Hopkins IL001 LED REMOTE User Manual Rev1

Hopkins Manufacturing Corporation LED REMOTE Rev1

User Manual_Rev1

Thank you for purchasing the Remote GoLite™. For added security, use GoLite™ to light the interior of your vehicle while approaching at night. GoLite is also great for illuminating the inside of your vehicle for any purpose, roadside repair or anywhere light is needed. If you have questions, comments or need assistance, call our technical support team at 800-835-0129. CONTENTS: 1 – GoLite (batteries not included), 1 – Remote (includes battery), 1 – Suction Cup, 1 – Visor Clip, 1 – Vibration Pad OPERATION: 1. Slide GoLite battery cover open and insert 4 AA batteries (not included). Replace battery cover. 2. Remote control includes a 12V 23A battery. For future replacement of battery, remove four screws on back of devise. 3. Slide on/off/remote switch located on light to the preferred position.  “ ○ ” symbol = Light is always off.  “ ─ “ symbol = Light is always on.  “ “ symbol = Light is activated on and off by remote control. 4. Place GoLite in the desired location. CAUTION: Do not place GoLite in any location that would impair visibility while driving or come in contact with airbags should they be deployed. Check state and local laws for regulations that may apply.  Built in hook allows for hanging from rear view mirror. Note: When hanging GoLite from the mirror, the front of the GoLite may come in contact with the rear of the mirror, causing a rattling noise. Use the included Vibration Pad and adhere to the GoLite or back of the mirror at the location where the GoLite contacts the mirror.  Suction cup allows for placement on any flat window surface. Clean window prior to attachment.  Visor clip allows for placement on passenger side sunvisor. CAUTION: To prevent damage to the light and personal injury, remove light prior to flipping sunvisor to the “down” position. 5. Remote Operation  Slide GoLite on/off/remote switch to the “ “ position. The red LED light on the end of GoLite will illuminate. For continuous remote operation, leave switch in this position at all times.  Push the on/off button located on the remote control to activate the light. Activation can be achieved from up to 100 ft. (in some instances, weather and other obstacles may interfere with the transmission, causing the activation distance to be less than 100 ft.)  Push remote button a second time to turn light off (GoLite will continue to be in the “remote” status and can be activated by the remote control devise at any time). GoLight will automatically turn off in 60 seconds if the light is not manually turned off. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help. HOPKINS MANUFACTURING CORPORATION 428 PEYTON STREET ● P.O. BOX 1157 ● EMPORIA, KS 66801-1157 Phone: (620) 342-7320 ● www.HopkinsMfg.com ● www.GoGearMobile.com

Navigation menu