Horizon Hobby DAMTX10 2.4 GHz Transceiver User Manual X1TXN User Guide updated

Horizon Hobby, LLC 2.4 GHz Transceiver X1TXN User Guide updated

Contents

Module users guide

Download: Horizon Hobby DAMTX10 2.4 GHz Transceiver User Manual X1TXN User Guide updated
Mirror Download [FCC.gov]Horizon Hobby DAMTX10 2.4 GHz Transceiver User Manual X1TXN User Guide updated
Document ID1121273
Application IDP6JLymZNKaK5NxOTrqGfLA==
Document DescriptionModule users guide
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize11.25kB (140630 bits)
Date Submitted2009-06-08 00:00:00
Date Available2009-06-08 00:00:00
Creation Date2009-06-08 08:21:13
Producing SoftwareGPL Ghostscript 8.15
Document Lastmod2009-06-08 08:21:13
Document TitleMicrosoft Word - X1TXN User Guide updated.doc
Document CreatorPScript5.dll Version 5.2
Document Author: mbriggs

X1TXN 2.4GHz DSSS Module User Manual.
Horizon Hobby Inc.,
1657 Country Club Dr.,
Milpitas CA 95035 USA
408 945 9800
1. Features
•
•
•
•
•
•
•
•
•
•
•
•
2.4GHz Direct Sequence Spread Spectrum (DSSS) radio transceiver module.
Operates in the unlicensed worldwide ISM band (2.4 GHz to 2.483.5GHz) band
Fully integrated power regulation with a wide input unregulated operating range
2.4 to 3.6V.
Fully integrated local oscillator and 12MHz 20ppm reference crystal
200mA operating current
Transmit power - 200mW EIRP
Receive sensitivity up to -95dBm
DSSS data rates up to 250kbps
1 mile operating range
Full packet assembling and disassembling
Auto transaction sequencer
Fully buffered digital interface with high voltage tolerant inputs
2. Pin description
Pin Number
10
11
12
Name
GND
VDD
IRQ
RST
MOSI
nSS
SCLK
MISO
GND
XOUT
TXRX
RXTX
Description
Module Ground
Module power input
Interrupt Request
Reset, active High
Master out, slave In data
Slave Select, Active Low
SPI data clock
Master in, slave out data
Module Ground
Clock output from module
Switch antenna to transmit direction
Switch antenna to receive direction
3. Specifications
Parameter
Storage Temp
VDD
Receive Sensitivity
Transmit power (conducted)
Transmit power (radiated)
Idle current
Receive current
Transmit current
Value
-65 to 105
2.4 to 3.6
-95
21
23
22
200
Units
Degrees Celsius
Volts
dBm
dBm MAX
dBm MAX
mA
mA
mA
4. Module User Requirements
4.1 This module must be integrated into a device where the user cannot access the
antenna connector and should not be able to remove/install the module.
4.2 Only a 2dBi antenna can be used with this module. The antenna must meet and not
exceed the gain and pattern of the supplied Inpaq DAM00BM11500209 folded dipole
antenna.
4.3 This module must not be co-located or operated in conjunction with any other
antenna or transmitter.
45.4 The device must contain the following permanent labeling on the exterior of the
device as follows:
Contains FCC ID: BRWDAMTX10
4.5 The user manual of the device must contain the following paragraph:
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This product contains a radio transmitter with wireless technology
which has been tested and found to be compliant with the applicable
regulations governing a radio transmitter in the 2.400 GHz to 2.4835 GHz
frequency range.
The following countries associated regulatory agencies recognizing the
noted certifications for this product as authorized for sale and use are:
USA
Denmark
Germany
Spain
Canada
France
Italy
Sweden
Belgium
Finland
Netherlands
UK
4.6 This module meets the requirements for a mobile device that may be used at
separation distances of more than 20cm from the human body. It may be used in handheld controllers that provide a separation distance of at least 5cm between the antenna
and the body (excluding hands/wrists). The instructions to the user for the host device
must include information requiring the product be used in a manner to ensure the
appropriate separation (20cm or 5cm) between antenna and body and requiring that the
transmitter not be collocated with another transmitting device.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Page Count                      : 3
Producer                        : GPL Ghostscript 8.15
Create Date                     : 2009:06:08 08:21:13
Modify Date                     : 2009:06:08 08:21:13
Title                           : Microsoft Word - X1TXN User Guide updated.doc
Creator                         : PScript5.dll Version 5.2
Author                          : mbriggs
EXIF Metadata provided by EXIF.tools
FCC ID Filing: BRWDAMTX10

Navigation menu