Hong Jin Crown America HJC-BTA Bluetooth Stereo Transmitter User Manual 12 Users Manual
Hong Jin Crown America Inc Bluetooth Stereo Transmitter 12 Users Manual
manual
V01
KB84T User Manual
1. There is no on/off button on the Bluetooth adapter. You just need to plug it into the
dock connector directly.
■ One way: Switch the iPod on. Plug the iPod Bluetooth adapter into the dock
connector. The Blue LED(status indicator) will flash quickly and the iPod Bluetooth
adapter is now in pairing mode.
■ Another way: When the iPod is playing a song or video, plug the iPod Bluetooth
adapter into the dock connector, the blue LED will flash quickly and the iPod
Bluetooth adapter is now in pairing mode.
2. Tune your Bluetooth headset on and the LED on the headset will into pairing
mode(You can see user manual),Place the Bluetooth adapter and headset close to
each other(no more than three feet apart, and ensure there is no obstruction between
them). The Bluetooth adapter and headset will start pairing automatically.
3. The LED on the two device will flash quickly while they are pairing.
4. The pairing should be completed in one minute. KB84T and Bluetooth headset is
connecting,and you can listen music from iPod.so you can start using your iPod
wirelessly.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this equipment.
(Example- use only shielded interface cables when connecting to computer or peripheral devices).
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of FCC RF Rules. Operation is subject to the
following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.