Hoover 48011868 01 Synua Plus _cover Instruction Manual SY71NM

User Manual: Hoover Instruction Manual A2 SY71NM02 - Vacuum Cleaner Help and Advice from Hoover

Open the PDF directly: View PDF .
Page Count: 6

I

J

L

M

N

G

®

1

H

J

K

L

R

T

U

B

D

A

E

F

O

S

P

Q

abc

A

C

E

F

B

D

B

D

®

W* X* Y* Za*

Zb*

V2**

a

V1**

b

* Certain models only ** Certain models only, nozzles may vary according to model

HF

V**

CA

HF

PRINTED IN P.R.C.

48011868/01

USER MANUAL

C

M

Y

CM

MY

CY

CMY

K

2

6*

8

12

6

45

a)

6 7 16

13

12

7

13

9

15

14

a) b) c)

b) c) d)

3*

a) b)

7

11

a) b) c)

a) b) c) d)

a) b)

“click”

10

1

2

* Certain models only ** Certain models only, nozzles may vary according to model

C

M

Y

CM

MY

CY

CMY

K

1

GB

INSTRUCTIONS FOR SAFE USE

This appliance should only be used for domestic cleaning, as

described in this user guide. Please ensure that this guide is

fully understood before operating the appliance.

Do not leave the appliance plugged in. Always switch o and

remove the plug from the socket after use, or before cleaning

the appliance or any maintenance task.

This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance. Cleaning and user

maintenance shall not be made by children without supervision.

If the power cord is damaged stop using the appliance

immediately. To avoid a safety hazard, an authorised HOOVER

service engineer must replace the power cord.

Keep hands, feet, loose clothing and hair away from rotating

brushes.

Use only attachments, consumables or spares recommended or

supplied by HOOVER.

Static electricity: Some carpets can cause a small build up of static

electricity. Any static discharge is not hazardous to health.

Do not use your appliance out of doors or on any wet surface or

for wet pick up.

Do not pick up hard or sharp objects, matches, hot ashes,

cigarette ends or other similar items.

Do not spray with or pick up ammable liquids, cleaning uids,

aerosols or their vapours.

Do not run over the power cord when using your appliance or

remove the plug by pulling on the power cord.

Do not continue to use your appliance if it appears faulty.

HOOVER service: To ensure the continued safe and ecient

operation of this appliance we recommend that any servicing

or repairs are only carried out by an authorised HOOVER service

engineer.

Do not stand on or wrap the cord around arms or legs when

using your appliance.

Do not use the appliance to clean animals or people.

Do not position the appliance above you when cleaning the

stairs.

The Environment

The symbol on this appliance indicates that this appliance may not be treated as

household waste. Instead it must be handed over to the applicable collection point

for the recycling of electrical and electronic equipment. Disposal must be carried

out in accordance with local environmental regulations for waste disposal. For more

detailed information about treatment, recovery and recycling of this appliance, please

contact your local city oce, your household and waste disposal service or the shop where you

purchased the appliance.

This appliance complies with the European Directives 2006/95/EC, 2004/108/EC and

2011/65/EU.

