Hong Jin Crown America HJC-BTD Bluetooth Stereo Transmitter User Manual KB85TB Quick User Guide V01
Hong Jin Crown America Inc Bluetooth Stereo Transmitter KB85TB Quick User Guide V01
manual
V01
Simple Operate Statement：
1.Please open the bluetooth stereo audio device power，and into pairing mode。and
power on the KB85TB into pairing mode，connect together，you can listen music from
MP3 PLAYER。
2.Please power on the Bluetooth stereo audio device have paired’s for KB85TB， and the
power on KB85TB’s 3.5mm plug to plug in the MP3 PLAYER 3.5mm jack，KB85TB can
auto connect to Bluetooth stereo audio device,play MP3 PLAYER music，you can listen
music audio。
3. KB85TB is without line，ten minute timeout to close power。
Key Statement：
[Power On]
■ Press and hold the power button for 3 seconds at power off status，and all led light on
together，open power finish。
■ If KB85TB not paired for any Bluetooth stereo audio device,the KB85TB is auto pairing
mode at power on。
■ If KB85TB have paired for last Bluetooth stereo audio device,the KB85TB is auto
connect last Bluetooth stereo audio device at power on。
[Power Off]
■ Press and hold the power button for 3 seconds at power on status，and all led light off
together，close power finish。
[Pairing]
■ Press and hold the power button,until see the two led alternate to flash。
■ If not search any Bluetooth device,KB85TB auto try to connect last Bluetooth stereo
audio device at timeout。
■ If pair succeeds,KB85TB auto connect to listen the music at Bluetooth stereo audio
device from MP3 PLAYER。
V01
[Cancel Pairing]
■Can not cancel pair at pairing mode,Only to power off. and power on replay。
[Connet and Play]
■Press KB85TB’s power button to connect the Bluetooth stereo audio device at power on
and have paired。
LED Display Statement：
[Pairing LED]
Red and Blue led alternate to flash。
[Require Connect LED]
Red and Blue led Once light on together，and after alternate to flash。
[Music Transmitting LED]
Blue led light on every 4 seconds for a long and short light。
(Blue light is made into the red light only bright at low power alarm) 。
[Connecting LED]
Every three seconds,Blue led fast to flash three times。
(Blue light is made into the red light only bright at low power alarm) 。
[Idle LED]
Every three seconds,Blue led flash one times。
(Blue light is made into the red light only bright at low power alarm) 。
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this equipment.
(Example- use only shielded interface cables when connecting to computer or peripheral devices).
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of FCC RF Rules. Operation is subject to the
following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.