Huawei Technologies AF15 Tripod Selfie Stick User Manual
Huawei Technologies Co.,Ltd Tripod Selfie Stick
User Manual
Quick Start Guide
(Wireless Version)
Tripod Selfie Stick
If the selfie stick successfully pairs with your phone, the green indicator will be on for 3
Connecting to your phone
Camera button
1
2
1
Press and hold the camera button on the selfie stick for 2 seconds to enter Bluetooth
pairing mode.
Enable Bluetooth on your phone search for available devices. Select AF15.
seconds and off.
English
Using the selfie stick
Expand the selfie stick.
1
(Optional) Open the tripod at the bottom,
push the pole upwards, and place the
tripod on a horizontal level surface.
2
2
English
Attach your phone on the selfie stick.
3
Set the volume button on your phone
to act as the shutter button.
Use the remote control to take a photo.
4
3
English
Replacing the remote control battery
Remove the Bluetooth remote control from the tripod. Push against the battery cover in the
direction shown by the arrow and replace the battery.
21 3
4
English
Press and hold the camera button on the selfie stick for 3 seconds until the green indicator
light turns off.
Powering off the selfie stick
Note:
5
● If you do not use the remote control for 3 minutes, it will automatically enter sleep mode
and disconnect from your phone. The remote control will be powered off if you do not use
it for 6 hours.
● The Bluetooth range for the remote control is 10 meters.
● When your are using the selfie stick, the red indicator of the selfie stick will blink if the
battery level is lower than 20%. Please replace the battery in time.
English
6
The statements should be displayed in the user manual:
changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help
7
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.