HOOVER Limited, Pentrebach, Merthyr Tydl, Mid Glamorgan, CF48 4TU, UK

2

A. On / O Button

B. Stretch flexi tube

C. Bin release button

D. Bin inlet

E. Bin handle

F. Product neck

G. Cord grip

H. 3in1 tool:

Ha. Crevice Tool

Hb. Furniture Nozzle

Hc. Dusting Brush

I. Carry handle

J. Upper cord hook

K. Flexi tube handle

L. Lower cord hook

M. Flexi tube handle location

N. Blockage inspection hose

O. Dust bin

P. Airvolution unit handle

Q. Filter pack

R. Filter release latch

S. Airvolution system

T. Bin empting latch

U. Dust container door

V. Hard Floor Nozzle (HF)**

V1. Hard Floor Nozzle (HF)**

V1a. Furniture protector

V2b. Locking pedal

V2. Carpet Nozzle (CA)**

W. Parquet nozzle*

X. Mini-turbo nozzle*

Y. Multi-function tool*

Za. Rigid extension tube

Zb. Long crevice tool

GB

GETTING TO KNOW YOUR CLEANER

*Certain Models Only ** Certain models only, nozzles may vary according to model

PREPARING YOUR CLEANER

1. Remove the accessories from the main packaging. You should find the following:

 •Cleanerbody

 •Cleanerhandle

 •3in1tool

 •Extensiontube

•Long crevice tool

 •HardFloorNozzle**

 •Parquetnozzle*

 •Carpet Nozzle**

 •Mini-turbonozzle*

 •Multi-functiontool*

2. Assemble the cleaner handle (Fig. 2a) and fix in position with the supplied screw. (Fig. 2b)

3. Secure the 3 in 1 tool to the rear of the cleaner handle. (Fig. 2c)

4. Secure the nozzle to the product. (Fig. 2d)

For models equipped with mini-turbo nozzle:*

1. The mini-turbo nozzle can be connected directly to the exi tube handle. (Fig. 3a)

2. If any blockages are encountered, please open the inspection cover. (Fig. 3b)

3. Ideal to clean soft furnishings and for the pet hairs removal.

For models equipped with Multi- function tool*:

 •TheMulti-functiontoolcanbeinserteddirectlyontotheexible hose.

Cord storage:

To store the cord after cleaning:

Wrap the cord around the two cord hooks. (Fig. 4)

NOTE: During cleaning, the cord can be clipped in the cord grip on the rear of the handle to

avoid any interference while cleaning.

USING YOUR CLEANER

Power switch:

To switch the cleaner on, and o press the power button in the centre of the cleaner.

(Fig. 5)

Cleaner lock release*:

To start cleaning, unlock the cleaner by pressing with your foot the locking pedal on the nozzle.

(Fig. 6)

Using the flexi tube:

Remove the flexi tube from the handle location in the cleaner. (Fig. 7)

You are immediately ready to use it alone or combined with the accessories, as desired:

3

*Certain Models Only ** Certain models only, nozzles may vary according to model

Emptying the Dust Container (Fig. 11)

1. Slide the bin release button downward and remove the dust bin from the cleaner.

2. Hold the container using the bin handle and pull the bin emptying latch. The dust

container door will automatically open.

3. Once empty, gently tap or shake the container to release any excess dust.

IMPORTANT -

Do not fill above the max level mark shown on the bin.

Allergy and asthma suerers:

When emptying any vacuum cleaner it is dicult to avoid exposure to dust. To minimize this

risk, please follow these instructions:

1. wrap the lower bin in a plastic bag and close the bag tightly around the dust container

before emptying.

2. Pull the bin emptying latch to empty the dust into the plastic bag. Close the bag quickly

and dispose of it immediately. (Fig. 12)

Cleaning the washable lters Fig. 13

1. Slide the bin release button downward and remove the dust bin from the cleaner.

2. Remove the lter pack by releasing the tab at the rear.

3. Separate the GREY foam lter from the DARK GREY HEPA lter pack using the tab provided.

Gently tap both lters against the side of a bin to release excess dust.

4. Wash the GREY foam lter thoroughly under hand warm water until the water runs clean.

Remove excess water by shaking and leave to dry for 24 hours. DO NOT USE HOT WATER

CLEANER MAINTENANCE

GB

 •3in1tool(storedonboard)

 •Extensiontube*

 •Mini-turbonozzle*

 •Longcrevicetool

 •Multi-functiontool*

The exi tube gives you the maximum exibility of usage. (Fig. 8

)

IMPORTANT

- When using cleaning tools, the cleaner must be kept in the upright position, and

held.

Using your 3 in1 tool:

The 3 in1 tool

(Fig.9)

is composed of:

•Crevice tool to clean corners and hard to reach areas

 •Furniture nozzle to clean curtains and soft furnishings

 •Dustingbrushattachment(withbristles)tocleandelicatesurfaces

The 3 in1 tool can be used directly on the flexi tube or combined with the additional exten

sion tube.

Assembly the dust bin

(Fig. 10

):

• Dust bin to be put in the location

• To rotate the dust bin and lock into main body

OR DETERGENTS.

5. Wash the DARK GREY HEPA lter thoroughly from the inside under hand warm water

until the water runs clean. Remove excess water by shaking and leave to dry for 24 hours.

When completely dry reassemble and ret lters to cleaner. DO NOT USE HOT WATER OR

DETERGENTS.

IMPORTANT - For optimum performance, shake o excess dust from the lters regularly.

