Huawei Technologies MU203B Wireless Module User Manual MU203 QSG

Download:
Mirror Download [FCC.gov]
Document ID	1236992
Application ID	PjAvCzTbnpPRSZ++mCU93Q==
Document Description	Installation Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.57kB (119684 bits)
Date Submitted	2010-02-04 00:00:00
Date Available	2010-05-04 00:00:00
Creation Date	2010-02-04 18:05:54
Producing Software	Acrobat Distiller 7.0 (Windows)
Document Lastmod	2010-02-04 18:06:18
Document Title	Microsoft Word - MU203 QSG.doc
Document Creator	PScript5.dll Version 5.2.2
Document Author:	z00122000

Copyright © 2009 Huawei Technologies Co., Ltd.
All Rights Reserved
No part of this document may be reproduced or transmitted in any form or by any
means without prior written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
Ltd.
and other Huawei trademarks are trademarks of Huawei Technologies Co.,
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
Notice
The information in this document is subject to change without notice. Every effort
has been made in the preparation of this document to ensure accuracy of the
contents, but all statements, information, and recommendations in this document
do not constitute the warranty of any kind, express or implied.
Table of Contents
Getting to Know the MU203..................................................................... 1
Preparing the MU203.............................................................................. 4
Installation Guide .................................................................................. 5
Safety Information................................................................................. 9
Thank you for purchasing Huawei MU203 Wireless
Module.
Note:
„
This manual briefly describes the preparation, the process for
installing/uninstalling, and safety precautions for using Huawei MU203
Wireless Module (hereinafter referred to as the MU203).
„
You are recommended to read the manual before using the MU203.
„
The signal strength and the transmission rate are affected by the actual
environment.
Getting to Know the MU203
The following figure shows the appearance of the MU203. The actual product may
differ.
2
BTB Connector
It is used to connect to the interface of the PC.
o Screw holes
They are used to fix the MU203 on the main board of the PC with screws.
Antenna interfaces
It is used to connect an antenna.
Requirements for the User Side
To use the MU203, the user must meet the following requirements:
„
60-pin Board to Board Connector interface.
„
Windows CE/Windows XP/Linux 2.6.18 or later versions
„
Display resolution: 800 × 600 or above.
„
The antenna gain：850M<4.28dBi，1900M<2.1dBi
Preparing the MU203
Locate the MU203 on the main board of the PC. Find the antenna.
If a USIM/SIM card is provided by your service provider, insert the USIM/SIM card
into the USIM/SIM card slot on the main board of the PC.
Note:
„
In certain cases, your PC may be disassembled only by the professionals.
„
Before you install the MU203 onto the main board of the PC, consult the PC
manufacturer or read the user manual of the PC.
Installation Guide
Installing the MU203 onto the Main Board of the PC
1. Locate the MU203 on the main board of the PC.
2. Insert the antenna into the antenna interface of the MU203.
3. Press downwards to fix the MU203 in the module slot.
Note:
„
Insert the antenna connectors vertically into the antenna interfaces of the
MU203.
„
Do not pinch the antenna cable or damage the connectors. Otherwise, the
wireless performance of the MU203 may be reduced or the MU203 cannot
work normally.
„
Ensure that the antenna cables are routed through the channel in the frame of
the PC and do not lay across the raised edges of the frame.
Removing the MU203 from the Main Board of the PC
1. Disconnect the antenna cables from the MU203. You can lift the connectors
with a small screwdriver.
2. Release the MU203 from the module slot. Then, lift up the MU203.
Installing the MU203 Software
A disk is provided in the MU203 packing box. The disk contains the management
program and the driver of the MU203.
1. Insert the disk into the disk drive of the PC.
2. Find the AutoRun.exe file under the disk path. Then double-click
AutoRun.exe to run the program.
3. Follow the prompts of the installation wizard.
4. After the program is installed, the shortcut icon of the management program
is displayed on the desktop.
Uninstalling the Management Program
1. Choose Start > Control Panel.
2. Find the management program, and click Add/Remove Program to
uninstall the management program.
Note:
It is recommended to restart the PC after the uninstallation to ensure that the
management program is completely uninstalled.
Safety Information
Read the safety information carefully to ensure the correct and safe use of your
wireless device.
Interference
Do not use your wireless device if using the device is prohibited or when it causes
danger or interference with electric devices.
Medical Device
„
Do not use your wireless device and follow the rules and regulations set forth
by the hospitals and health care facilities.
„
Some wireless devices may affect the performance of the hearing aids. For
any such problems, consult your service provider.
„
If you are using an electronic medical device, consult the doctor or device
