Huawei Technologies E880 HSPA Express Data Card User Manual English

Huawei Technologies Co.,Ltd HSPA Express Data Card English

User manual rev2

Copyright © 2008 Huawei Technologies Co., Ltd. All Rights Reserved No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice. Every effort has been made in the preparation of this document to ensure accuracy of the contents, but all statements, information, and recommendations in this document do not constitute the warranty of any kind, express or implied.
i Table of Contents Getting to Know Your E880...................................................................... 1 Requirements for the Computer ............................................................... 4 Preparation........................................................................................... 4 Safety Information................................................................................. 8
Thank you for choosing Huawei E880 data card (hereinafter referred to as the E880). With the E880 data card, you can access the Internet through wireless network at a high speed. Note: This manual describes the appearance, installation and removal of the E880. For the operation of the management program, refer to the User Manual. Getting to Know Your E880 The following figure shows the appearance of the E880. It is only for your reference. The actual product may differ. 1234 1 ExpressCard Interface It connects the E880 to a computer. 1
2 USIM/SIM Card Slot It is where you insert the user identity module (USIM/SIM) card. 3 Built-in Aerial Simply press the end and it will extend. We recommend you always have the aerial extended when connected to get optimum performance. When you have finished, push it back into the ExpressCard until it clicks. 4 Indicator It indicates the status of the E880. Colour Status Meaning Green Blinking (on for 100ms and off for 100ms; then on for 100ms and off for 2700ms) The E880 is powered on. Green Blinking (on for 100ms and off for 2900ms) The E880 is registered to a GSM/GPRS/EDGE network. Blue Blinking (on for 100ms and off for 2900ms) The E880 is registered to a UMTS network. 2
3 Green On The E880 is connected to a GPRS/EDGE network. Blue On The E880 is connected to a WCDMA network. Cyan On The E880 is connected to a HSPA network. - Off The E880 is removed.
Requirements for the Computer To use the E880, the computer must meet the following requirements:  Equipped with ExpressCard slot.  Windows 2000 SP4, Windows XP SP2, Windows Vista.  Mac OS X 10.4 and 10.5 with latest upgrades  Your computer’s hardware system should meet or exceed the recommended system requirements for the installed version of OS.  Resolution for the display: 800 × 600 or above. Preparation Getting Your E880 Ready Insert the User Identity Module (UIM) card into the slot of the data card with the golden contacts side facing downwards and the cut corner directing inwards. Follow the direction on the back of the data card. 4
Installation/Removal Guide On different operating systems (OSs), the installation and removal procedures may differ. Follow the system prompts during operation. Connecting the E880 with a Computer 1. Pop up the Built-in Aerial. Simply press the end and it will extend. 2. Plug the E880 into the ExpressCard slot of a laptop. 3. Insert the supplied CD of the data card into the CD-ROM drive of the laptop. 4. The OS automatically detects and recognises new hardware and starts the installation wizard. 5
6 5. Follow the prompts of the installation wizard. 6. After the program is installed, a shortcut icon for the E880 management program is displayed on the desktop. Note: If the program does not respond, run the Setup.exe file in the CD drive path of the laptop. Starting the Management Program 1. Double-click the shortcut icon on the desktop to start the management program of the E880. 2. Enter the personal identity number (PIN) code if you have enabled the PIN lock. Removing the E880 1. Exit the management program. 2. Remove the E880. Removing the Management Program 1. Click Start Menu. 2. Click Control Panel. 3. Click Add/Remove Program to remove the management program of the E880.
7 Note: Before removing the management program, exit the management program.
8 Safety Information Read the safety information carefully to ensure the correct and safe use of your wireless device. Interference Do not use your wireless device if using the device is prohibited or when it cause danger or interference with electric devices. Medical Device  Do not use your wireless device and follow the rules and regulations set forth by the hospitals and health care facilities.  Some wireless devices may affect the performance of the hearing aids. For any such problems, consult your service provider.  If you are using an electronic medical device, consult the doctor or device manufacturer to confirm whether the radio wave affects the operation of this device. Area with Inflammables and Explosives To prevent explosions and fires in areas that are stored with inflammable and explosive devices, do not use your wireless device and observe the rules. Areas stored with inflammables and explosives include but are not limited to the following:  Gas station  Fuel depot (such as the bunk below the deck of a ship)  Container/Vehicle for storing or transporting fuels or chemical products
