Horizon Hobby HBZ3751 Game Wireless Controller User Manual Manual

Download:
Mirror Download [FCC.gov]
Document ID	1928183
Application ID	s8XKekz56m2ATK+rGSSL7g==
Document Description	Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	21.82kB (272758 bits)
Date Submitted	2013-03-29 00:00:00
Date Available	2013-03-29 00:00:00
Creation Date	2013-01-21 13:22:25
Producing Software	Adobe PDF Library 9.0
Document Lastmod	2013-01-21 13:22:37
Document Title	Manual
Document Creator	Acrobat PDFMaker 9.1 Word 版
Document Author:	superyaomj

Transmitter
1.
Remove the transmitter bottom cover by pushing down with
thumbs, as indicated by the arrows
2.
Install batteries. Use fresh 1.5V “AA” batteries only.
3.
Watch polarity. Replace cover.
4.
To test, switch on transmitter—LED should glow brightly
5.
Replace batteries when you hear low-battery alarm(beeping
sound)
Motor Test and Battery Discharging
CAUTION:Keep everthing clear of the propller. A moving propller can cause injury
1.
The buttons below the power switch and labeled as
“TH. Trim” are the digital throttle trim buttons. With
your boat on the stand, turn on the transmitter and
install the battery.
2.
If motor is running, make sure the throttle trigger is
centered at neutral and press”-“ throttle trim button
until the motor stops
3.
Pull the throttle trigger back. Motor speed will increase
as the throttle trigger is pulled back.
4.
In order to fully discharge the battery , run the motor
at high speed until it shuts off. If there is not eough
charge in the battery to power the propeller, then
proceed to Step4.
5.
When finished with the motor test, be sure to
disconnect the battery first, then turn off the
transmitter.
Rudder Test
Move the steering wheel side to side. The rudder should
move as shown in the drawings
NOTE: The small buttons labeled as ”ST.Trim” under the
power switch are the digital steering buttons and are used
to adjust the “neutral” point of your steering wheel. To do
this, leave the steering wheel in the center position. If
rudder is not aligned straight ahead, use the digital rudder
trim buttons to center it
Choosing Your Location
1.
Choose a locatoin that is not being used by
2.
If you choose a lake, be sure there is no moss,
swimmers when you are running your boat
grass, weeds or debris present that could get
warpped around the propeller or trap your boat
offshore
3.
Make sure the shoreline is clear and relatively
flat so you can easily launch, operate and
retrieve your boat.
Do Not mix radio control boating and swimming.
Range test
You will need two people to do the range test: one to
hold the transmiiter and one to hold the zig zag Racer 3.
1.
One person holds the tranmitter; the other person
walks 100paces away with the boat
2.
Extend the transmitter antenna completely and turn
the transmitter on.
3.
Plug in the battery and close the hatch cover.
4.
As the first person moves both of the trasmitter
controls at the same time, the other person watches
to be sure the boat’s motor and rudder controls
operate smoothly
This equipment has been tested and found to comply
with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate this equipment.
This Category II radiocommunication device complies with Industry Canada Standard RSS-310.
Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 d’Industrie Canada.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : superyaomj
Create Date                     : 2013:01:21 13:22:25+08:00
Modify Date                     : 2013:01:21 13:22:37+08:00
Subject                         : 
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Metadata Date                   : 2013:01:21 13:22:37+08:00
Creator Tool                    : Acrobat PDFMaker 9.1 Word 版
Document ID                     : uuid:7ac11aff-2310-42db-9a80-8bf3d2e4eede
Instance ID                     : uuid:9d5986b0-60b5-49c6-bfae-be43284bc481
Format                          : application/pdf
Title                           : 
Description                     : 
Creator                         : superyaomj
Producer                        : Adobe PDF Library 9.0
Keywords                        : 
Source Modified                 : D:20130121052201
Company                         : 
Comments                        : 
Page Layout                     : OneColumn
Page Count                      : 3

EXIF Metadata provided by EXIF.tools