manufacturer to confirm whether the radio wave affects the operation of this
device.
Area with Inflammables and Explosives
To prevent explosions and fires in areas that are stored with inflammable and
explosive devices, do not use your wireless device and observe the rules. Areas
stored with inflammables and explosives include but are not limited to the
following:
„
Gas station
„
Fuel depot (such as the bunk below the deck of a ship)
„
Container/Vehicle for storing or transporting fuels or chemical products
„
Area where the air contains chemical substances and particles (such as
granule, dust, or metal powder)
„
Area indicated with the "Explosives" sign
„
Area indicated with the "Power off bi-direction wireless equipment" sign
„
Area where you are generally suggested to stop the engine of a vehicle
Traffic Security
„
Observe local laws and regulations while using the wireless device. To prevent
accidents, do not use your wireless device while driving.
„
RF signals may affect electronic systems of motor vehicles. For more
information, consult the vehicle manufacturer.
„
In a motor vehicle, do not place the wireless device over the air bag or in the
air bag deployment area. Otherwise, the wireless device may hurt you owing
to the strong force when the air bag inflates.
„
Observe the rules and regulations of airline companies. When boarding,
switch off your wireless device. Otherwise, the radio signal of the wireless
device may interfere with the plane control signals.
Safety of Children
Do not allow children to use the wireless device without guidance. Small and
sharp components of the wireless device may cause danger to children or cause
suffocation if children swallow the components.
Environment Protection
Observe the local regulations regarding the disposal of your packaging materials,
used wireless device and accessories, and promote their recycling.
10
WEEE Approval
The wireless device is in compliance with the essential requirements and other
relevant provisions of the Waste Electrical and Electronic Equipment Directive
2002/96/EC (WEEE Directive).
RoHS Approval
The wireless device is in compliance with the restriction of the use of certain
hazardous substances in electrical and electronic equipment Directive
2002/95/EC (RoHS Directive).
Laws and Regulations Observance
Observe laws and regulations when using your wireless device. Respect the
privacy and legal rights of the others.
Care and Maintenance
It is normal that your wireless device gets hot when you use or charge it. Before
you clean or maintain the wireless device, stop all applications and power off the
wireless device.
„
Use your wireless device and accessories with care and in clean environment.
Keep the wireless device from a fire or a lit cigarette.
„
Protect your wireless device and accessories from water and vapor and keep
them dry.
„
Do not drop, throw or bend your wireless device.
„
Clean your wireless device with a piece of damp and soft antistatic cloth. Do
not use any chemical agents (such as alcohol and benzene), chemical
detergent, or powder to clean it.
„
Do not leave your wireless device and accessories in a place with a
11
considerably low or high temperature.
„
Use only accessories of the wireless device approved by the manufacture.
Contact the authorized service center for any abnormity of the wireless device
or accessories.
„
Do not dismantle the wireless device or accessories. Otherwise, the wireless
device and accessories are not covered by the warranty.
Emergency Call
This wireless device functions through receiving and transmitting radio signals.
Therefore, the connection cannot be guaranteed in all conditions. In an
emergency, you should not rely solely on the wireless device for essential
communications.
Regulatory Information
The following approvals and notices apply in specific regions as noted.
CE Approval (European Union)
The wireless device is approved to be used in the member states of the EU. The
wireless device is in compliance with the essential requirements and other
relevant provisions of the Radio and Telecommunications Terminal Equipment
Directive 1999/5/EC (R&TTE Directive).
Federal Communications Commission Notice (United States): Before a wireless
device model is available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure.
FCC Statement
* This device should be installed and operated with a minimum distance of 20 cm
12
between the radiator and your body when you use the device via a USB cable.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications made to this equipment not expressly
approved by HUAWEI may void the FCC authorization to operate this equipment.
13

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2010:02:04 18:06:18+08:00
Create Date                     : 2010:02:04 18:05:54+08:00
Metadata Date                   : 2010:02:04 18:06:18+08:00
Format                          : application/pdf
Title                           : Microsoft Word - MU203 QSG.doc
Creator                         : z00122000
Document ID                     : uuid:37faa0ec-fbe0-472d-9145-31aa1b2b31cc
Instance ID                     : uuid:4062fd6c-b468-4b92-a04a-7d7dbc9ee813
Page Count                      : 15
Author                          : z00122000

EXIF Metadata provided by EXIF.tools