Honsenn Technology BT-H802 HONSENN BLUETOOTH HEADPHONE User Manual 20140331
HONSENN TECHNOLOGY CO.,LTD HONSENN BLUETOOTH HEADPHONE 20140331
User Manual
WARNING: Do not place batteries in mouth or ingest. Keep out of reach of children and pets.
Please dispose of any used batteries properly following any local regulations. Do not incinerate.
PLEASE LISTEN RESPONSIBLY
The Occupational Safety Health Administration (OSHA) has issued headphone usage recommendations for
maximum daily exposure and sound pressure levels(measured in decibels(dB). A decibel is a unit of measure of sound ,
and decibels increase exponentially as sound gets louder. For example, conversational speech is typically around 60dB,
and a rock concert in a stadium is often about 110dB.
OSHA GUIDELINES FOR NOISE EXPOSURE LIMITS
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1 This device may not cause harmful interference and 2 this device must accept any interference received , including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiates radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on , the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part as a Class B Digital Device.
Caution: Changes or modifications not expressly approved by the manufactured could void the user’s authority to
operate this device.
Caution: To comply with the limits the Class B digital device, pursuant to Part15 of the FCC Rules, this devices is to
comply with Class B limits. All peripherals must be shielded and rounded. Operation with non-certified peripherals or
non-shielded cables may result in interference to radio or reception.
This Class B digital apparatus complies with Canadian ICES-003.
90dB 8hours
95dB 4hours
100dB 2hours
105dB 1hour
110dB 30minutes
115dB 15minutes
120dB Avoid as damage may occur
Sound Pressure level Recommended Maximum Exposure Per Day
WEEE NOTICE
Note: This mark applies only to countries within the European Union(EU) and Norway. This appliance is
labeled in accordance with European Directive 2002/96/EC concerningwaste electrical and electronic
equipment (WEEE).This label indicates that this productshould not be disposed of with household waste.
It should be deposited at an appropriate facility to enable recovery and recycling.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
The term”IC:”before the radio certification number only signifies that industry Canada technical specifications
were met.
This device complies with part 15 of the FCC Rules and the applicable industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions(1)this device may not cause harmful interference,
and(2) this device must accept any interference ,including interference that may cause undesired operation of the
device .
SPECIFICATIONS
BLUETOOTH V4.0+EDR
Range: Up to 10m(33feet)
Input rating:5V DC,0.5A
CHARGING
Charge for 1hour before first use.
When fully charged the battery will provide up to 10 hours of talking and/or music time.You can continue to use the
headset while charging.
Low battery (Battery Status Indicator):
PAIRING
Before using the headset for the first time it must be paired with a Bluetooth device (mobile phone, ect)
1 Ensure the headset is off.
2Hold the Power/Pairing button for 3 seconds. The headset will turn on then the status indicator will rapidly
flash
3 Turn on Bluetooth on the device and set it to search for Bluetooth devices.
4 Select “HONSENN802” from the device list.
Once a device has been paired the headset will remember it. When the headset is turned on it will automatically scan for
remembered device, beginning with the most recently paired. Up to 8 devices are memorized .
TURNING ON/OFF VOLUME &MUSIC CONTROLS
CALLS
Make calls as normal from the phone, when the headset is connected the audio will automatically go to the headset
DISCONNECT THE HEADSET
To disconnect the headset from the device, power the headset off or disconnect it in the Bluetooth menu of the device
RECOONECT THE HEADSET
To connect to the most recently used device, power the headset on. If Bluetooth is enabled on the device they will
automatically reconnect. To connect to another remembered device, select “HONSENN” from the Bluetooth menu
of the device.
STATUS INDICATOR
Example:
Blinks Blue Blinks Red Time Between Blinks
B BR R
B R
RR R
B B B
B B B
R B R B
Image ONE Bluetooth Headset Direct Connect Audio Cable Micro USB Charging Cable
123
4
8
5
6
7
1Audio jack 2 Status Indicator 3 Charging jack 4 Volume-
5 Track back 6 Volume+ 7 Track forward 8 Play/Pause, Anwer/End Call
Hold 3 seconds
Status indicator
ON
OFF
volume down volume up
Previous Track
Next track
Play /Pause
Play/Pause,Answer/End Call
Reject call-Hold 2 Seconds
Answer/End call-press one
USING WITH THE DIRECT CONNECT AUDIO CABLE
The headset can be connected to an audio source using the direct connect audio cable. Note:When the audio cable
is connected the Bluetooth function and controls are disabled.
.
STATUS INDICATOR
Example:
Blinks Blue Blinks Red Time Between Blinks
B BR R
B R
General and Standby
HSP(Phone Calls)
Pairing
Low Battery
Standby (Bluetooth Connected)
Standby（Bluetooth Not Connected）
Outgoing call/Active Call
BR RB B R RB B R B R
B B B B B B
R R R
B B B B B B
B B B B B B
B B B
lncoming
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.