9  Area where the air contains chemical substances and particles (such as granule, dust, or metal powder)  Area indicated with the "Explosives" sign  Area indicated with the "Power off bi-direction wireless equipment" sign  Area where you are generally suggested to stop the engine of a vehicle Traffic Security  Observe local laws and regulations while using the wireless device. To prevent accidents, do not use your wireless device while driving.  RF signals may affect electronic systems of motor vehicles. For more information, consult the vehicle manufacturer.  In a motor vehicle, do not place the wireless device over the air bag or in the air bag deployment area. Otherwise, the wireless device may hurt you owing to the strong force when the air bag inflates.  Observe the rules and regulations of airline companies. When boarding, switch off your wireless device. Otherwise, the radio signal of the wireless device may interfere with the plane control signals. Safety of Children Do not allow children to use the wireless device without guidance. Small and sharp components of the wireless device may cause danger to children or cause suffocation if children swallow the components. Environment Protection Observe the local regulations regarding the disposal of your packaging materials, used wireless device and accessories, and promote their recycling.
10 WEEE Approval The wireless device is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive). RoHS Approval The wireless device is in compliance with the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2002/95/EC (RoHS Directive). Laws and Regulations Observance Observe laws and regulations when using your wireless device. Respect the privacy and legal rights of the others. Care and Maintenance It is normal that your wireless device gets hot when you use or charge it. Before you clean or maintain the wireless device, stop all applications and disconnect the wireless device from your PC.  Use your wireless device and accessories with care and in clean environment. Keep the wireless device from a fire or a lit cigarette.  Protect your wireless device and accessories from water and vapor and keep them dry.  Do not drop, throw or bend your wireless device.  Clean your wireless device with a piece of damp and soft antistatic cloth. Do not use any chemical agents (such as alcohol and benzene), chemical detergent, or powder to clean it.  Do not leave your wireless device and accessories in a place with a
11 with any other antenna or transmitter to avoid exceeding the RF exposure limit. considerably low or high temperature.  Use only accessories of the wireless device approved by the manufacture. Contact the authorized service center for any abnormity of the wireless device or accessories.  Do not dismantle the wireless device or accessories. Otherwise, the wireless device and accessories are not covered by the warranty. Emergency Call This wireless device functions through receiving and transmitting radio signals. Therefore, the connection cannot be guaranteed in all conditions. In an emergency, you should not rely solely on the wireless device for essential communications. Specific Absorption Rate (SAR) Your wireless device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. These guidelines were developed by the independent scientific organization ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health. The guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit for wireless devices is 2.0 W/kg and the highest SAR value for this device when tested properly worn on the body is 0.547W/kg. SAR compliance has been established in typical laptop computer(s) with Express card slot, and product may be used in a typical laptop computer. Other applications like handheld PCs or smaller host devices have not been verified and may not comply with relevant RF exposure rule and such use shall be prohibited. Unless special co-transmission configuration(s) which has (have) approved by the authority, this transmitter must not be co-transmitting or operating in conjunction
12 arding radiofrequency radiation (RF) exposure lt in your RF exposure exceeding on apply in specific regions as noted. ed in the member states of the EU. The ice (United States): Before a wireless pted by the USA and Canada is 1.6 watts/kilogram (W/kg) r to the Body Worn Operation Important safety information regTo ensure compliance with RF exposure guidelines the device must be used with a minimum of 1.0 cm separation from the body. Failure to observe these instructions could resuthe relevant guideline limits. Regulatory InformatiThe following approvals and noticesCE Approval (European Union) The wireless device is approved to be uswireless device is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EC (R&TTE Directive). Federal Communications Commission Notdevice model is available for sale to the public, it must be tested and certified tothe FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. FCC Statement The SAR limit adoaveraged over one gram of tissue. The highest SAR value reported to the FCC fothis device type when tested properly worn on the body is 1.130W/kg. This device complies with Part 15 of the FCC Rules. Operation is subjectfollowing two conditions: (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.
13 : e complies with Part 15 of the FCC Rules [and with RSS-210 of Industry is subject to the following two conditions: nd ding interference that : or modifications not expressly approved by the party responsible for his equipment has been tested and found to comply with the limits for a s, ent and receiver. hat to which the 15.19 NOTICEThis devicCanada]. Operation (1) this device may not cause harmful interference, a(2) this device must accept any interference received, inclumay cause undesired operation. 15.21 NOTICEAny changes compliance could void the user's authority to operate this equipment. 15.105 NOTE: TClass B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructionmay cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipm• Connect the equipment into an outlet on a circuit different from t
14 • Consu rienced radio/TV technician for help. Version: V100R001_01 Part Number: 3101****receiver is connected. lt the dealer or an expe

Navigation menu