o

Press Pgm to access the programming mode. Period 1 is selected.

Press Hour and Min to set the start time of the selected period, or press
Clear if you want to skip the period (--:-- is displayed).

Press Day to select the day to program (hold for 3 seconds to select the
entire week).

Press Pgm to select another period, or press Day to select another day.
Then repeat step 3.

Press Mode/Ret to exit the programming mode.

NOTE: If no button is pressed for 60 seconds, the thermostat will automatically exit the programming mode.

TL8130A

10.

Technical Specifications

Power supply: Refer to the power base installation instructions
Display range: 0°C to 60°C (32°F to 140°F)
Setpoint range: 5°C to 30°C (40°F to 86°F)
Display resolution: 0.5°C (1°F)
Storage: -20°C to 50°C (-4°F to 120°F)
Heating cycle length: 15 minutes
Data backup: In the event of a power failure, most settings are saved. Only
the time must be re-adjusted if the power failure lasts more than 2 hours. The
thermostat will return to the mode that was active prior to the power failure.

;

11.

Warranty

Honeywell warrants this product, excluding battery, to be free from defects in the
workmanship or materials, under normal use and service, for a period of five (5)
years from the date of purchase by the consumer. If at any time during the warranty
period the product is determined to be defective or malfunctions, Honeywell shall
repair or replace it (at Honeywell's option).
If the product is defective,
(i)
return it, with a bill of sale or other dated proof of purchase, to the place from
which you purchased it, or
(ii) call Honeywell Customer Care at 1-800-468-1502. Customer Care will make
the determination whether the product should be returned to the following
address: Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr N,
Golden Valley, MN 55422, or whether a replacement product can be sent to
you.
This warranty does not cover removal or reinstallation costs. This warranty shall
not apply if it is shown by Honeywell that the defect or malfunction was caused by
damage which occurred while the product was in the possession of a consumer.
Honeywell's sole responsibility shall be to repair or replace the product within the
terms stated above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR
DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF
ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS
PRODUCT. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES
ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES,
INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE FIVE-YEAR DURATION
OF THIS WARRANTY. Some provinces do not allow limitations on how long an
implied warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which
vary from province to province.
If you have any questions concerning this warranty, please write Honeywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-4681502. In Canada, write Retail Products ON15-02H, Honeywell Limited/Honeywell
Limitée, 35 Dynamic Drive, Scarborough, Ontario M1V4Z9.
12.

Customer Assistance

If you have any questions about the operation of your thermostat, please go to
www.honeywell.com/yourhome, or call Honeywell Customer Care toll-free
at 1-800-468-1502.

Printed in China

69-1805

3/5/05

2/2

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Copy, Extract, Assemble, Print high-res
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Producer                        : Acrobat Distiller 7.0 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2007:05:07 15:55:03-05:00
Create Date                     : 2005:05:03 14:47:31-04:00
Metadata Date                   : 2007:05:07 15:55:03-05:00
Document ID                     : uuid:252adbbc-e92f-485f-b080-aae9e4f9c032
Instance ID                     : uuid:5e6c5306-3c56-48de-9dfb-b421da9f9bfa
Format                          : application/pdf
Title                           : 69-1805 Honeywell Programmable Thermostat TL8130A User Guide
Creator                         : Honeywell Aube Technologies
Description                     : User Guide
Page Count                      : 2
Subject                         : User Guide
Author                          : Honeywell Aube Technologies

EXIF Metadata provided by EXIF.tools

Honeywell TL8130A 69 1805 Programmable Thermostat User Guide Manual To The A39b97d1 A145 4f40 Bb18 6c5510b0985b

Navigation menu

Versions of this User Manual:

Views

Navigation