We recommend that the GREY foam lter and the DARK GREY HEPA lter are washed every 3

MONTHS.

NOTE: Do not use the cleaner without lters assembled.

Cleaning the dust bin / separation unit

1. Place the bin on a at surface and remove the lters.

2. Remove the Airvolution system by lifting the Airvolution unit handle. (Fig. 14)

3. Use a cloth or the dusting brush to remove excessive dust from the Airvolution unit

surface.

4. Ret the Airvolution unit into the dust bin and ret the lters.

5. Ret the dust bin to the cleaner.

NOTE: For stubborn dirt the Airvolution system can be washed, but care must be taken that it

is completely dry before retting to the cleaner.

IMPORTANT -

For optimum performance, we recommend that Airvolution system is inspected

after each empty.

Removing a blockage

1. check if the dust container is full. If so refer to “emptying the dust container’’.

2. If the dust container is empty but suction is still low:

A.Ifcleaningtoolswereinusecheckthecleaning tool.(Themini-turbo*nozzlecanbe

checkedbyunlockingtheclipandliftingthecovertoremoveanyblockage) (Fig. 3b)

B. check the exi tube by removing it from the hose handle location, stretching it to full

length.

C. Check the bin inlet by removing the bin and checking inside the bin inlet.

D. Remove the nozzle and check the nozzle connection.

E. Remove the blockage inspection hose and check from both sides. (Fig. 15)

IMPORTANT  Switch the cleaner o and remove the plug from the electricity supply before

checking cleaner.

4

GB

ACCESSORIES AND NOZZLES

To obtain the best performance and energy eciency#1 it is recommended that the correct

nozzles are used for the main cleaning operations. These nozzles are indicated in the diagrams

by the letters GP, HF or CA.

A nozzle type GP can be used to clean both carpet and hard oor.

A nozzle type HF is suitable for use only on hard oor.

A nozzle of type CA is suitable for use only on carpet.

The other nozzles are accessories for specialist cleaning tasks and are recommended for oc-

casional use only.

It is important to note that this vacuum cleaner is supplied with an Energy Label as required by

EuropeanRegulation(EU)665/2013.

If the label shows a red prohibition circle on the left covering the carpet symbol, then this indi-

cates that the vacuum cleaner is not suitable use on carpets.

If the label shows a red prohibition circle on the right covering the hard oor symbol, then this

indicates that the vacuum cleaneris not suitable for use on hard oors.

#1 NOTE: Dust pick up ability carpet, dust pick up ability hard oor, and energy eciency in

accordwithCommissionRegulations(EU)665/2013and(EU)666/2013.

HOOVER spares and Consumables

Always replace parts with genuine HOOVER spares. These are available from your local HOOVER

dealer or direct from HOOVER. When ordering parts always quote your model number.

•HEPA / Foam lter pack: S100(35601367)

•Hard Floor Nozzle  G216EE(35601609)

• Carpet Nozzle: G215EE(35601608)

Should you have a problem with the product, complete this simple user checklist before calling

your local HOOVER service.

• Isthereaworkingelectricitysupplytothecleaner?Checkwithanotherelectricalproduct.

•

Isthedustbinfullorchokedwithnedust?

To empty the dustbin see ‘Emptying the dust

container’.

• Isthehoseblocked?Toclearablockagesee‘Removingablockage’.

• Isthereablockageinthecleaner?Toclearablockagesee‘Removingablockage’.

• Aretheltersblocked?Tocleanlters,see‘cleaningthewasablelters’.

USER CHECKLIST

IMPORTANT INFORMATION

•MiniTurboNozzle: J45(35601003)

•ParquetNozzle: G87PC(35600655)

•Multi-functiontool: MFT2(35601366)

HOOVER Service

Should you require service at any time, please contact your local HOOVER Service Oce.

Tel: 08444 995 599

Email: customer.services@hoovercandy.com

Quality

HOOVER’s factories have been independently assessed for quality. Our products are made using

a quality system which meets the requirements of ISO 9001.

Your Guarantee

The guarantee conditions for this appliance are as dened by our representative in the country

in which it is sold. Details regarding these conditions can be obtained from the

dealer from

whom the appliance was purchased.

The bill of sale or receipt must be produced when making

any claim under the terms of this guarantee.

Subject to change without notice.